Answered: Q/ plot in time domain and double sided…

Q/ plot in time domain and double sided amplitude spectrum of the signal shown in below figure x(1) a) When t -0 b) When t- 0 What do you conclude?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 3. Draw the signal in time domain and frequency domain. Discuss the information obtained from two…

A: A frequency-domain graph illustrates how much of a signal is contained inside each particular…

Q: Consider the signal given as:

A: Given, Impulse signal, ht=e-tut We know that- Transfer function, TF= Laplace transform of impulse…

Q: Suppose a signal q = 0.01sin(50t) - 0.02cos(50t – 0.37). (a) Write the signal q in complex…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: x(n)=4+4*u(n-10) Calculate the average power of the discrete-time signal defined as ?

Q: EX: Find the exponential then find the trigenemetric form. f(t). F.S of the signal shawn belowy

A: It is given that:

Q: (b) The power spectral density of an additive, stationary and Gaussian noise is represented by the…

Q: a) Find graphically the measured apparent frequency b) Draw the frequency spectrum before and after…

A: Given: E=3sin(400πt)fs=150Hz

Q: discrete periodic time signal is given by X (n)=Sin 1-what is the 2 what is the Largest positive or…

A: According to the question, for the given discrete-time signal as shown below xn=sin2πn1024 we need…

Q: Take the periodic signal with period 3 given as x(n) = {0, −6, 12}, and find its FS coefficients.…

A: Given a periodic signal with period 3 given as: x(n)={0,-6,12}. We need to find its Fourier Series…

Q: An FM signal has an intelligence frequency of 5 kHz and a maximum deviation of 20 kHz. How many…

A: Given: Intelligence frequency =5kHz Maximum deviation of =20 kHz

Q: Q2/ If the modulating signal given by m(t)=2cos(2n10t)+3cos(2n30t), and the carrier signal given by…

A: Given data, m(t)=2cos(2π10t)+3cos(2π30t)and c(t)=5cos(2π500t)

Q: Let the pulse be triangular of height 20 mv and width 1.0 ms. Find SNR at the T-1 ms if noise is…

Q: Determine the time domain signal x(t) using its magnitude and phase spectrum given in the figure…

Q: If an experiment uses a pressure transducer that collects samples at 1000HZ, what is the highest…

Q: If a digital signal has 4 levels find out the number of carrier frequencies required to modulate the…

A: We have given If a digital signal has 4 levels find out the number of carrier frequencies required…

Q: A- Categorize the signal x(n)-{..,0,0,2,-1, 7,3,6.5,4,-8,0,0,...) as: I- Deterministic or random…

Q: Sketch the single-sided and double-sided spectra of

Q: (b) If the 9-point sequence x[n] represents a time-domain signal sampled at 3 kHz, what frequency…

A: Time domain signal is represent the according to time ,signal is change . and frequency domain…

Q: An AM radio station transmits a signal consisting of a carrier wave at frequency vc = 106 Hz. If we…

Q: 1. A telephone channel using copper wires can be modeled by a simple RC filter. Sketch a circuit…

A: Given that telephone channel using copper wires modelled as simple RC filter, the channel is shown…

Q: The following figure shows the density function of the signal spectrum g (t). A) What is the average…

A: We need to calculate power of given power spectral density. We also need calculate the auto…

Q: 8. Consider a filter with the frequency response H(w) = e-a (a) Show that this filter is physically…

Q: Consider a continuous-time sinusoidal signal xa(t)=3sin(100πt), is sampled at a rate of 300 samples…

Q: By viewing a signal in the frequency domain you can determine which of the following: a. the…

A: By viewing a signal in the frequency domain you can determine which of the following:

Q: aling O) An ssB-AM Signal is generatedl by madulabing an 800 KHz Carrier by the signal m(t) = a Cos…

A: An SSB-AM signal is generated by modulating an 800 kHz carrier by the signal…

Q: 12. Noise generated by an amplifier of radio is an example for? a) Discrete signal b) Deterministic…

A: Noise generated by an amplifier of radio is an example for

Q: 2Suppose you have the following information signal i(t) = 4sin(4000nt + %3D 90) modulates with the…

A: We will find frequency modulated signal and bandwidth for frequency modulation.

Q: Consider a circuit described by a frequency response represented by the red dotted line in the…

A: Given vin(t)=3cos2π×10t We know that Gain=V°Vin Gaindb=20log Gain Le xt=Hjω ⇒y(t)=AHjωosinjωot+Hjωo…

Q: If a signal's frequency spectrum has only discrete components ranging from 0 to infinite. What the…

A: Discrete components which are containing a single component or may be two components in some cases…

Q: Multiplication of a signal in the time domain with a cos function will result in a) conversion of a…

A: Multiplication of a signal in the time domain with a cos function will result in

Q: The DSB-SC modulated signal is given as u (t) = 100m (t) cos2πfct and the carrier frequency is 1MHz.…

A: As per our policy we can provide solution of first three questions only As we have given: ut=100…

Q: [3] x(t) is a continuous time (CT), Periodic signal, with a period T. The equation for a single…

A: The Fourier series expansion is determined by the following expression, xt=a02+∑n=1∞ancosnt+bnsinnt…

Q: When the lower sideband components of the Double Sideband (DSB) signal whose spectrum is given in…

Q: If we can hear sounds whose amplitude goes from 1 to 1 million in steps of one. With how many bits…

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other…

Q: A carrier signal is amplitude modulated by a sinusoid. The resulting AM equation is: VAM =…

A: Note: As per the guide lines of the bartleby we are supposed to solve 3 questions, when they are…

Q: Q/ plot in time domain and double sided amplitude spectrum of the signal shown in below figure x(1)…

Q: Q1: For the following system: 3 G(s) : %3D s2 +s+4 Find the response for: 1-Sinusoidal signal input…

A: "According to company's policy we can answer only the first three sub-parts of a given question, if…

Q: c) The waveform shown in Figure 1c is passed into an Ideal Low Pass Filter (ILPF) which has a…

A: The frequency response of an ideal low-pass filter is a rectangular function, and it is a brick-wall…

Q: Show that for a periodic signal with x,(t + T/2) = x,(1), the odd harmonics are zero and the even…

A: Given that Period ic signal

Q: Which of the following signals is formed when the lower sideband component of the Double Sideband…

Q: A signal x(t), bandlimited to 10 Hz, is sampled at 12 samples/s. what portion of its spectrum can…

A: Given data, Bandlimited frequency fm = 10 Hz Sampling frequency fs=12 Samples/sec

Q: 1-)Examine the graphs of the DSB (t) and VSB (t) signals in the time space. What are the…

A: According to the question, we need to find (a) the difference between DSB and VSB? (b) How many…

Q: Еxample.5: A carrier wave is frequency modulated using a sinusoidal signal of frequency fm and…

Q: Question 23 When calculating the voltage of an FFT peak of a sinusoidal signal, would it match the…

A: Frequency response represents how the output gain or phase responds for a single frequency over a…

Q: For the periodic input signal defined by the attached graph: a) Plot the output signal for two…

A: Given C=0.22μFR=56.2kΩVk=0.7VPIV=50VE=9V The characteristic time for the capacitor is…

Q: Q1: For the signal G(), shown in figure beside. Find Inverse Fourier Transform g(t)

A: Bartleby has policy to solve only first question and incase if it has subparts then solve only first…

Question

Q/ plot in time domain and double sided amplitude spectrum of the signal
shown in below figure
x(t)
a)
When t - 0
b)
When t - co
What do you conclude?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Different Types of System and Its Property

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Define a truncated sinusoid function. Use fs=100 Hz for time 0 to 10. From time 0 to 5 define a sinusoid of frequency 1 Hz. After that the signal should be 0. Plot this. Compute the FFT of this signal using N points (N=length of signal) and plot the magnitude of the first 100 frequencies along with the correct frequencies (scale n/N by fs). Can you identify the primary frequency of your signal from this plot? Are there other frequencies and why or why not? Repeat this analysis using 10N points in the FFT (and plot 10x as many frequencies so you have the same range shown). What did this do to the DFT and to your resulting magnitudes.
What is the frequency response? What is the expression for the magnitude of the frequency response, could you also sketch it? ..
Explain Frequency Modulation (FM), Amplitude Modulation and Phase Modulation (PM) signal in time domain, frequency domain. Answer in paragraph form
a) Explain the drawing rules and formulas of the Nyquist curve. b) G(?)=K [(S−1)(S−2) / (S+2)(S+3)] ; Construct nyquist curves for K=1, 5/3, 9 values. Write down the Nyquist stability criterion and explain whether the system is stable or not. c) Define the gain and phase margin, this time on the nyquist curve.
An FM radio broadcast used a modulator with a frequency deviation sensitivity of 5KHz/V, a 2Vp – 10 kHz modulating signal, and a 10Vp – 88MHz carrier Signal , determine : (a) Actual minimum bandwidth from the Bessel function table in kHz (b) Appropriate minimum bandwidth using Carson’s rule in kHz (c) Percent Modulation (d) The FM modulated waveform carrier and significant sideband components amplitudes; NOTE: Use this format in providing your answers to this problem: VJ0=x.xx v,VJ1=x.xx v,VJn=x.xx v; where VJO is the modulated carrier amplitude, VJ1-VJn is the amplitudes in significant sideband components and the number of sidebands (n) depending on your computation. (e) The unmodulated carrier power (W) for the FM modulator assumes that the load resistance is 50 Ω f) The corresponding FM modulated waveform carrier and significant sideband components power and its total power in mW. Note: Use this format in providing your answers to this problem: PJ0=xxx.xx mW,PJ1=xxx.xx…
(can you solve it fast?) Which ones are correct about Nyquist's Theorem in sampling? I. Relates the conditions on the time and frequency planes ii. Helps quantize iii. They determine the bandwidth requirement iv. Returns the spectrum of the sign
An FM radio broadcast used a modulator with a frequency deviation sensitivity of 5KHz/V, a 2Vp – 10 kHz modulating signal, and a 10Vp – 88MHz carrier Signal , determine. Use this Bessel table below to solve this problem. (a) Actual minimum bandwidth from the Bessel function table in kHz
What is the difference between classical or frequency domain and modern or time domain? And give an example for each domain.
Let's say you have an input signal coming in mixed with a high frequency noise so that Vin(t) = sin0.3t+3cos31t. The signal to noise ratio is currently 1/3. A LPF with cutoff frequency at 0.6 Hz is chosen. What is the output signal to noise ratio? Use asymptotic approximations. Keep three significant figures.
A random signal with a random phase is given as in the following. The phase has a uniform distribution. Computecorrelation function and power spectral density of the random variable X (t).
Determine the time domain signal x(t) using its magnitude and phasespectrum given in the figure below.
What is the difference between classical or frequency domain and modern or time domain? And give an REAL LIFE example for each domain.