PROBLEM No. 2 Two steel pipe columns (E = 200,000 MPa, A1 = 1800 mm², A2 = 2000 mm²) support a rigid beam AC that has a 3.6 m overhang AB. The beam supports a linearly varying load of maximum intensity w = 75 kN/m as shown in the figure. Neglect the weight of the beam AC, and assume that the beam is supported on the two columns such that it transmits load to each column as an axial load. Determine the vertical displacement at end A of the beam, in column 1 at B and column 2 at C. Answer in mm. kN 75 m В - "Rigid" |(1) 2.4 m (2) 3.6 m 3.6 m

PROBLEM No. 2 Two steel pipe columns (E = 200,000 MPa, A1 = 1800 mm², A2 = 2000 mm²) support a rigid beam AC that has a 3.6 m overhang AB. The beam supports a linearly varying load of maximum intensity w = 75 kN/m as shown in the figure. Neglect the weight of the beam AC, and assume that the beam is supported on the two columns such that it transmits load to each column as an axial load. Determine the vertical displacement at end A of the beam, in column 1 at B and column 2 at C. Answer in mm. kN 75 m В - "Rigid" |(1) 2.4 m (2) 3.6 m 3.6 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Fluid mechanics, i need solutions in 10 minutes please. Q/Q2 The 4 -m- diameter circular gate of Fig. E2.6a is located in the inclined wall of a large reser voir containing water (y = 9.80 kN / m³). The gate is mounted on a shaft along its horizon tal diameter. For a water depth of 10 m above the shaft determine: (a) the magnitude and lo cation of the resultant force exerted on the gate by the water, and (b) the moment that would have to be applied to the shaft to open the gate.
an open rectangular tank mounted on atruck is 8 m long and 1 m. wide. it is filled with water to a depth of 3.69 meters. if it is accelerated at 10.16 m/s^2 along its length, determine the required height (in meters) of the tank to prevent any water from spiling.
A tank has one of its side inclined inward at an angle of 30° with horizontal. The free surface of the contained water is at Elev 15.25 m. The orifice located on the inclined side issues a jet, having it's vena contracta at Elev 10.70 m. If the highest point in the trajectory of the jet is at Elev 14.00 m, find the actual velocity of the jet air friction. Neglect air friction. Include fbd.
Neglect friction of the 55-Ibf collar against its vertical guide and compute the velocity of the collar after it has fallen 7ft., starting from22 ft/sec. in the position shown below. The unstretched length of the spring is 3ft.
Find the total force on the side of a water-filled cylindrical tank with 5m height and 10m diameter woter =9800 N/m' a) 3848 KN b) 5547 KN Ocd 7696 KN d) 2770 KN
A rectangular plate with a width of 16 m and height of 12 m is located 4 m below the water surface. The plate is tilted and makes angle of 35deg angle with the horizontal. The resultant hydrostatic force in kN acting on the top surface of this plate is a. 9745 b. 5190 c. 10,800 d. 8470
A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which the velocity is 3.60 m/s. The pressure is – 34. 465 kPa at A in the suction pipe. The 15 cm diam pipe discharges horizontally into air at C inclined at 30 degrees. Find the maximum height and range that the water can reach if B is 1.8 m. above A and 20 hp is delivered to the pump? Assume that the pump operates at 80 % efficiency and that the frictional loss in the pipe between A and C is 3 m.
An elevated water tank weighs 3000kN when filled with water, the centroid of the mass being at a height of 9 meters from ground. The horizontal spring factor for the tank tower is 15 kN/mm. Determine the shear force generated at the base of the water tank tower by horizontal seismic inertia force. Assume the ground motion has a period of 2.0 sec and maximum acceleration of 0.15g
A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up to measure any displacing force, the tank is suspended in a particular way. The horizontal force is required to keep the tank in place on the removal of the plug. The opposite applied force to the orifice is 16.8N. The volume per time was found as 141lt/minute. It is assumed that the level of the water is maintained at a constant height of 2.785m above the orifice. Calculate Cc, Cv, and Cd for the orifice.
A 100-N 8.0-m uniform cantilever is installed as a diving board fixed to the ground using two support fulcrums. It is expected to accommodate divers with a maximum weight of 800 N. Determine the reactions (magnitude and direction) of the two support fulcrums A and B before the diver jumps off the end of the diving board? *
Determine the support reaction forces and moment for thesketched system
A pump draws water from a 20 cm diam suction pipe and discharges through a15 cm diam pipe in which the velocity is 3.60 m/s. The pressure is – 34. 465 kPaat A in the suction pipe. The 15 cm diam pipe discharges horizontally into air atC. To what height h above B can the water be raised if B is 1.8 m. above A and20 hp is delivered to the pump? Assume that the pump operates at 80 %efficiency and that the frictional loss in the pipe between A and C is 3 m. Determine the inclination angle at point C for the water stream to reach a range of 50 m. Also, calculate the maximum height that the water can go from the selected datum plane.