Q/ Twenty four voice signals are sampled uniformly and then time division multiplexed. The highest frequency component for each voice signal is 3.4 kHz. If the signal is pulse amplitude modulated using Nyquist rate sampling, what is the minimum channel bandwidth required, and .what is the signaling rate

Q/ Twenty four voice signals are sampled uniformly and then time division multiplexed. The highest frequency component for each voice signal is 3.4 kHz. If the signal is pulse amplitude modulated using Nyquist rate sampling, what is the minimum channel bandwidth required, and .what is the signaling rate

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Similar questions

Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?
draw the spectrum ideal Sampling and Natured Sampling??
In the figure below, an x(t) signal varying between +- 1.6 V is split into 8 quanta levels and converted to a digital signal. being converted. a) Calculate the quantization gap voltage (step)? b) Draw the PAM, PCM and ASK outputs in this conversion process? c) Calculate bit transmission rate if sampling pulse frequency ?? = 2kHz.
What is the "Nyquist-Shannon sampling theorem," and how does it impact digital data transmission?
For a user signal with maximum frequency 20KHz: What must be the proportionality constant Kf and the modulation index β for the maximum FM modulated signal bandwidth to be 200 KHz, if the maximum signal amplitude is 2 volts? What is your standard deviation in Hz? Calculate modulated signal strength
What is the main disadvantage of linear delta modulation? What is the solution for this problem? this question from digital communication course.
Fora standard SSBSC carrier AM, the peak unmodulated carrier peak voltage is 10 V for a load resistance of 10 ohms and modulation index of 1. What will be the total transmitted power?
What is a minimum number of sampling frequency required to have distortion free reconstruction of a digital signal from its samples?
3. Which of the following is a key characteristic of orthogonal frequency-division multiplexing?A. Amplitude modulationB. Noise performanceC. Digital modulationD. Spectral efficiency
Show that the distance between two signal points of BPSK scheme is 2√??
The number of bits per sample in a PCM system has SNqR=45 dB is?
In the application of typical digital signal processing, explain the concept of operation in Speech Coding and Compression.