PROBLEM 2: The 280-kg, 6m-wide rectangular gate shown is hinged at B and leans against the floor at A making an angle of 45° with the horizontal. The gate is to be opened from its lower edge by applying a normal force P at its center. 0.5 m Water 3 m 45° DI

Q: A rectangular beam 300 mm deep is simply supported over a span of 4 metres. What uniformly distribut...

A: Depth of beam =300 mm deep is simply supported  span length = 4 meters. to find the uniformly distri...

Q: what picture is related to civil engineering field? Give three mathematical terms describing the pic...

A: Step: 1 Civil engineering field consist construction and designing of project. For example – road c...

Q: 225 kN- 6m - 6 m - Using Cantilever Method, determine the Shear force at BE in kN.

A:

Q: Computer the travel time using the Sheet Flow Method for a 25-year design storm. Assume the project ...

A: Travel Time or Time of concentration : 1. Time of concentration is a concept used in hydrology to me...

Q: H.W: - After surveying a borrow-pit, the surveyor produced the following borrow- pit grid below, the...

A: Given:- The borrow-pit grid of the ground surface is given  The excavated cut level = 10 m To determ...

Q: Year Annual rainfall Year Annual rainfall (cm) (cm) 1960 130.0 1971 90.0 102.0 1961 84.0 1972 1962 7...

A: the annual rainfall from 1960 to 1981 years are given in table form.75 % dependable annual rainfall ...

Q: A rigid beam loaded with negligible mass is pinned at B and is supported by two identical rods, exce...

A:

Q: O Camidee the hemepleeced spiedl Shown bebw Bubged G Q eidlial staess p (cum forun). Computi the Vee...

A:

Q: What

A: A tall structure usually have less width and length compared to its height. A structure whose height...

Q: Consider the following shear force diagram as shown in figure: V (in kN) 10 kN! -2 degree x(m) -2 kN...

A:

Q: What are the various EIGRP tables

A: Various EIGRP tables are listed below: 1. Neighbor table 2. Topology table 3. IP routing table

Q: With the schematic diagram of a pump, tanks, and piping determine the following: 1) The velocity of ...

A: Given, Pump and pipe system 

Q: A flat steel plate is of trapezoidal form. The thickness of the plate is 15 mm and it tapers uniform...

A:

Q: leans against the floor at A making an angle of 45° with the horizontal. The gate to be opened from ...

A: solutionWeight of gate, W =600lbWidth of gate, B =20ftAngle of gate with horizontal, θ =45°Specific ...

Q: 40. The following water content data are from several plastic limit tests for a soil. Determine PL o...

A: we will find water content for each test and take average.

Q: At a point in an elastic material under strain, there are normal stresses of 60 N/mm2 and 40 N/mm2 (...

A:

Q: Oil 45 kPa SG = 0.72 75 cm Air Water 30 cm Mercury SG= 13.6

A: Specific gravity of oil ,SGo=0.72Specific gravity of mercury ,SGm=13.6Depth of oil = 75cm=0.75mDepth...

Q: A 24-hr storm occurred over a catchment of 2.8 km area and the total rainfall observed was 10 cm. An...

A:

Q: A beam is loaded as shown in figure below: wo A B 2 2 R2 R, The moment at B (MB) will be

A:

Q: he to The structure loaded as shuwn : he 4m P 40 KN E 200 GPa 12=1c_100 x 10° mm • Solve the reactio...

A:

Q: PROBLEM 1: Both a gage and a manometer are attached to a tank lo measure pressure, Given the reading...

A: The values and diagram given in the question are as follows

Q: A soil sample was collected by driving steel cylinders of 1000 cm3 of volume and mass of 100 g wit...

A: We will calculate water content and solid weight

Q: fundamentals of surveying. ANGLE TO THE RIGHT TRAVERSE. A five-sided closed traverse proceeds in a ...

A:

Q: Determine the vertical reaction at A.

A: To determine the vertical reaction at support A.   In order to determine the reaction at A, we will ...

Q: Assume a turtle can move at an average speed of 0.100m/s while a hare can move at a speed of 15m/s. ...

A: It is required to find the time in seconds the hare has to wait for the turtle to catch up 

Q: E= 30 LFel=? Y A FeloN 30

A:

Q: In a storm of 210 minutes duration, the incremental rainfall at various time intervals is given belo...

A:

Q: 2. Calculate the ultimate capacity of a rectangular beam with b-350mm, d=540mm, A, = 5- 25 mm. Assum...

A:   Given b=350mmd=540mmf'c=24Mpafy=345MPa As= 5×π4×252=2454.37mm2 ρb=0.85 f'cβ1× 600fy(600+fy)β1 = 0....

Q: The state of stress at a point P in a two dimensional loading is such that the Mohr's circle is a po...

A: Given data,   Mohr’s circle is a point located at 175 MPa on the positive normal axis. So it is a po...

Q: Question 6 E F D 225 kN 6 m A B 6 m 6 m Using Cantilever Method, determine the Shear force at EF in ...

A: Given data in question  Frame Load Dimension To find out  Shear force in EF

Q: -67.5 kN 3.6 m to D - 112.5 kN E F 3.6 m A B C 6 m -4.5 m- +4.5m Use cantilever method to analyze th...

A:

Q: Two similar round bars A and Bare each 30 cm long and loaded as shown in the given figure. The ratio...

A:

Q: e initial rate of infiltration of a watershed is estimated as /hr, the final capacity is 0.2 in/hr, ...

A: K=-0.4 per hr Time period=6hr

Q: Determine the horizontal and vertical components of reaction at the pins A and C. JA 12 kN/m 60° -60...

A: This question is related to the Structure Analysis. In this question we calculate the reaction at su...

Q: F 5 k 16 D 10 k E 16 C 12 ft 12 ft

A: This question is related to Structure Analysis. In this question using Force equilibrium equations w...

Q: PROBLEM 2: The 280-kg, 6m-wide rectangular gate shown is hinged at B and leans against the floor at ...

A:

Q: Ac-beam is subjected to the loads shown. The dimensions and loads of the c-beam are given below. P=5...

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since t...

Q: Find the work required to pump all of the water from a rectangular tank with an 8mx5m base and a hei...

A: To determine the work done to pump out the water from the given rectangular tank.   Given, Dimension...

Q: 25 lb 15 lb 1 ft

A:

Q: E 20 k 12 ft 12 ft 5 k -5 ft-5 ft- -14 ft-

A:

Q: Estimate the annual volume of water lost due to evaporation on a 6.273 km2 lake assuming a pan coeff...

A: Calculate total lake evaporation and multiply by pan coefficient.

Q: For the beam and loading shown below, calculate the maximum and minimum factored reaction for suppor...

A:

Q: Which of the following statements is INCORRECT? O During dry periods, surface cracks that develop on...

A: Infiltration is the process by which water on the ground surface enters into the soil.

Q: Is it 49.3 kN down or up???

A: This question is related to the Structure Analysis. In this question Reaction at B (Rb or By ) will ...

Q: 2. A column in a building is subjected to the following load effects: 9 kips compression from dead l...

A:

Q: A field was supplied water from an irrigation tank at a rate of 120 lit/sec to irrigate an area of 2...

A:

Q: 60 mm 30 mm y 40 N•m (a) 00.02 mm 40 N.m 30 mm y 5 mm 10 mm 10 mm (b)

A:

Q: building is 30 m. high and has a total dead load of 45,000 kN. If the zone factor is 0.40, importanc...

A: Give:  A building is 30 m. high           Total dead load = 45,000 kN.            Zone factor = 0.40...

Q: 1.0 m E23 10 cocer 1.5 m k5.2x 10 cmisec Canal 3.0 m k2.0x 10 cm/sec 2.0 m 1.2 m A=0.3 x 10 cm/sec 3...

A:

Q: Y 8 - 200 450 mm d' = 35 mm

A: Given data: fy=460 N/mm2d'=35 mm