Problem: The given data are obtained from the hydrographic survey of a reservoir. Theaccompanying tabulation gives elevations of points over the area of 60m by 100m thesurface area of the reservoir was divided into squares of 20m. Point A -1 is located in thenorthwest corner of the lot and D- 6 at the southeast corner. All elevations are in meters.Use contour interval of 0.50 m. The water surface elevation is 112.00mPoints235A113.7113.2113.5112.15112.3112.7112.2110.6109.3109.9110.7112.8C112.7110.4109.5109.2110.5112.6D112.55112.6112.4112.4112.8112.91. Plot the data using a scale of 1cm = 5m.2. Use pencil in plotting the squares.3. Draw the contour lines. These contours represent the depth of water at every0.50m interval.4. Draw the longitudinal section of the reservoir showing the level of water at every0.50 m interval.

Solution Scale = 1 cm = 5 m From the data given, identify the maximum and minimum elevation of…

Problem: The given data are obtained from the hydrographic survey of a reservoir. The accompanying tabulation gives elevations of points over the area of 60m by 100m the surface area of the reservoir was divided into squares of 20m. Point A -1 is located in the northwest corner of the lot and D- 6 at the southeast corner. All elevations are in meters. Use contour interval of 0.50 m. The water surface elevation is 112.00m Points 2 3 4 6 A 113.7 113.2 113.5 112.15 112.3 112.7 В 112.2 110.6 109.3 109.9 110.7 112.8 C 112.7 110.4 109.5 109.2 110.5 112.6 D 112.55 112.6 112.4 112.4 112.8 112.9 1. Plot the data using a scale of 1cm = 5m. 2. Use pencil in plotting the squares. 3. Draw the contour lines. These contours represent the depth of water at every 0.50m interval. 4. Draw the longitudinal section of the reservoir showing the level of water at every 0.50 m interval.

Problem: The given data are obtained from the hydrographic survey of a reservoir. The accompanying tabulation gives elevations of points over the area of 60m by 100m the surface area of the reservoir was divided into squares of 20m. Point A -1 is located in the northwest corner of the lot and D- 6 at the southeast corner. All elevations are in meters. Use contour interval of 0.50 m. The water surface elevation is 112.00m Points 2 3 4 6 A 113.7 113.2 113.5 112.15 112.3 112.7 В 112.2 110.6 109.3 109.9 110.7 112.8 C 112.7 110.4 109.5 109.2 110.5 112.6 D 112.55 112.6 112.4 112.4 112.8 112.9 1. Plot the data using a scale of 1cm = 5m. 2. Use pencil in plotting the squares. 3. Draw the contour lines. These contours represent the depth of water at every 0.50m interval. 4. Draw the longitudinal section of the reservoir showing the level of water at every 0.50 m interval.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Calculate the side widths and cross-section area of embankment having width =20m and side slope( 1/2 )formation level =20m . ground level=15m and ground slope ( 1/12) from C.L to side
From the results of a hydrographic survey of a lake, the following area were obtained: a= 11236.12 m^2b= 11052.35 m^2c= 10968.69 m^2d= 10185.47 m^2e= 97458.98 m^2f= 89618.34 m^2g= 75961.78 m^2h= 62845.96 m^2If the vertical distance between contour lines is 6m, determine the volume of water in the lake above the level of contour H using average end area method.
n Rising and Dipping distance which equation is correct? a. 2.20 X √ Elevation b. 4.10 X √ Elevation c. 3.08 X √ Elevation d. 2.08 X √ Elevation
The areas in cut of two irregular sections 65 meters apart are 36m2 and 72m2 respectively. Base width is 10 meters, side slope of 3H:2V. Using prismoidal correction formula, find the corrected volume of cut in m3 between the two stations.
Answer the subquestions: A. A slope measurement of 545.38 m is made between points A and B. The elevation of A is 424.25 m and that of B is 459.06 m. Determine the horizontal distance between two points. B. A traverse line was measured in three sections: 295.85 m at slope 8°45’, 149.58 m at 4°29’, and 373.48 m at slope 4°23’. Determine the horizontal length of the line. Note: Draw the figure and show the complete solution. Provide a recheck of the answers.
Given a rectangular tract of land 690m by 1220m, the elevation at the center of the tract (E) is 165.0m and the elevation of corners A,B,C and D are 62.5m, 93.3m, 212.8m and 125.3m, respectively. Assuming uniformity of slope between the given corners, and contour interval of 20m, you are required to plot the contour lines. The contour lines with elevations of 100m and 200m to be shown as index contours.
A two-level section has the following data:bottom width=8m side ,slope=2:1 on the left ans 1:1 in the right,transverse slope of the ground=8:1.Find the area of the section if the height at the center is 35% of tge formation width
Simpson rule in surveying
A line XYZ is measured on the slope in two segments. The first segments XYmeasures 824.45m and the second segment YZ measures 1244.38m.If thedifference in elevation between points X and Y is 4.25m and that between Y andZ is 6.47m,determine the horizontal length of the measured line.
In the quadrilateral ABCD the sides were measured as follows: AB, 8.34 m; BC 7.77 m; CD, 8.99 m; and DA 14.83 m. If the angle between sides AB and BC is 117.85 degrees, determine the area of the quadrilateral. PLEASE NEED ANSWER IN 10 MINS. SORRY BUT IT HAS NO DIAGRAM PRESENTED.
A trapezoidal channel is to be designed to carry 280m3/minute of water. Determine the cross – sectional dimensions of the channel if the slope is 1 in 1600, side slopes 45oand the cross – section is to be a minimum, take c = 50 in si units.
Compute the elevation of reservoir C. CHOICES: a.835.06, b. 538.06, c. 853.60, d. 583.60.