Q2:-A rectangular gate AB in Fig is I m long and 1.5m wide into the paper, hinged at A. and resting on a smoothbottom at B. The Glycerin of sg- 0.89 acting on the left of gate, What the depth of water h will acting on gate?WaterGlyceria2 mIm60

formula to find force exerted on flat plates immersed in the water F=γAhγ= unit weight of liquidA=…

Q2:- A rectangular gate AB in Fig is I m long and 1.Sm wide into the paper, hinged at 4, and resting on a umooth bottom at B. The Glycerin of sg-0.89 acting on the left of gate, What the depth of water a will acting on gate? Water Glycerin 2 m m 60

Q2:- A rectangular gate AB in Fig is I m long and 1.Sm wide into the paper, hinged at 4, and resting on a umooth bottom at B. The Glycerin of sg-0.89 acting on the left of gate, What the depth of water a will acting on gate? Water Glycerin 2 m m 60

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Draw the B.M.D for the following, (El) is constsnt 5kN 10kN/m D 21 B A 2m 6m 21

A: Given:- The magnitude of the uniform load = 10 kN/m The magnitude of point load at D = 5 kN To…

Q: What is the minimum Block mass (kg) that is required to open the gate A-B? The density of water is…

A: Given data Oil specific gravity Water Density of block Horizontal force Normal force

Q: Water flows through a horizontal branching pipe as shown at a rate of 280L/s. All points are inside…

A: P1=70kPa Q=280L/s A1=0.1m2 V3=6m/s To find pressure at section 3

Q: A 10 m y D B 60 KN 40 KN 80 KN

A: Sopl

Q: Situation 2. Determine Wp аnd tp if the location of centroid from bottom is 19.120cm (ỹ) and I =…

Q: Q2: Gata AB Fig. below, 6m wide and weight 5 kN, it is hinged at B, determine the water level h,…

A: Given, width of gate=6mweight of gate=5KNUnit weight of water=9.81KNm3Solution,From figure…

Q: Gate AB in Figure below is semi-circular, hinged at B, and held by a horizontal force F2, at point…

Q: Question 1:- the gate (CD) shown in fig. below has a 1.5 m width if the unite weight of glycerin is…

A: Weight of gate=200kg

Q: C6-68 A lightweight pipe is slipped over the handle of a wrench to give extra leverage (Fig. P6-68).…

A: Given Data: The force exerted on the wrench is F=225 N. The total length of the pipe is L=600 mm.…

Q: 4497) Determine tha force in bars BD, CD, and DE of the nacelle trus showa in Fig. P427. 600 b 1200…

Q: Steel cuble E, = 200GPA A, - 400mm2 L = 3m Q2/ Find the displacement of point B. Answer B 45 6n =…

Q: 2.62 Gate AB in Fig. P2.62 is 15 ft long and 8 ft wide into the paper, hinged at B with a stop at A.…

A: We have to calculate water level h for the gate will start to fall.

Q: Problem 2 A 1.0X102 N force in the j direction is applied to piping (ABCDEFG). The points in Fig 2…

A: Given data:- Force F =100 N The force vector is F⇀=(100 i+0 j+0 k) N The coordinates of points;…

Q: Question 1:- the gate (CD) shown in fig. below has a 1.5 m width if the unite weight of glycerin is…

A: To find depth of water h

Q: L K 60° 4 m 10 kN В D E F -3 m - 3 m+ 3 m - 3 m -- 3 m-|- 3 m -| 20 kN 30 kN 40KN Figure 2

Q: A 3 in. D 2 in. G in.

Q: 10 kN 2 kN/m of I 6m- I 4m- 4m-

Q: Question 1:- the gate (CD) shown in fig. below has a 1.5 m width if the unite weight of glycerin is…

Q: Q1-for the Structure shown,Draw the bending moment and shearing force Diagrams: 30 kN 5KN/m 4m +3+

A: The following figure shows the Free Body Diagram of the beam.

Q: acebook MODULE 13 (part 1) - Shear and X letails COLLEGE OF ENGINEERING AND ARCHITECTU Civil…

Q: Consider the retaming wall shown m the ligure helow Calculate the Rank me passive force per unit…

A: Passive pressure is a condition in which the retaining system exerts a force on the soil. Since…

Q: Question 1:- the gate (CD) shown in fig. below has a 1.5 m width if the unite weight of glycerin is…

Q: A homogeneous rectangular gate AB 5.5 ft wide and 10 ft long. Friction in the hinge is negligible.…

Q: 3.66 A long water trough of triangular cross section is formed from two planks as is shown in Fig.…

Q: Water flows through the elbow. It exits to the atmosphere at section 2. The inlet and exit pipe…

A: We have above given data we have to find the force on the flange bolt at section 1

Q: Question 1:- the gate (CD) shown in fig. below has a 1.5 m width if the unite weight of glycerin is…

A: Step 1

Q: mpletion Status: Two cables suspending a 100 kg object. The cables are at different angles from the…

A: Given Weight of block = 100kg Angles = theta = 35⁰ theta = 42⁰

Q: GIVEN: VERTICAL thATE HIN GED LIQUID I Im %3D LHINGE GATE 2m Fi LIQuin を 3m

Q: tho The 200-kg engine block is suspended by the cables AB and AC. The angle a = 40°. The FBD…

Q: ituation 3: If 0 = 30° and T = 6 kN, determine the magnitude of the resultant force acting on the…

A: Here we have to calculate resultant force on eyebolt and it's direction clockwise from x axis.

Q: 30 KN/m Im -> 30m & Draw Bending Momont Diagramn? Q Draw Deffected Shape? Reaction?

A: Three Moment Equation: M1L1+2M2(L1+L2)+M3L2+6A1a¯1L1+6A2b¯2L2=0

Q: -) The gate shown below rests on a Sinooth floor at A and is hinged at B. Neglecting its weight,…

Q: A -6 m ·x 15 kN BE 2m 2m 2m 30 kN m -6 m C

A: To Determine Support Reactions at A, B and C

Q: Point B is an internal hinge. Find Ay, MA, and Cy. 30 kN 60 kN/m 25 kN 20 kN В 2 m 3 m 2 m 1.5 m 1 m

Q: n the figure. 20kN 3m 3m G0 KN E A

A: To find force in member

Q: 60kN 20kN/m 10kN/m 2m Hinge 3m B 2m С 2m D 4m E

A: Simplifying the given beam.

Q: 20 kN 40 kN/m -8 m 150 kN-m Prob. 7–55

A: Note: As you have nothing mentioned in this problem so, we are solving it for reaction at support A…

Q: 50 kN 100 kN 50 kN A D В C E -3 m -3 m -3 m -3 m- ВEAM 4

Q: Locate the centroid y̅ of the area.

A: The given figure is shown below:

Q: Water flows through the elbow. It exits to the atmosphere at section 2. The inlet and exit pipe…

Q: Gate AB in Fig. (5) is 15 ft long and 8 ft wide into the paper, hinged at B with a stop at A. The…

A: Width=8ft Length=15ft

Q: 4.OKN 8.OKN 2KN/m 2m im. 4m 2m

A: To draw the shear force and bending moment diagram-

Q: 5kN/m 40 kN A 2m 2m Figure 2

Q: Sample Problem 7.3 Determine the maximum force P that can be applied to block A in Fig. (a) without…

A: In this problem, question asking what is the value of force P required to move either block we find…

Q: Analyze the frame shown below 3m 100KN 2. C. 1 2. 0-53 D 5m

Q: Q2: Determine (Y). If PA- Pg 6624

A: To solve this problem, we are given Pressure at A - Pa Pressure at B - Pb Pa-Pb=6624 We ned to…

Q: Gate AB in Fig. (5) is 15 ft long and 8 ft wide into the paper, hinged at B with a stop at A The…

A: To find value of h

Q: *** The unit of the water height needs to be meter. The width of the rectangular gate of AB (Figure…

A: Weight of gate (W) = 1810 kN = 1810000 NWidth of gate (b) = 4 m

Q: 4-42. The rectangular gate of Figure 4.63 has a width of 2 m and is exposed to atmospheric pressure…

A: To Determine The vertical support reaction force acting at the bottom end of the gate, V

Q: 4m seawater (SG=1.031) A 60 2m

Question

Q2:-A rectangular gate AB in Fig is I m long and 1.5m wide into the paper, hinged at A. and resting on a smooth
bottom at B. The Glycerin of sg- 0.89 acting on the left of gate, What the depth of water h will acting on gate?
Water
Glyceria
2 m
Im
60

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

P- Value (10kN)
This is a determinate structure, which must be statically stable and used in the analysis of MCD? a. Primary Structure b. Virtual System c. Real System d. Analytical mode
What is the centroid pressure acting on the gate? O (1000)x(8) O (1000)x(6) (9810)x(5) (9810)x(6) (9810)x(4) None of the above
15. Acid circular rod that is 600 mm long and 20 mm in diameter is subjected to an axial force of 50kN. The elongation of the rod is 1.40 Circular mnd that is 600 mm long, and 20 m mnm modutas of clustcity assume that the ratenia dues not yield. A. 68209 GPa B. 0.6821 GPa C. 68.21 GPa D. 682.1 GPa
Calculate reaction at supports
What is the reaction at support C for the beam shown and a settlement of 25 mm at supportC
Calculat reactions at pin support A and edge B, take beam weight 35 Kg 1 т 3 т B 50° A
18. If a close coiled helical spring absorbs 30 Nmm [S-toof energy while extending by 5mm, its stiffness will be (b) 4 N/mm (a) 2 N/mm sqa-bun ann and (c) 6 N/mm (d) red boxit 10 N/mm q
Answer for MC1 and Mc2
9,46 The square, flat plate shown in Fig. P9.46a is cut into four equal-sized pieces and arranged as shown in Fig. P9.46b. Determine the ratio of the drag on the original plate [case (a)] to the drag on the plates in the configuration shown in (b). Assume laminar boundary flow. Explain your answer physically. (a) (14 -1
The switch shown is designed to close as the temperature rises causing AB and CD to expand and making point E come in contact with point F. Arm AB is made of steel with a CTE of ast = 12x10-6/ °C, and arm CD is made of aluminum with a CTE of aa = 24x10-é /°C. At 20 °C, arm BDE is vertical as shown. Determine the required gap, s, (at 20 °C) if the switch is to close at 120 °C, knowing that LBD = 400 mm and LDE = 160 mm. Express your answer in mm to the nearest 0.001 mm. E D
1406. Through what distance will body A in Fig. P-1408 move in changing its velocity from 6 ft per sec to 12 ft per sec?