Q2 Two single-phase voltage sources, V1 and V2 are connected by parallel line impedance of Z11 = 1+ j2 N and Z12 = 3+jN as shown in Figure Q2(a). If, V, = 230210° Vrms and V, = 240420° Vrms (i) Analyze the current supplied and received by the sources of V, and V2 respectively. (ii) Determine the complex power for each source. (iii) Based on the real and reactive power, explain whether each of sources is supply

Q2 Two single-phase voltage sources, V1 and V2 are connected by parallel line impedance of Z11 = 1+ j2 N and Z12 = 3+jN as shown in Figure Q2(a). If, V, = 230210° Vrms and V, = 240420° Vrms (i) Analyze the current supplied and received by the sources of V, and V2 respectively. (ii) Determine the complex power for each source. (iii) Based on the real and reactive power, explain whether each of sources is supply

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
Find the equivalent resistance per phase for the following three-phase load-balanced arrangements, express your responses as a function of the impedances, ?1, ?2, ??1 and ??1. Remember to add j and –j to the reactances, as appropriate.
4) State the relation between line and phase values of voltage and current for 3-pha se DELTA connected load .state the equation for active, reactive power consumed by 3-phase load.
What can you say about the flow of power as a function of time between a balanced three-phase source and a balanced load? Is this true of a single-phase source and a load? How is this a potential advantage for the three-phase system? What is another advantage of threephase power distribution compared with single-phase?
An AC three phase distribution system (given in Figure 2), which has end user with balanced three phase (10A) load, is given in the figure. The phase-neutral voltages of the transformers are given as V1=224V, V2=225V, V3=228V and V4=231V respectively. a) Calculate phase-neutral voltage of the bus-bar (B). b) Calculate currents of the transformers (I1, I2, I3 and I4) c) Calculate phase-neutral voltage of the point K while the output of TR3 and TR4 (xy) have been short circuited for a transient time (transformers are still operational) by the line fault.
please explain the operating principle of single phase 2S-2P PMSM based on 3D design illustration.
In the power system whose single line diagram is shown below, the line cross-section is 95 mm2, the intrinsic conductivity coefficient is 34 m/ohm.mm2 and the inductive reactance of the line is 0.4 ohm/km. According to these values; Find the location and value of the largest voltage drop.
Write an introduction about: LOAD BALANCING in 3-Phase System
In the above figure, a single line model of a three-phase power system is given. Base power 50MVA, base voltage 13.8kV according to its value, a) Per-unit values of power system circuit elements according to the given base power and base voltage values. calculate. b) The perunit you calculate by drawing the equivalent impedance circuit for one phase of the power system given in the figure. show on the values.
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.
Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.