Q4: Answer the following questions for the array shown below0.50.0 1.10.15.12.1 - 3.5- 6.60.3r0.06.02.83.4array1- 0.41.12.11.31.10.0- 2.0(a) What is the size of array1?(b) What is the value of array 1(1,4)?(c) What is the size and value of array1(:,1:2:5)?(d) What is the size and value of array1([1 3].end)?

An array is a matrix or vector that can store data in row and column form.

Q4: Answer the following questions for the array shown below 0.5 [0.0 2.1 - 3.5 6.0 0.0 -1.1 - 6.6 2.8 3.4 arrayı 0.1 5.1 - 0.4 1.1 2.1 0.3 1.3 1.1 0.0 - 2.0 (a) What is the size of array1? (b) What is the value of array1(1,4)? (c) What is the size and value of array1(:,1:2:5)? (d) What is the size and value of array 1([1 3].end)?

Q4: Answer the following questions for the array shown below 0.5 [0.0 2.1 - 3.5 6.0 0.0 -1.1 - 6.6 2.8 3.4 arrayı 0.1 5.1 - 0.4 1.1 2.1 0.3 1.3 1.1 0.0 - 2.0 (a) What is the size of array1? (b) What is the value of array1(1,4)? (c) What is the size and value of array1(:,1:2:5)? (d) What is the size and value of array 1([1 3].end)?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

As an assignment for antenna course work, you are asked to design a mobile phone antenna which is suitable for a 4G LTE mobile cellular radio system, let’s assume the centre frequency is 2500 MHz. i)What are the general design issues you should take into account? ii)What are the TWO most important parameters in terms of its performance? And what are the expected values?
Use the free space model to compute the free space path loss for a 900 MHz signal over a distance of 200 meters. Express your answer in dB. state the answer in the correct units and show all your computations to receive credit
Use the free space model and the following equation to compute the received power in dBm for a 900 MHz signal travelling to a receiver 200 meters away. Assume the transmitter antenna gain is 10 dB and the receiver antenna gain is 3 dB. Assume the power at the transmitter is 22 dBm. (Note: Pr dBm is the received power in dBm, Pt dBm is the transmitted power in dBm, PL dB is the free space path loss in dB, Gt dB and Gr dB are the antennas gains at the transmitter and receiver, expressed in dB, respectively) state the answer in the correct units and show all your computations to receive credit
Consider a receiving antenna with a ground value of 20 dB and an equivalent noise temperature of 12dBK, the G/T factor will be: Select one: A. The value is 32dB/K b. The value is 8dB/K c. None of the results is correct d The value is -8db/K
A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. Compute the bandwidth occupied by the signal, by using the conventional method and Carson’s rule. Sketch the spectrum of each signal, showing all significant sidebands and their exact amplitude.
12) This MCQ QUESTION FROM ANTENNA ENGINEERING course.
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what is the path loss in dB of the signal if the operating frequency is 3 GHz. (Use two decimal places for the final answer)
4. Derive the equation to get the message from DSB-SC signal usinghomodyne receiver.
An attenuator can be made using a section of waveguide operating below cutoff, as shown in theaccompanying figure. If a = 2.286 cm and the operating frequency is 12 GHz, determine the requiredlength of the below-cutoff section of waveguide to achieve an attenuation of 100 dB between the inputand output guides. Ignore the effect of reflections at the step discontinuities.
3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.