Problem#1 Determine vo in the op-amp circuit shown in Fig. 1 6 V 20 ΚΩ 2 V b 40 ΚΩ 2010

Q: Q1:- A GaAs sample with no = 3x 10¹5 cm³ is illuminated with light and 10¹4 electron- hole pairs/cm³…

A: We need to find out the change in hole concentration

Q: The magnetic flux through a wire loop increases according to the relation DB = 4.0f² + 3.0t, where…

A: Given, The magnetic flux through a wire, ϕB=4.0t2+3.0t mWb Time, t=1.5 s

Q: ww C R www is 7.5 mH 12 Q2 Z ?For the circuit shown above, what is the maximum average power that…

A:

Q: :An industrial heater has a nameplate that reads Vrms 219 Hz 50 kVA 106 lagging 0.82 ?What is the…

A: Brief description:  For the above given question we need to calculate the value of reactive power.…

Q: VT= 10 V A R₁ 150 $2 R₂ 15 $2 R3 1052 B + Lo

A:

Q: 5. Find the input impedance at 20 krad/s for the circuit shown in Figure 4. 3 mH 200 £2 m vooo 0.592…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one. 5) In this…

Q: 2. Solve for I for the circuit shown in Figure 2. 0.4.គ -N V -j0.8 ព ↓1 16/45°v ខ្ទី... | Figure 2…

A:

Q: 15 The unit of current is: (a) coulomb (c) volt (b) ampere (d) joule

A: Brief description: For the above question we need to find SI unit of current.

Q: What are the main limiting factors to battery improvements?

A: Battery improvement

Q: 2. Let X[k] be the DFT of x[n] = {0, 1, 2, 3, 2, 1, 0, 0). (c) For Z[k] =(-1) X[k], obtain the…

A: Let X(k) be the DFT of x[n]=(0,1,2,3,2,1,0,0} For Z(k)=(-1)kX(k) , we need to obtain the inverse DFT…

Q: Q3 : for figure 1, find Vo? Determine the voltage V, in the circuit of Fig. 1 j1Ω 2 Ω 6/90° V I j4Ω…

A: In this question,  We need to determine the voltage Vo as shown the circuit?  We are solving this…

Q: Q1: Simplify the block diagram shown in Fig. (1). then obtain the closed-loop transfer functions…

A:

Q: (a) Calculate the phaser current I and I 2 in the circuit of figure 4.

A: Note :- As both questions are not inter-linked. So as per the guidelines we are supposed to answer…

Q: A 397-Vrms, 60-Hz supply serves a load that is 10 kW (resistive), 5 kVAR (capacitive), and 15 kVAR…

A:

Q: Delta-Star Power Transformer 22kV 0.4 kV, Current on 0.4kV side is 1500A CTs on 0.4 kV have ratio of…

A: Given that a delta star 22/0.4kV power transformer. Given CT ratio on 0.4 kV side = 500:1 Current on…

Q: A 3-phase 440V, wye connected induction motor has a star-connected stator and delta connected rotor…

A:

Q: Find I, & Iz₂ using 7010° mesh analysis. jio -j20 F2 I, 1514 40 190

A:

Q: Draw mechanical equivalent Electrical system for the following mechanical translational system using…

A: Given mechanical translational system with masses M1 and M2 along with a force input P on mass M1.…

Q: For the common base circuit shown, determine IC and VCB. Assume the transistor to be of silicon. RE…

A: It is given that: RE=1.5 kΩ RC=1.2 kΩ VEE=8 VVCE=18 V

Q: Q13. Which of the following is the main disadvantage of using con (a) Poor performance at high…

A: There are the few questions related to the harmonics their generation ,how to control or eliminate…

Q: (a) Why in an AC transistor amplifier is it important to AC couple the input and output?

A: Transistor amplifier- It is a condition in which a transistor works as amplifier and used to…

Q: Consider the following three Phase balanced circuit 210200 Vrms jasn 210/120° Vrms 24-321 jost -+…

A: In three phase balanced circuit the phase angles differ from each other by 120 degrees.  Three-phase…

Q: A 3-phase 440V, wye connected induction motor has a star-connected stator and delta connected rotor…

A:

Q: Let the parallel current sheets be as in Figure 7.14. Also let H = H₂ + H₂ where H, and H, are the…

A:

Q: Q2 Compute the convolution x(n) of the signals x₁ (n)= (1, -2, 1} x₂ (n) = {} 1, 0≤n≤5 0, elsewhere

A:

Q: Q3: Find hybrid_parameters for the network in figure re ΤΩ ΖΩ Figure 2 ΖΩ ΤΩ 141, 228

A:

Q: Q2// Find the current at 10 2 by using thevenin's theorem? 292 122 10v +₁+ 592 VIL 1092 +₁+ 20v

A:

Q: Q1- For the sinusoidal waveform in Fig. 1: a. What is the peak value? b. What is the instantaneous…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The switch in Fig.4, has been in position a for a long time. At t=0, it moves to position t…

A: In this question,  We need to determine the current in the capacitor C as shown the circuit?  We…

Q: Four point charges each of 10 μC are placed in free space at the points (1, 0, 0), (−1, 0, 0), (0,…

A: Given 4 point charges each of 10 μC are placed in free space at the points (1, 0, 0), (−1, 0, 0),…

Q: PROBLEM: Manually plot the root locus Number of branches Number of asymptotes Asymptote real axis…

A:

Q: answer A three-phase motor, Y connection, 380-V, 100-kW, 110- kVA, 50 Hz Design a band pass filter…

A:

Q: . Find i(t) for t>0 if the circuit is in steady state at t = 0 t=0 10 mF 10 A 40 60 4H t=0

A:

Q: At an electrical rotor position of 7/2, the flux linkage equations of a 2-phase machine are 2ab =…

A: Given λab =2005 iab and Ksr  =0-110

Q: Specify the LM-series linear regulator required to regulate a fixed voltage of -9 V. Please write…

A: To specify the LM series linear regulator required to regulate a fixed voltage of -9 V

Q: PROBLEM: in plotting root locus, find the break-away/break-in point is/are. R(S) + K s(s+ 1)(s² + 4s…

A:

Q: An audio power amplifier delivers a 30 volt RMS 1 kHz sine to a loudspeaker. If the loudspeaker…

A: Given data, RMS voltage Vr=20 V Impedance is given Z=7∠450

Q: Use Norton to solve for the current and voltage at 10 ohm resistor. 1 20 Ω 2 Μ 10 Ω 3 120 V 30 Ω 40…

A:

Q: Q1: Choose one of the choices indicated in the parentheses such as the following sentences have a…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q1// Find I1, I2 & 13? Where Ri= 1022, R₂-40N & R3-2092 Vi=10v & v₂=20v R₁ V₁ R₂ R3 + V₂

A: In this question we will find unknown currents through resistances....

Q: 2i 0.5 Ω ΜΑ 120 ΜΗ Figure 6 20 μF

A: Brief description: In the above given question they have mentioned a parallel combination circuit…

Q: Solve for the power of each individual resistors. 12 V 5 A 20 V + 20 V Io + 8 V 3 A 3 A

A:

Q: A three-phase balanced source voltages, operating with a 380 -V line voltage as shown in Fig. 1.…

A: Assumptions in Electrical circuits analysis  Inductor absorb reactive power and considerd as…

Q: (b) A first order low-pass RC filter circuit as shown in Figure P3(b) is fed with an input voltage…

A:

Q: Problem 3. A coaxial cable has an inner core radius of 0.5 mm and an outer conductor of internal…

A: Given a coaxial cable having, Inner core radius, a = 0.5 mm Outer core radius, b = 6 mm Dielectric…

Q: Determine the following for the network shown below: Use Mathematical Approach a. ID b. VGS c. VDS…

A:

Q: 7 calculate the t-parameters of the passive 2-port in figure 2. 12 M V₂ V₁ 10Ω. 2092 www 592

A: Brief description: For the above given 2 port network we need to calculate the value of transmission…

Q: For the circiut shown, R = 500 2, C=3.0 µF, L=6.5 H and V200 V. The resonance frequency oo for the…

A: Given, R=500 ΩC=3.0 μFL=6.5 HVm=200 V

Q: .For the following voltage and current phasors, calculate the apparent power in VA V = 191 4 230…

A:

Q: Design a buck-boost converter to supply a load of 75 W at 50 V from a 40-V source. The output ripple…

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.