PROBLEMS : 1. The IR drop in the line due to the reactive current is one disadvantage of low power factor loads. Name some other reasons why low power factor loads are undesirable. VII.

Q: 1-transfer function of DC Series motor 2-block diagram of DC Series motors.

A: DC series motor : DC series motor is a set of self-excited DC vehicles wherein the sphere coil is…

Q: (s + 1) 100 s² + 110s + 1000 A) Find the factors of Bode stander transfer function? B) For each…

A:

Q: A 500-Ω R is in parallel with 300-Ω XL with 500V. Find IT, pf, ZT.

A:

Q: A 1 mA meter movement with internal resistance of 100 ohm, is to be converted into a 0 -100 mA…

A: given 1 mA meter movement with internal resistance of 100 ohms , is to be converted into a 0-100 mA…

Q: What is the equivalent transfer function of the following block diagram? R(S) 1 C(s)

A:

Q: Q21) Find the value of R, if 1,3A Rx Www 562 www 502 www E-24 V 1pm 3A

A:

Q: Electrical Engineering The sinusoidal signal x(t)=4sin(2π t) is transmitted using a 4-bit binary PCM…

A:

Q: Q2: Air flows out of a nozzle straight up 30 m. What is ?nozzle velocity exit

A: Given data, Height is given h = 30 m Final velocity v = 0 m/sec Let initial velocity is u…

Q: becomes to analyze electronics circuits. a. Not all the time b. True c. False d. In some cases only…

A: There are few questions related to the basic understanding of microwave amplifier and it's basic…

Q: Question (3) In the circuit shown below, e(t) = √2 100 sin 40t volts. Find out: d) The total circuit…

A:

Q: For a negative unity feedback system, using Routh-Hurwitz criterion for stability, determine the…

A:

Q: b) x(t)= etu(-t) , h(t)= 8(t) > c(t) h(t) y(t)

A: b ) To find output y(t) of a system with given  Input x(t) and system transfer function h(t)

Q: Q1) Two conducting cylindrical surfaces are located at p = a and p = b, and both of length L. A…

A: The direction of electric field will be in   same direction as of current density.  We know that-

Q: 021) Find the value of R, if 1,-3A Rx www 502 562 www E-24 V 1g 3A

A: In this question,  We need to determine the value of resistance Rx if current flow in this branch is…

Q: Calculate the average Baud rate if the bit rate is 100 Mbps

A: Given Bit Rate Rb =100Mbps

Q: (Q14) An RC phase shift oscillator using Op-Amp is shown. Given the value the electric resistance…

A:

Q: 1. Referring to Figure 1, design a circuit that will achieve the same output Y by only using NOR…

A: The solution is

Q: 1 Three infinite current sheet K₁ -10 az at x = 2 Find -60 äz at x = 7 and K 2 = 20 az at x = 5 and…

A: We need to find out the magnetic field for given current distribution .

Q: please solve step by step Please solve for the currents across each impedance using Superposition.…

A: Using superposition theorem calculation of current across each impedance.   According to…

Q: What is the value of Vout? b. What is the voltage gain?

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Iq=0.8 m/ RB Vs Re -5√ cus B=100 Ry=10ka a) re b) Bi, zo, AV, Ais A₁ + Vo FL Z Rc = 4 ka

A:

Q: Problem 2: Design a circuit that has three input signals A, B, and C and one output F.  The output…

A:

Q: npn -24 - عند استخدام تـرانـزسـتـور npn transistor was used as a current كمكبـر لـلـتـيـار فـإذا…

A: Given, A NPN transistor is being used as a current amplifier. Base current, IB=1 mA Current gain,…

Q: please explain with fully details

A:

Q: R(S) + K C(s) s(s+7) (A) Find the overall transfer function (B) For what values of K, the system…

A: In this question,  We need to determine the overall transfer function?  We know closer loop transfer…

Q: Two impedances given by z₁ = (10+ j5) and z₂ = (8 + j6) are joined in parallel and connected across…

A:

Q: Find vo 12 v +1 by using node analysis 12KM VB VA VC vosoka бке 6 v 3 кл

A: In this question,  We need to determine the voltage Vo as shown the circuit using the nodal…

Q: An RLC resonant circuit has a resonance frequency of 1.5 MHz and bandwidth of 10 kHz. If C = 150 pF,…

A: Given, An RLC resonant circuit has, Resonance frequency, fo=1.5 MHz Bandwidth, B.W.=10 kHz…

Q: 5. The simplified form of the Boolean expression a'bc + abc' + abc + a'bc' is: a. ab + bc + a'bc' b.…

A: Given expression is, a'bc+abc'+abc+a'bc' Taking bc common from 1st and 3rd term and bc' from 2nd and…

Q: Answer the following wuth illustration and solutions. 1.) A second-order band pass filter is to be…

A: Given data, Lower frequency fL=500 Hz Higher frequency fH=1.5 kHz = 1500 Hz Value of resistance R= 1…

Q: At w = 4000, the system H(s) = 10000*((s+100)(s+100))/((s+10000)(s+10000)) has a gain of: O A. 76 dB…

A: This question belongs to control system . It is based on the concept of calculation of gain of the…

Q: A full wave rectifier circuit is given with peak output voltage Vy =15 V, R=10 kN, C= 50 µF, T…

A: For the full-wave rectifier, the ripple voltage is given by the expression as shown below:…

Q: Consider the circuit shown in Figure 2. The transistor parameters are ß= 100 and VA = 100 V.…

A:

Q: A die ectric-filled parallel-plate capacitor has plate area A-10.0 cm, plate separation d-6.00 mm…

A: Given: A dielectric filled parallel plate capacitor, Area of plate, A=10.0 cm2 Plate separation,…

Q: VBB 3V (b) RB Μ 27 ΚΩ Rc 390 Ω Bbc = 125 Vcc 8 V

A:

Q: A 40 hp, 230-V, 8 pole , 25-Hz three phase induction motor is running at 355 rpm at rated load. The…

A:

Q: -v(t)-i(t) 1.5 -1 -0.5 0.002 0.004 0.006 0.008 0.01 0.012 0.014 0.015 0.018 0.02 0022 0.024 0.026…

A: Given data, Voltage vs current graph is given as,

Q: 35. If the peak amplitude of a low-pass filter output is 5V, what voltage will correspond to the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: What are the transistor fabrication techniques, process of fabrication, structure.

A: According to the question, we need to discuss the transistor fabrication techniques, the process of…

Q: What is the induced voltage Vs in the transformer, if the primary voltage Vp-220 V with number of…

A: Given, Primary voltage, Vp=220 V Number of primary turns, Np=50 Number of secondary turns, Ns=10

Q: Direct transmission of message signal without modulation can be cause. Problems Noise Fading…

A: These are the few questions related to the understanding of basic modulation techniques and their…

Q: Find The Z Parameters for the circuit shown

A: It is given that:

Q: Experiment 1 1. Define E-I characteristics of a solar module. 2. Explain the use of potentiometer in…

A: Solar Panel A Solar panel or a solar module is the assembly of a photovoltaic cell that is mounted…

Q: A circuit consists of a battery connected to three resistors (65 , 30 , and 180 2) in parallel. The…

A: Given, The three parallel connected resistors are R1=65 ΩR2=30 ΩR3=180 Ω Total current, I=2.7 A

Q: Q2j Consider the function: (s) = 1−e-T² S X(s) = Show that s = 0 is not a pole of X(s).

A:

Q: 2) From the given digram of inductance comparison bridge circuit, determine the value of Rx and Lx…

A:

Q: 8. Compute the output impedance of the circuits shown in Figure. Vcc J 마 Rc ORcllro Rc Q1 = Rout

A:

Q: 1:2 Di Silicon 24Vp D₂N Silicon RL=2.2 k Analyze the circuit using any circuit analysis method to…

A:

Q: The power consumed by a coil is 300 W when connected to a 30 V dc source and 108 W when connected to…

A: Given, Power consumed by a coil when connected to 30 V DC supply, Pdc=300 W Power consumed by a coil…

Q: For the network of Fig.1, with bypassed capacitance (CE), determine the re equivalent model circuit…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.