Answered: Q/ Compute the pull force (F) on the…

Name: Q/ Compute the pull force (F)on the rope exerted by theman to hold th
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Q/ Compute the pull force (F)on the rope exerted by theman to hold the crate in theposition shown. Alsocalculate the tension (T) in theupper rope.5 m01.5mO30°200 kg

Engineering

Mechanical Engineering

Q/ Compute the pull force (F) on the rope exerted by the man to hold the crate in the position shown. Also calculate the tension (T) in the upper rope. 5 m 1.5 m 30° 200 kg

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.67P: The cable AB supports a uniformly distributed load of 12 lb/ft. Determine the angles A and B, and...

See similar textbooks

Similar questions

The cable AB supports a uniformly distributed load of 12 lb/ft. Determine the angles A and B, and the cable tension at A.
The 110-lb traffic light is suspended from two identical cables AB and BC, each weighing 0.80 lb/ft. If the maximum allowable horizontal force exerted by a cable on a vertical post is 170 lb, determine the shortest possible length of each cable and the corresponding vertical distance h.
The 15-m-long cable supports the loads W1 and W2 as shown. Find the ratio W1/W2 for which the segment BC will be horizontal; that is, 2=0.
The tensions in the cable at points O and B are TO=1200N and TB=1800N. Determine the weight W of the cable.
Q1) Find the force F on the bottom of the tank if : K=1.5 m , H= 6 m, D=5 m.
The figure shows the normal force on a jumping person as measured using a force table. A: From the graph, determine the weight of the jumping person. B: What is the maximum net force on the jumping person during the jump phase? C: Approximate the average net force during the jumping phase.
A person is pushing on a handrail at an 80° direction, with a load of 150 lbs. Determine the x and y components of the force on the handrail.
A cable is subjected to the following concentrated forces. Determine the following: 1.1 The force P needed to hold the cable in the position shown, i.e., so segment BC remains horizontal is ___________ kN. 1.2 The sag yB is equal to _________ m. 1.3 The maximum tension in the cable is __________ kN.
Show the fbd/figure, given and formula used. The engine of a motorboat delivers 40 hp to the propeller while the boat is moving at 10m/s. What would be the tension in the towline if the boat were being towed at the same time?
1. Samer (ms = 75 kg) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on each side of the seat. (You may assume the seat has negligible mass.) A. Determine the tension in each cable due to Samer sitting on the swing seat. B. Given each cable has a diameter of 1 mm and each cable is exactly 5 m long before Samer sits on the seat, determine the length of each cable when Samer is sitting on the seat. (The cables are made of Aluminum for which Y = 70 GN/m°.) show all work in logical, detailed form and box in numerical answers. Include a diagram wherever possible. On any problem where an FBD is appropriate, it must be included for maximum credit. All numerical results should be stated to 3.00 or 4.000 significant figures and in mks units unless otherwise noted.
A block on an inclined plane at 43 degrees has a weight of 100 lb if fs = 0.50 and fk = 0.30, what force P directed up the plane will move the block with constant speed (a) up the plane (b) down the plane? Show full solution and FBD.
1. If the mass of cylinder CC is 50 kg, determine the mass of cylinder AA in order to hold the assembly in the position shown 2. If an astronaut has a mass of 180 LBM on earth, what is the weight of this astronaut on the moon, where g=5.32 ft/s2?