Q1 Answer the following questions with 1- (00110101)BCD (-----) o=(--------). 2- Count in Hex. from (7-33)10- 3- Convert the binary number 10011.011 to decimal. 4- Convert the decimal number 66 to 0ctal. 5- The decimal number (-29) as an 8-bit number in the 2's complement necessary caleulations: form is - ------ -- 6- (707)s is between(-- -)s and (-- -). 7- Gray code for (11001), = 8- The largest number in BCD system with 2- digit is - 9- ASCII means- 10- A O1=

Q1 Answer the following questions with 1- (00110101)BCD (-----) o=(--------). 2- Count in Hex. from (7-33)10- 3- Convert the binary number 10011.011 to decimal. 4- Convert the decimal number 66 to 0ctal. 5- The decimal number (-29) as an 8-bit number in the 2's complement necessary caleulations: form is - ------ -- 6- (707)s is between(-- -)s and (-- -). 7- Gray code for (11001), = 8- The largest number in BCD system with 2- digit is - 9- ASCII means- 10- A O1=

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Find the answers to the following questions? a) Find the excess-3 code of (152) Base 10.b) Convert binary to grey code 0101011.
8- Convert the following Gray codes (1000)to binary? 9- How many bits are required to represents the decimal numbers in the range from( 0 to 999 )using : 1- straight binary code? 2-Using BCD code? 10 Determine the codes that are entered from the computer’s keyboard when the following basic program statement is typed in. also express each in hexadecimal notation.10 Add “X=A+B”;X
A) How many Binary digits do you need to represent a deciaml number 355?
The binary number 1010 0011 is an ?even or odd? number that has?even or odd? parity?
An eight bit number, 01011101, is: 1)added to 4 2) subtracted from -10 3) ANDED with 15 a) What is the outcome of these operations in binary? b) What is this number in decimal? c) What is the original number in decimal?
Construct 3 to 8 and 6 to 16 Decoder with basic gates (Module KL-33005, block c). Truth Table Boolean Expression:- Circuit:-
Perform the indicated arithmetic on the following signed 2’s complement binary numbers. a) 01011011 + 11100101 b) 01001 - 01110 c) 1111 + 1100 Note: The answer should show the 2’s complement binary result; also indicate if each result is positive or negative or overflowed (by writing “positive”, “negative” or “overflow” next to the binary answer) and then follow with the decimal value of the result if there was no overflow. Do not extend (add any additional length) to these representations, but rather use a binary number word size equal to those found in each problem statement.
Add signed binary numbers (+5) and (-12). Use 8 bits to represent your numbers.
Convert the binary number (1011101) to its equivalent decimal and BCD values. (Show you work) Convert the decimal number (478) to its equivalent hexadecimal and binary values. (Show you work) List the next twenty five hex numbers in sequence from (9E7) hex upwards, adding one each time. (Write them horizontally, with comma as separator) Answer the following logic operations : a) 0 . Z’ = b) 1 + W = c) d . d’ = d) b . b = e) X + (X+1)’ = f) 1 + X’ = g) C + B’C’ = h) B + (BC)’ =…
2-bit half-adder using logic gates and or not. Please type answer no write by hend.
If R0 = 0x20008000, after run STMDB r0!, {r3, r9, r7, r1, r2} command what is the r7 register memory start address?A. R0= 0x20007ff4B. R0 = 0x20007ffefC. R0 = 0x20007fffD. R0=0x20007fecE. R0 = 0x20007ff0
Question 2: The HCS12 registers have the values shown in the attached table.Where X, means the values is undefined. Answer the following:A. What is the HCS12 operational mode?B. What is the value on port B pins?C. What is the value on pins PT4-PT7?D. What is the value of X in PTT register?E. Is port B working in full or reduced power?F. What is the pins configuration of CAN2 and CAN4?