Q.A very long hollow conductor of inner radius 'a' and outer radius 'b' is located along z axis and carries a current / in the -'ve z direction as shown on the right. If the current distribution is uniform. a) Find the magnetic field intensity for a srsb and r2b b) Calculate the stored magnetic energy per unit length for a srsb c) Find the inductance per unit length for a srsb

Q.A very long hollow conductor of inner radius 'a' and outer radius 'b' is located along z axis and carries a current / in the -'ve z direction as shown on the right. If the current distribution is uniform. a) Find the magnetic field intensity for a srsb and r2b b) Calculate the stored magnetic energy per unit length for a srsb c) Find the inductance per unit length for a srsb

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12MCQ

See similar textbooks

Similar questions

The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C and a 60-Hz resistance of 0.0956 ohm per mile at 50C for the all-aluminum Marigold conductor, which has 61 strands and whose size is 1113 kcmil. Assuming an increase in resistance of 2 for spiraling, calculate and verify the dc resistance. Then calculate the dc resistance at 50C, and determine the percentage increase due to skin effect.
The magnetic field intensities inside and outside of a long and smooth conductor with a cross section radius are as follows. Accordingly, find the current densities J inside and outside the conductor. (Hint: Use cylindrical coordinates)
With respect to the diagram shown below develop an equation for magnetic field intensity of a currect carrying straight conductor extending from point A to point B, consider dl=dzaz in this case
Besides the number of turns and the legth of active conductor, whit of the following is?are a factor which affects the amount of emf(voltage) induced in a coil? A) how fast the conductor is moving through the field(rate of incidence), B) the strength of the magtnetic field(flux density), C) the angle at which the conductor is cutting the magnetic field( angle of incidence), D) all of the above What is mean by genarator regulation? A) it is the percentage rise in terminal voltage from no-load to full-load, B) it is the percentage rise in terminal voltage full-load to no-load, C) it is the amount of control one has over the terminal voltage by way of the field excitation, D) none How are transformer components indetified? The algebraic symboly for the number of kilovolt-amperes on the load side of the transformer is_____. A) KVAh, B) KVAx, C) KVA-primary, D) KVA-secondary
A cylindrical conductor of radius 1 cm has an internal magnetic field ? = ?0 (?2−?20.03) ?Φ ?/?Find the total current carried by the cylindrical conductor.
Supposed that a coaxial cable consists of a solid inner conductor of radius a, surrounded by a concentric cylindrical tube of inner radius b and outer radius c as shown below. We assume that the conductors are carrying an equal current I naught that is distributed equally into the cross-section but of different directions as indicated by the directions in the image above. Calculate the magnitude of magnetic field at a distance r from the axis, where: - rc Plot the magnitude of the magnetic field with respect to the distance r from the axis.
The magnetic flux density of sheet steel is smaller than the cast iron for the same value of field intensity True False
Determine the inductance per unit length of a coaxial cable with an inner radius a andouter radius b
A long, solid, cylindrical wire of radius A has a current density given by j = j0r/A. Determine the magnetic field, within the wire, in terms of the total current "I" flowing through the wire.
3. As shown in the figure, a current of 3D204 flows through a long U-shaped (hairpin)-shaped conductor made by bending the conductor in a semicircle with a radius of R = 100mm. Point 6 is the middle of the straight part, very far in a semicircle, and the straight part can be approximated as an infinity line. Find the (a) magnitude and (b) direction of B at point a, respectively, and (c) magnitude and (d) | Find each direction.
-Electric flux density, Gauss's law and -Divergence theorem 7.
with a point charge of 30 nC at (-1, 0, 2), -20 nC at (0,0,0) and 10 nC at (1,5,-1). The total flux leaving a cube of 6 m on each side centered at the origin is?