Answered: Provide your complete solution and…

Provide your complete solution and formula. Sample Problem: [ EE Board October 1999 | The instantaneous voltage of a single phase generator is given by the equation 300 sinwt. What is the ms voltage?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.32MCQ: While the instantaneous electric power delivered by a single-phase generator under balanced...

See similar textbooks

Related questions

Q: Explain the types of generator used in wind turbines with a neat diagram and also discuss the grid c...

A: Wind turbine- A wind turbine is a mechanical device that converts the energy contained by the moving...

Q: 1. An emf of 9.7mV is induced in a coil while the current in a nearby coil is decreasing at a rate o...

A: We need to find out mutual inductance for given induced voltage

Q: 2. What is the process of converting a signal from a given rate to a different rate?

A: In this case, from the given options, the correct option corresponding to the process of converting ...

Q: Four electricians are discussing wiring under raised floors in information technology equipment room...

A: "Control" for the disconnecting means should be gathered, labelled, and placed near the main exit do...

Q: 120 20 Inad" 120 (e)

Q: (ii) Find the magnitude and direction of the unknown currents in figure 3. Given il = 10A, i2 = 6A, ...

Q: 3. A fine-grain aluminum wire (grain size is 0.2um) is thermocompressively bonded to aluminum thin f...

A: Electromigration- The term electromigration is define as the movement of atoms with in the material ...

Q: Given the points A(x=2, y=3, z=-1) and B(p = 4, 0 = -50°, z = 2), find a unit vector in cylindrical ...

A: Given points are,Ax=2, y=3, z=-1andBρ=4, ϕ=-50°, z=2

Q: Determine the thermal noise voltage for a component operating at -60 °C having a bandwidth of 50 kHz...

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

Q: 4. When two coils having inductances of 5H and 4H respectively were wound uniformly onto a non-magne...

A: coefficient of coupling = mutual inductance bateween two coilproduct of inductance of the two coils...

Q: 5. An iron core 0.4m long and 5 cm?. In cross section, is wound with 300 turns. Wh current of 0.5 A ...

Q: Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6| B = |0| and C =[10 5 1] ...

A: Given a system defined by x˙=Ax+Buy=Cx where, A=010001-6-11-6B=101C=1051

Q: 5. The following figure shows the eight-bit Adder-Subtractor. Your inputs for this combinational cir...

Q: 1 out of 3 attemp Find the bandwidth and center frequency of the bandstop filter of the figure. Roun...

A: Given circuit,

Q: 1. Sketch the waveform of vo. Indicate the maximum and minimum values. 10 Vy

A: Given circuit GivenVi=10VE=4V

Q: An electric kettle working at 220 V heats upto 2 liters of water from 20 °C to 100 °C in 2 minutes. ...

Q: Given three impedances Z1= 10+j0, Z2= 3+j4 and Z3= 8-j6. Impedance Z2 and Z3 are connected in parall...

Q: Find thevenin's equivalent with respect to terminal "ab

A: This question belongs to electrical circuit theory . It is based on the concept of Thevenin's theore...

Q: Calculate lo using nodal analysis.

Q: A ring having a cross-sectional area of 500 mm?, a circumference of 400 mm and D=800microWb has a co...

A: Given, Cross sectional area, A=500 mm2 Circumference, l=400 mm Flux, ϕ=800 μWb Turns, N=200 Relative...

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

A: We need to choose one of the following option for the given Question. The process of converting a s...

Q: Use superposition to find the voltage v in the circuit shown. ЗА 10Ω ww www + V - 40 V 10 Ω 2V,

A: In this question we will find voltage across 8 ohm using superposition theorem.... Superperposition ...

Q: Find the xoltage acrass Si Si 10e L.

Q: resultant voltage

A: Conversion of sin and cos- cosθ=sinθ+π2sinθ=-cosθ+π2 Polar to rectangular form- r∠θ=x-yjwhere,x=rcos...

Q: At T 400K, what the concentration of free electrons / holes in intrinsic silicon? 1.5x1010/cm3 5.16x...

Q: Consider an input x[n] and a unit impulse response h[n] of a discrete-time LTI system given by: h[n]...

Q: If your cellphone camera needs at least 1000 photons per second to detect light of wavelength 502 nm...

A: Given Number of photons n=1000wavelength λ=502 nmc=2.998×1018 m/sh=6.626×10-34 J.s

Q: A 60 Hz sinusoidal voltage v = 141sinwt is applied to a series RL circuit. The values of the resista...

Q: 2. Draw and explain the difference between clipper circuit and clamper circuit output waveform

Q: 100(2+ jw) (4+ ja) (5+jw) The standard form of the transfer function H = is 100 (1+ jw/2) A H=- (1+j...

A: Brief description : Transfer function is defined as it is the ratio of Laplace transform of the outp...

Q: 3.. A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter be...

A: self inductance of the coil = number of turns2×permebility×area of the coremean length of the core. ...

Q: shunt-wound motor runs at 600 r.p.m from a 230 V supply when taking a line current of 50 A. its arma...

A: In this question we will solve questions related to DC shunt wound motor ....In first part we will f...

Q: Homework: 10 2 6 V 42 8 V us F1)

Q: A generating station has a demand of 25 MW, a load factor of 60%, then the average demand will be:

A: Given: A generating station has, Maximum demand = 25 MW Load factor = 60 % Average demand =?

Q: a) Draw nominal - T model of Transmission Line. b) Write ABCD Parameters of the nominal T m...

A: Solve the problem

Q: 3.. A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter be...

A: Given:N=1000A=4 cm2 or 4×10-4 m2d=20 cm or .2 m

Q: 23 W compact fluorescent lamp (equivalent to a 100 W incandescent lamp) remains lit for 12 hr a day ...

Q: (1) Three point charges lie along a straight line as shown in the figure, where q, = 6.00 uC, q2 = 1...

A: We have given Three point charges lie along a straight lineq1=6.00μCq2=1.50μCq3=-2.00μCThe separati...

Q: In a communications system, trhe ideal value of noise figure is a.0 b.1 c. 1 dB d.infinity

A: Consider the noise figure define the performance of the radio frequency system. The noise figure als...

Q: A 240 V, 50 Hz single-phase motor takes a current of 8 A at a PF of 0.65 lagging. Determine the valu...

Q: In a third system a motor controller has an input of 8.88 V with a current of 0.696 A. The controlle...

A: Efficiency = output power/input power But power = voltage × current

Q: Five identical circuits having 20 dB S/N ratio each are connected in tandem with each other. What is...

A: The solution is given below

Q: 1. How does speaker convert electrical energy to sound energy? 2. How does microphone convert elect...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: A coil has a resistance of 4 ohms and an inductance of 2H. It is connected to a 20V dc supply. Calcu...

A: Given: A coil have Resistance, R=4 Ω Inductance, L=2 H Supply V=20 V dc

Q: P3.1 The unit step response of a certain system is given by c(t) =1+e -e-2", 120 (a) Determine the i...

A: It is given that: ct=1+e-t-2e-2t , t≥0

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in...

A: Consider by the enthalpy of fusing the energy required to transform the solid water to water is 333....

Q: 7. Two inductors whose self-inductances are given as 75mH and 55mH respectively, are positioned next...

A: Mutual Inductance- The term mutual inductance refer to the interaction between the magnetic field of...

Q: Given the full-wave rectifier circuit shown below and given that the diode is made up of Silicon and...

A: According to Bartleby guidelines we are supposed to solve the first 3 subparts at a time kindly repo...

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

Provide your complete solution and formula.
Sample Problem: [ EE Board October. 1999 |
The instantaneous voltage of a single phase generator is
given by the equation 300 sinwt. What is the rms
voltage?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
The total instantaneous power absorbed by a three-phase motor (under balanced steady-state conditions) as well as a balanced three-phase impedance load is (a) A constant (b) A function of time
The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1460 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 3.7473 5.2280 8.0815 7.1534 1.2558 4.3763 2.6455 6.3414
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly?
For single phase ac voltage controller, R=15ohm, f=50Hz and Vrms=230V and α=0,82 rad. Calculate the rms load voltage (V). In this question, take 2 digits after the comma and take pi = 3,14; enter your answer into the system in terms of the desired unit only as a number.solve the question by using the rules of power electronics
What is the alternators terminal phase voltage at shorted load condition? Explainand justify your answer in one(1) sentence.Use IA as the reference phasor.
three phase star connected alternator is rated at 1600kVA, 13500V. The armature resistance and synchronous reactance are 1.5 ohm and 30 ohm respectively per phase. Calculate the percentcage regulation for a load of a 1300 kW at leading power factor.
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?
A 1 MVA, 11 kV, three phase wye connected synchronous generator has a synchronous reactance of 5 ohms and a negligible resistance per phase. At a certain field current the generator deliver rated load at 0.9 power factor lagging. Calculate the per phase voltage generated by the alternator.