Answered: Problem 4: The mass of the diver is 75…

Problem 4: The mass of the diver is 75 kg and the mass of the diving board is 45 kg. Draw the free body diagram of the diving board. Find the reactions at A and B.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.72P: The cable AOB weighs 24 N/m. Determine the sag H and the maximum tension in the cable.

See similar textbooks

Related questions

Q: Find the enthalpy and the specific volume of stea, at 169.06 kPa if its quality is 90%.

Q: The following observations were recorded during a boiler trial of 1 hr duration. 700 kg of coal of c...

A: Explanation: The stepwise procedure to solve this problem is shown in the following attached image:

Q: Find density Mars s= 30% yolume -7c

A: Given data : The value of mass =m=30 g The value of volume=V=7 cm3 Required : Density

Q: the welght of the red 70N 0.8 m SON 1.3 m

A: Given DataP1=70NP2=50NW=5kg×9.81m/s2RA=?RB=? ***As per our company policy we are supposed to do only...

Q: Figure 2.1 shows a double-pipe heat exchanger is constructed of a stainless steel (k =15.1 W/m.°C) i...

Q: The velocity components for a three dimensional incornpressible flow is given by : u=x'-y-2x, v=y'-z...

Q: discuss the power train of a four-wheel tractor and power tillers. Discuss how power is transmitted ...

A: A transmission is a gearbox that reduces the speed of a vehicle. It can be described as a series of ...

Q: a trolley of mass m stands on frictionless rails.a rod of mass m and length l is pivoted to the roof...

A: Write the free-body diagram of the system.

Q: The diameter of pipe carrying water changes gradually from 20mm at A to 450mm at B. A is 4.57m lower...

A: Write the given data. dA=20 mmdB=450 mmzB-zA=4.57 m

Q: In the system shown, it is found that the force multiplier of force Facting from B to D is Fm 200 KN...

A: By using Sine Rule, 4000/ sinA = 22 / 24 SinA = 4000 * 24 / 22

Q: Which of the following sectioned beams show the internal force reactions drawn to match our positive...

Q: 2. Find the resultant force R acting through point C and the horizontal couple acting through points...

A: Given data: Grid size =1m×1m Need to determine the magnitude of the resultant force and couple about...

Q: Thermodynamic Properties of HFC-134a Refrigerant (1,1,1,2-tetrafluoroethane) CH2FCF3 molecular Wei...

A: Case1: when the refrigerator is placed in household air, TH= 70°F= 294.26 K TC = 0°F= 255.372 K Car...

Q: Determine the equivalent spring constant of the system where the spring will be located in the posit...

Q: gate A plane ex of 8ox 8ocm is submeuged On 45 angle with the in water Af it is hovizontal, what for...

Q: Refrigerant 12 is expanded steadily in an isothermal (constant temperature) process. The flow rate i...

Q: 2.5-14 A brass sleeve S is fitted over a steel bolt B (see figure), and the nut is tightened until i...

A: The force exerted on the sleeve and the bolt due to thermal expansion is given by the formula given ...

Q: Carbon dioxide at 537°R and 14.7 psia has a density of 0.1123 lbm/ft3. Determine (a) the gas constan...

A: GIVEN DATA - TEMPRATURE T=537'R PRESSURE P=14.7 psia DENSITY = 0.1123 lbm/ft3

Q: a steam 8.0 MPa and 485 degree Celsius enters the turbine and expand at condenser pressure of 0.006 ...

A: Givenmass of the steam m=1kgsteam enter at turbineP1=8MPaT1=485oCcondenser endP2=0.006MPa

Q: Find the longitudinal stress in the tank.

A: To Find the longitudinal stress.

Q: Q13 Find the force F moment = 50 Nm distance = 0.25 m force = ? moment = force x distance from the p...

A: Given data, Force F is applying perpendicular to the bar, d= perpendicular distance to the force a...

Q: Draw clearly the Kinematic diagram and the degree of freedom Lift Table

A: A lift table is a device that raises merchandise, pallet loads, and other items using a scissor mech...

Q: PROBLEM 7: A tanker carries 190000 barrels of motor gasoline in its hold. Determine the weight of th...

A: Given data, Number of barrels, n= 190000 S= 0.720 Volume of each barrel v= 159 litre =0.159 m³

Q: Problem 3 Two pipes are connected by a manometer as shown in Fig. Determine the pressure difference,...

A: It is required to determine pressure difference between A and B

Q: xplain how each of these variables relate to environmental impact assessment and how they affect th...

A: Environmental Impact Assessment (EIA) is the process of analysing the possible environmental imp...

Q: Item Unknown phase h *SBL SPH %x %y kJ/kg K 1.76713 kPa L/kg kl/kg k/kg "C 1 1609.6 1354.8 1.74463 5...

A: P T v h s 1609.6 41 0.1485 416 1.6952 1354.08 35 0.01726 415.23 1.74463 548.06 3 0.04253 406.3...

Q: An open tank in the shape of a frustum of a cone is bound by two hoops, one at the top and the other...

A: according to the detail pr0ovided and some assumptions

Q: analyze a symmetrically loaded simple truss. The minimum number of members is 10. All joints must ha...

A: 1A => Minimum number of members, m = 2j - 3 = 2* 10 - 3 = 20 - 3 = 17 1B => Minimum number o...

Q: 3.4-3) A stepped shaft ABCD consisting of solid eircular segments is subjected to three torques, as ...

Q: 1. 2 kg of air undergoes a power cycle undergoes a power cycle consisting of the following processes...

A: Dear student, we are suppose to solve only 3 sub parts. Please post other parts as a separate questi...

Q: A car is to be hoisted by elevator to the fourth floor of a parking garage, which is 48 ft above gro...

A: Apply kinematic equation for 0 to maximum velocity to calculate the vertical distance during acceler...

Q: An ideal double-reheat steam turbine receives 290,000 kg/hr of steam at 10 MPa and 400 °C. The two r...

A: Disclaimer:Since you have posted a question with multiple subparts, we will solve the first three su...

Q: A solar energy based HE which recieves 60KJ of heat at 900C and rejects 50kJ of heat to the ambient ...

A: Given data, Q1= 60 kJ ,T1= 90°C Q2= 50 kJ ,T2= 30°C

Q: When discussing the reasons why a change from 12 V to 42 V batteries is likely in the future, Techni...

A: following is the answer to the problem-

Q: A battery is well insulated while being charged by 12.3 V at a current of 6 A. Take the battery as a...

A: power = V * I = 12.3 * 6 = 73.8

Q: The following observations were recorded during a boiler trial of 1 hr duration. 700 kg of coal of c...

A: We've provided information from the question: ms=5250 kg/hr, p=12 bar,C.V.=30000 kJ/kg, x=0.94,Ts...

Q: 500 5. Calculate the resultant of the force system, and express it as a force and a couple moment wi...

Q: In an oil pool, a small steel ball is released from the surface (y=0) without initial velocity. The ...

A: Given that, Mass of ball, m=0.2 kg,Constant, k=0.84355 kg/sec,Acceleration due to gravity, g=9.81 m/...

Q: 1. A small airplane flying horizontally with a speed of 150 miles/hr at an altitude of 400 feet abov...

Q: A room in the lower level of a cruise ship has a 30-cm-diameter circular window. If the midpoint of ...

Q: •Platinum and gold are completely soluble in both the liquid and solid states. The melting point of ...

A: Given Data : Melting point of platinum = 3225 oF Melting point of gold = 1945 oF Alloy starts to so...

Q: A cylindrical steel pressure vessel with a diameter of 1200 mm and a wall thickness of 20 mm is subj...

Q: Show the derivation of the girth and longitudinal stresses of the thin-walled cylindrical container...

Q: Problem 2 A U-tube manometer is connected to a elosed tank as shown in Fig. P2.3/, The air pressure ...

Q: A 500-g collar can slide without friction along the semicircular rod BCD. The spring is of constant ...

Q: A torsional bar is subjected to two external torques (10NM and 5Nm) and a distributed torqu (15NM/m)...

Q: What are the components of the environment from the point of view of the decision-maker? What do th...

A: 1) Understanding biological system creation, construction, and capacity; and the executives of human...

Q: draw the projection three

A: To find Projections

Q: stimate the total volumetric flow rate gas and the total mass emission rate of the particles in Fig ...

A: Given data: At section 1 and section 2, the measured velocities and particle flow rates are as follo...

Q: Two kilograms of water is contained in a pis- ton/cylinder (Fig. P3.143) loaded with a linear spring...

Question

Problem 4: The mass of the diver is 75 kg and the mass of the diving board is 45 kg. Draw the free body
diagram of the diving board. Find the reactions at A and B.
B
Wp
WD
+ 1.2 m
2.4 m
4.6 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.
The homogeneous 20-kg door is held in the horizontal plane by a thrust hinge at O, a hinge at A, and the vertical prop BC. Determine all forces acting on the door.
The uniform, 20-kg bar is placed between two vertical surfaces. Assuming sufficient friction at A to support the bar, find the magnitudes of the reactions at A and B.
The cable AOB weighs 24 N/m. Determine the sag H and the maximum tension in the cable.
The 40-kghomogeneous disk is placed on a frictionless inclined surface and held in equilibrium by the horizontal force P and a couple C (C is not shown on the figure). Find P and C.
The 350-lb homogeneous plate has the shape of an isosceles triangle. The plate is supported by a thrust hinge at A, a slider hinge at B, and the cable CD. Find the force in the cable and the magnitudes of the hinge reactions.
The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
The automobile, with center of gravity at G, is parked on an 18 slope with its brakes off. Determine the height h of the smallest curb that will prevent the automobile from rolling down the plane.
The pulley-cable system supports the 150-lb weight. The weights of the pulleys and the horizontal bar ABC are negligible. Determine the cable tensions at A and C and the distance x.
The center of gravity of the nonhomogeneous bar AB is located at G. Find the angle at which the bar will be in equilibrium if it is free to slide on the frictionless cylindrical surface.