Problem: For the antenna position control system, find lead-lag compensator control (proportional gain will be given by the pre-amplifier gain K), so that the following requirements are fulfilled: 25% OS 2-second settling time • Ky = 20. Here OS = maximum overshoot Settling time > use 2% formula

Problem: For the antenna position control system, find lead-lag compensator control (proportional gain will be given by the pre-amplifier gain K), so that the following requirements are fulfilled: 25% OS 2-second settling time • Ky = 20. Here OS = maximum overshoot Settling time > use 2% formula

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: For a new receiver circuitry what is an appropriate amplifier?

A: Based on the basic of communication system

Q: a) What is the intermediate frequency and why is it necessary (why not simply use the RF frequency…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: explain with drawing the super heterodyne receiver?

Q: 22. A radar system receives signals at 2.5 GHz and uses superheterodyne detection with an…

Q: Define signal-to-noise ratio and noise figure of a receiver. When might the latter be a more…

A: Signal-to-noise ratio ( SNR ) is define as a ratio of the power of a signal to a noise power which…

Q: 3) Determine the minimum height of the receiving antenna of a 45-km 5 pts communication system whose…

Q: Write shortly about the instrumentation of FT-IR? Please shortly answer at your own words. Answer…

Q: State how the frequency of a carrier varies in an FM system when the modulating signal amplitude and…

Q: What is the effective radiated power (ERP) of a repeater with 450 W transmitting power output, 4 dB…

A: It is given that: Transmitting power output=450 WFeedline loss=4 dBDuplexer loss=6 dBCirculator…

Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…

A: It is given that: carrier frequency:fc=520 kHz

Q: 4. A wireless host is initially located 8m away from the transmitter. The signal power at this…

A: we are authorized to do only one question at a time so i am solving question 4 only Distance of foot…

Q: Q / Consider a cellular system with 500 total allocated voice channel frequencies. Calculate the…

A: Cellular System, Total number of voice channel=500 calculate S/I ratio is equal to 4,7,12; N=4,7,12

Q: Increasing the transmitter power of a radar by a factor of 5 will increase the maximum range by what…

A: Given:- PT=Transmitted Power P'T=5PT

Q: FM DEMODULATION Why is it necessary to recover the original information signal from the carrier?

A: By using modulation we sent our original signal from transmitter to receiver with the help of…

Q: Which of the following properties are not advantages of the microwave (radio-relay) communication…

A: In this question, Choose the correct option Which of the following properties are not advantage of…

Q: ) A satellite in geostationary orbit at (36000 km) has a (4 GHz) downlink transmitter which feeds…

Q: An attenuator can be made using a section of waveguide operating below cutoff, as shown in the…

A: According to question, determine the required length of the below-cutoff section of the waveguide to…

Q: Engineers plan to use a 2 x 10^9 Hz link with a 300 Hz bandwidth to communicate with a remote…

A: We need to find received power at given distance . We will also find out noise power then we will…

Q: Wirless communication Determine the carrier-to-noise density ratio for a receiver with a 70 dBW…

A: The solution is given below

Q: Find the basic path loss for a communication link from Moon to Earth operating at 4000 MHz. The…

A: Path loss (in dB) can be defined in the following way:

Q: broadcast superheterodyne receiver having no RF amplifier, the loaded Q of the antenna coupling…

A: We need to find out the image frequency and image rejection ratio .

Q: What is the relation between carrier frequency of received signal and the intermediate frequency of…

A: The superheterodyne receiver(also called as superhet) is a type of radio receiver which uses a…

Q: A.G. distance of 40 km from the receiver. What should be the minimum height of receiving antenna?,…

A: For the above given question we need to calculate the value of minimum height of the receiving…

Q: A wireless communication system has a trasmit power Pt = 10 mW. Through extensive measurements, the…

A: A wireless communication system has a transmit power Pt = 10 mW. Through extensive measurements, the…

Q: Consider a cellular system with operating frequencies around fc = 900 MHz, cells of radius100 m, and…

A: We need to find transmitted power for given system .

Q: 1. What will happen if an antenna is not a part of the radio receiver circuit? 2. What is the effect…

A: As per our policy we can provide answer to first question only. A high frequency electricity is…

Q: Suppose you have a 2.4 GHz W-Fi access point that has an EIRP of 23 dBm 1. Express the EIRP in mw…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Digital MPSK transmissions carried on a 6GHZ terrestrial link require a bandwidth of 24MHz. The…

A: To calculate the received power. With the given data- Let Pt=Transmitted power Pr=Received power…

Q: A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. What is the modulation index?

A: Given: fc=162 MHz∆f=12 kHzfm=2 kHz

Q: n a superheteridyne receiver, what is the value of the image frequency if a 580 kHz channel is being…

A: Given that IF frequency = 455 khz signal frequency = 580 khz Formula of image frequency is given by…

Q: Determine frequency the fade margin for the following conditions: distance between sites, D = 40…

A: In wireless communication when a signal is transmitted from one location to another the signal get…

Q: A) What does the Modulation term mean in Communication?

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Q2: What's the effect of phase error A0 and small frequency error Af in the locally generated…

A: Here, the same carrier signal generating SSBSC waves is used to detect the message signal. Hence,…

Q: (a) Sketch the satellite communication system between the transmitter and the describe the type of…

A: A satellite communication is define as the communication which has an involvement of satellite…

Q: What is AMOLED? why is it used? advantages disadvantages ?

A: Amoled is a technology that is used in the display of smartphones. The full form of Amoled is Active…

Q: What are the applications of Yagi-Uda antenna array?

A: The explanation is as follows.

Q: In layman's term, explain intermediate frequency and its importance. What is the use of intermediate…

A: An intermediate frequency (IF) is a frequency to which a carrier is shifted as an intermediate step…

Q: What is AMOLEDs? History of AMOLED?. What is purpose of AMOLED?. The parts and components of amoled?…

A: AMOLED is a display technology and stands for Active Matrix Organic Light Emitting Diodes. It is a…

Q: One of the key factors that drives the design of a satellite based personal communication system is…

A: According to the question we have to calculate the value of the maximum uplink range.

Q: Find the basic path loss for a communication from Moon to the Earth operating at 3000 MHz. Assume…

A: The basic path loss for a communication link can be expressed as

Q: A system is being designed to use a 30 GHZ link with a 300HZ bandwidth to receive signals from a…

A: According to the question we have to discuss about SNR.

Q: A circular loop, of loop radius λ/30 and wire radius λ/1000, is used as a transmitting/receiving…

A: a)The radiation resistance of the loop is given by Rr=η2π3sλ2 ...............(1)we have circular…

Q: Determine frequency the fade margin for the following conditions: distance between sites, D = 40…

A: In wireless communication, when a signal is transmitted from one location to another, the signal…

Q: Why S-Parameters are with proper mathemati cal equations? required to analyze the Microwave networks…

A: Microwave networks- Microwave networks are used for transmission of information by microwave radio…

Q: What is the relation between carrier frequency of received signal and the intermediate frequency of…

A: Given : Superheterodyne receiver is one of the analog receiver. FS= Carrier frequency of the…

Q: Q2. Calculate the lowest three (n=1,2,3) blind speeds of an MTI radar operating at 3 GHz, with a PRF…

A: To convert a unit of Meter per second into Kilometer per hour, 1 m/s = 3.6 km/h To convert a unit…

Q: 6. What is the relation between carrier frequency of received signal and the intermediate frequency…

A: The relationship between the carrier frequency and intermediate frequency is in step-2.

Q: Q 2: Draw the block diagram of the synchronous(coherent) detector, and explain briefly what the…

A: Brief description : Here in the above question we need to explain about block diagram of the…

Q: Determine the fade margin for the following conditions: distance between sites, D = 40 km;…

A: In wireless communication when a signal is transmitted from one location to another the signal get…

Question

Problem: For the antenna position control system, find lead-lag compensator
control (proportional gain will be given by the pre-amplifier gain K), so that the
following requirements are fulfilled:
• 25% OS
2-second settling time
• Ky = 20.
Here OS = maximum overshoot
- Settling time → use 2% formula

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circular loop, of loop radius λ/30 and wire radius λ/1000, is used as a transmitting/receiving antenna in a back-pack radio communication system at 10 MHz. The wire of the loop is made of copper with a conductivity of 5 .7 ×10 7 S/m. Assuming the antenna is radiating in free space, determine the(a) radiationresistan ce of the loop; (b) loss resistance of the loop (assume that its value is the same as if the wire were straight ); (c) input resistance; (d) input impedance; (e) radiation efficiency.
Q / Consider a cellular system with 500 total allocated voice channel frequencies. Calculate the mean S/I ratio for cell reuse factor equal to 4,7, and 12. Assume omnidirectional antennas with six interferers in the first tier and a slope for path loss (γ = 4). Discuss the results
An attenuator can be made using a section of waveguide operating below cutoff, as shown in theaccompanying figure. If a = 2.286 cm and the operating frequency is 12 GHz, determine the requiredlength of the below-cutoff section of waveguide to achieve an attenuation of 100 dB between the inputand output guides. Ignore the effect of reflections at the step discontinuities.
6. What is one advantage provided by a phase-shift keying (PSK) system?A. Improved noise performanceB. Better ionospheric fading characteristicsC. Low probability of errorD. Transmitter frequency is constantly changing
EMT by sadiku-chapter 13-antenna problem no 20.-ASAP
Four received power measurements were taken at distances of 100 m, 200 m, 1 km, and 3 km from a transmitter. These measured values are given in the following table. It is assumed that the path loss for these measurements follows the model in Equation (4.69.a), where do = 100 m: find the minimum mean square error (MMSE) estimate for the path loss exponent, n
A) Draw root locus? B ) Calculate departure point from the real axis and K gain on this point? C ) Calculate departure point from the imaginer axis and K gain on this point? D) Define stability range for the system?
2. Mention the advantages of indirect method of FM generation? 4.
Identify and describe components of radio frequency communications focusing on units of power and comparisons, radio frequency mathematics, signal/interference/noise ratios, and budgets. Need detailed answer please. Thanks in advance
4. One of the key factors that drives the design of a satellite based personal communication system is the size and allowable power of the handset transmitter. If the handset is limited to a three-quarter watt (0.75W) transmitter, and has an antenna with a gain of only 1.5 dB, what is the maximum range over which we can close the uplink with an acceptable margin (10 dB)? Givens: a) satellite antenna diameter of 1.0 meter (.65 efficiency), b) transmitter frequency 900 MHz, c) bandwidth 150 KHz, and d) noise temperature 500K.
In layman's term, explain intermediate frequency and its importance. What is the use of intermediate frequency in superheterodyne receiver?
A wireless communication system has a trasmit power Pt = 10 mW. Through extensive measurements, the path gain of the system at the reference distance is determined to be -32 dB, and the path loss exponent to be 3.8. Using the simplified path loss model, find the received power in mW at distance 200 meters from the transmitter