Q3. As shown on the right in image below, the force Facting on the box varies with displacement s, and the coefficient in the image, C = 13. Determine the work done by force Fto the box when the box has displaced s = 1.5 m. Please pay attention: the numbers may change since they are randomized. Negative sign must be included if the work done is negative. Your answer must include 2 places after the decimal point, and proper SI unit. F (N)

Q3. As shown on the right in image below, the force Facting on the box varies with displacement s, and the coefficient in the image, C = 13. Determine the work done by force Fto the box when the box has displaced s = 1.5 m. Please pay attention: the numbers may change since they are randomized. Negative sign must be included if the work done is negative. Your answer must include 2 places after the decimal point, and proper SI unit. F (N)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
Calculate the horizontal force P required to push the 85-lb lawn mower at constant speed. The center of gravity of the mower is at G, and the coefficients of rolling resistance are 0.12 for the front wheels and 0.18 for the rear wheels.
If PCD=6000lb and PGD=1000lb (both compression), find P and Q.
The engine of an automobile develops 20hp when the automotive is traveling at 50 km/hr. What is the resisting force in Newton? If the resisting force is proportional to the velocity, what horsepower will drive at 25 km/hr?
SHOW COMPLETE SOLUTION A 5kg block rests on the smooth incline (30 degrees above horizontal) and is attacked on a spring originally stretched by 0.5m. Determine the total work done by all the forces acting on the block when a force P= 400N parallel to the inclined pushes the block up the plane at distance 1.5m
In the following figure, the horizontal surface onwhich this block slides is frictionless. If the two forcesacting on it each have magnitude F = 30.0 N andM = 10.0 kg , what is the magnitude of the resultingacceleration of the block?
In a hydraulic press, the small cylinder has the diameter of 8 cm while the larger piston has thediameter of 22 cm. If the force of 600 N is applied to the small piston, what is the force on thelarger piston, neglecting friction?
When landing on a carrier, a 10,000-lb airplane is given a deceleration og 3kg(96.6 ft/sec^2) by means of a cable engaged by an arresting hook. Find the tension in the cable. Format of the answer is lb.
Given the figure before, when the displacement of block D is 360 ft, then the displacement of block A is closest to:
To test the validity of aerodynamic assumptions made in the design of the aircraft, its model is being tested in a wind tunnel. The support bracket is connected to a force and moment balance, which is zeroed when there is no airflow. Under test condition sS, the lift L, drag D, and pitching moment MG act as shown. The force balance records the lift, drag, an d a moment Mp. Determine MG in terms of L, D, and Mp.
Two weights (one is 100lbs. the other is 50 lbs.) are suspended over a circular post as shown. Determine the minmum co-efficient of static friction such that the weights remain motionless if B=180.
Consider a ball rolling around in a circular path on the inner surface of a cone. The weight of the ball is shown by the vector W. Without friction, only one other force acts on the ball—a normal force, (a) Draw in the vector for the normal force. (The length of the vector depends on the next step, b.) (b) Using the parallelogram rule, show that the resultant of the two vectors is along the radial direction of the ball’s circular path. (Yes, the normal is appreciably larger than the weight!)