Problem 2: Given this network of capacitors: c2 4 uF 1 uF C3 3 uF C4 2 uf C5 2 uF Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, calculate the following: a. The equivalent capacitance between a and b. b. The charge on each capacitor. C. The potential difference on each capacitor d. Energy stored on each capacitor

Problem 2: Given this network of capacitors: c2 4 uF 1 uF C3 3 uF C4 2 uf C5 2 uF Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, calculate the following: a. The equivalent capacitance between a and b. b. The charge on each capacitor. C. The potential difference on each capacitor d. Energy stored on each capacitor

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A paper dielectric plate capacitor is to be experimentally tested. The metal plates and the paper material between said plates are all 20 cm in radius and subjected to 10V dc in the test. How much is the capacitance does this capacitor have in picofarads (pF), if the paper material between plates used is 2 cm thick? Input answer in 4 decimal places and in pF. Note: Relative permittivity of the paper ( εr ) : 0.4225
Given the capacitance of four capacitors Ca= 30 µF, Cb = 20 µF, Cc = 40 µF and Cd = 10 µF. If Cb and Cc are connected in parallel and the parallel combination is connected in series with Ca and the combination is further connected in parallel with Cd, calculate (a) the equivalent capacitance (b) the voltage across each capacitor if the circuit is supplied by 240 volts DC source (c) the charge on each capacitor.
Referring to the figure shown, if E=240V, Rs=30k-ohms, Rp=50k-ohms and C=40 micro-farad:(a) To what voltage will the capacitor be charge if the switch is closed for a comparatively long time?(b) Assuming an initial capacitor voltage as in (a) what will be the instantaneous potential ec 1 second after the switch is opened?(c) Assuming the switch to be opened at the instant the capacitor potential reaches the voltage determined in (b), what will be the value of ec 0.5 second after the switch is closed
The following data was collected in a lab where a 1000 uF capacitor was discharged using a 3 volt power supply. The capacitor was in series with a resistor of unknown value. a. Draw an RC circuit diagram where a capacitor can be charged and discharged in the same circuit using asingle pole double throw switch.b. Construct a graph of showing the discharge curve of the capacitor’s voltage with time using the databelow.c. Linearize the data below to construct a straight line with a constant slope.d. The graphs should be labeled and titled. The axes should be labeled with appropriate units.e. Using the the linearized data calculate the time constant for the RC circuit.f. Calculate the value of the unknown resistor.g. Show that the capacitor is nearly discharged after 5 time constants.
A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from a 10-V DC source, determine which among the following is a differential equation describing the circuit? Let q be the amount of charge in the circuit at any time t.
A capacitor is made from two flat parallel plates placed 2 mm apart, .and its capacitance at vacuum is 10-12- F , if 200 volt applied in between then a Dielectric material was entered and its Dielectric constant Is 49 , Calculate : a) the new value of capacitance after the entrance of the Dielectric b) what is the value of charge on Dielectric material surface c) the polarization p of the Dielectric material d) calculate the displacement and the field inside the Dielectric
Two concentric cylindrical plates have an outer radius of 4 cm, an inner radius of 3.8 cm, and a cylinder length of 10 cm. The gap of both plates contains air. Specify: a. Capacitance of capacitors (in pF, pico-farad). b. Capacitor charge (in nC, nano-coulomb) if the capacitor is connected to a 12 volt power source. c. Capacitance and charge captor if the gap of both plates is filled by the material with a dielectric constant of 2.3.
A ceramic capacitor has an effective plate area of 4 cm2 separated by 0.1 mm of ceramic of relative permittivity 100. Calculate the capacitance of the capacitor in picofarads. If the capacitor in part is given a charge of 1.2 µC what will be the p.d. between the plates?
Q1 (True/False): A) The current through the capacitor is inversely proportional to the derivative of the voltage across it: Is it true or false? B) In a typical electronic circuit the capacitor blocks DC and couplest he AC to the next stage of the circuit: Is it true or false? C) The more the value of the stray capacitance , the better it is: Is it true or false?
Determine the total capacitance, in nF, of a parallel-plate capacitor having three dielectrics in between where the individual capacitances in nanofarads are 71, 90, 19, respectively.
Method: Transient Analysis Solve for Current and Voltage at 20 ms and 100 ms for: Capacitor 1 (C1) (20 microFarad) Capacitor 2 (C2) (10 microFarad) Inductor (L1) (10 mH) Resistor 1 (R1) (500 ohms) Resistor 2 (R2) (200 ohms) Voltage: 25 V, 1000 Hz
In the magnetically coupled circuit shown k1=1, kK2=0.873 & V5=2020°V. 1.Find the voltage across the capacitor using mesh {Maxwell) current method? 2.Find the total power dissipated in the circuit? (Ans.: Vc=21.4521567°V & Pr=55.7W)