Q. No. 9. Sketch vo for the network of Figure given below. 100 V 83 KA -100V Answer:

Q: R1 R2 ZL 100/0 Vx 0,8Vx

A: Maximum average power delivered to load

Q: 21. This circuit represents a model of a solar photovoltaic panel. Given that V₁ = 30V, R; = 2002…

A:

Q: For the circuit shown. If the peak voltage V, -120 L 20 V, X = 4.Y=2, and Z = 4. Answer the…

A:

Q: What is the power conservation theorem in the electrical network?

A: According to the power conservation theorem in the electrical network, the algebraic sum of all the…

Q: In AC distribution, 3 phase 3 wire system can be used for all types of loads. Select one: True…

A: 3 Phase 3 wire system includes all the phases i.e R Y and B while in 3 phase 4 wire system an…

Q: Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal…

A: To determine the current in each branch

Q: Determine the value of the mesh currents shown below. 12 12V 10 V

A:

Q: For the mutual electric circuit shown in figure beside, find the set values of * ?mesh currents 1 &…

A:

Q: In the following circuit, V1=97.01 Volts and V2=2V, Volts. V2 cos(wt) V, cos(wt + 45°) 10 0 v(t) If…

A:

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

A:

Q: .For the following voltage and current phasors, calculate the real power in Watts V = 125 4 8⁰ Vrms…

A:

Q: Solve the electric network. You may use any of the 3 solutions to SLE (Gauss Elim-REF, GJ-RREF, or…

A:

Q: Plor the root locus of the system where

A:

Q: In the phasor diagram of balanced star connected system the angle between VR and VRY is -30 degree.…

A: The above statement is false.

Q: ZL ZR For the circuit given above, the circuit parameters are; Is = 12 A, ZR = 7 ohms, Zc = -j14…

A: Fig: Given circuit  apply KCL at node A,…

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

A: Given Data: R = 6 ohm VL = 415 V IL = 30 A

Q: A resistor in series with a 138microfarad capacitor, is connected to a 60HZ source. If the voltage…

A: From given capacitor value and voltage across the capacitor capacitor calculate current through…

Q: the cct shown find Vo f i. 8Ke Va io Skr vb V。そEL 1oka

A:

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

A:

Q: 4) For AC supply voltage of 120 Vac, frequency of 60Hertz and capacitive value of 10.61 micro Farad…

A:

Q: Q1: A three branch parallel circuit has a current locus as given in Figure shown below. Determine…

A: Given:-w=500rad/sec

Q: Use nodal analysis to determine the voltage across 5 ohm resistance and the current in the 12 V…

A: Solution !!

Q: Exercise 2: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak…

A: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time…

Q: circuit shown, find (a wer absorbed, (d) po

A: Since you posted a question with multiple sub-parts. We will solve the first three sub-parts for…

Q: In an electrical circuit, which nature of impedance causes the currents and volfages in phane?…

A: In reactive impedance current lead , lag or in phase with voltage that depends on the reactive…

Q: Calculate the following if the power line delivers 230 V to a load with a resistance of 10 ohms.…

A:

Q: QI) For the circuit shown in figure, use Nodal Analysis to obtain currents ir, iz and is. 40 ww 2A…

A:

Q: A wye-connected load has a IP current of 25A. What is value of the IL current supplying the load?…

A:

Q: Three coils each having resistance of 12 Q and the phase current 18 A are connected in delta across…

A: three coils each having resistance of 12 ohm and thee phase current 18A are connected in delta…

Q: •4) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34°. 1.…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: In Distribution Substations, the Voltage is stepped up for distribution via the Distribution Lines.…

A: 1) In distribution substations, the high voltage from the transmission lines is stepped down to a…

Q: electric circuit is built up by connecting in series an alternating and sinusoidal power source of…

A:

Q: The load on a 120-V, 60-Hz supply is 5 kW (resistive), 8 KVAR (inductive), and 2 KVAR (capacitive).…

A:

Q: Q2// For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…

A:

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

A:

Q: Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor…

A:

Q: max. ave. power transfer

A:

Q: Q9-d) A resident need an electrical supply less than 12 kVA, single-phase from a 3-phase supply…

A: Given, Required power is less than 12kVA single phase from 3 phase supply of 50Hz which is star…

Q: Determine the current that flows through V- 110 cos 377t V. an 82 resistor connected to a voltage…

A:

Q: .Q1: Find lo using mesh analysis

A: assigning each mesh a current

Q: 7. If the current in one coil becomes steady, the current in neighboring coil is? b. Infinity c.…

A:

Q: Three resistances, each of 500 ohms are connected in star to a 400 V, 50 Hz, 3 phase supply. If…

A:

Q: I want a summary + a drawing of the electrical circuit Balanced Wye-Wye connection

A: Balanced Wye-wye connection: A balanced wye-wye connection is one in which both the source and the…

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

A: Given, We have certain conditions. According to that we have to find the unknown resistance value.…

Q: Three coils each having resistance 6 Ω and inductance L H are connected in star to a  415V, 50Hz,…

A:

Q: 4A 10020' V(ms)

A:

Q: hydo power very wefal cemporent Why pover systen? 9, in a

A: This is a simple theoretical question based on hydroelectric power system and its advantages . I…

Q: AC resistance of conductors used in electrical machines which is operating with AC power supply is…

A: In the question, the given Statment    "AC resistance of conductors used in electrical machines…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.