===================================================== Q4/ Compute the Ground level of the points for the following readings: Station B.M. 0+00 1+00 L. 2.5 5.0 2.5 5.0 Distance (m) C.L. 0+00 1+00 R. 2.5 5.0 2.5 5.0 B.S. 1.1 1.3 I.S. 1.47 1.5 1.45 1.35 1.37 1.46 1.4 1.43 F.S. 1.5 1.45 H.I. ========== Ele. (m) 20.5

===================================================== Q4/ Compute the Ground level of the points for the following readings: Station B.M. 0+00 1+00 L. 2.5 5.0 2.5 5.0 Distance (m) C.L. 0+00 1+00 R. 2.5 5.0 2.5 5.0 B.S. 1.1 1.3 I.S. 1.47 1.5 1.45 1.35 1.37 1.46 1.4 1.43 F.S. 1.5 1.45 H.I. ========== Ele. (m) 20.5

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

How was this 0.68 V2 calculated? And also 40.77 f V2 because I am not getting that..
SITUATION B: Prepare and complete the profile level notes for the information shown and perform the customary arithmetic check. What is the difference in elevation between TP1 and TP2? STA BS HI FS IFS ELEV BM1 2.32 328.70 1 1.7 2 2.2 3 1.2 4 0.9 TP1 2.77 3.43 5 2.2 6 3.7 7 1.6 TP2 2.22 3.06 8 2.8 9 3.6 10 2.0 11 1.1 BM2 2.45
A wooden block (40 cm wide (b), 20 cm long (h) and 15 cm deep) floats on the seawater (specific gravity, sg = 1.025) with a depth of immersion is 12 cm. Calculate the position of metacentre, MG and justify the stability of block with the aid of sketch.
A line was recorded as 1750.00 meters long. The standard tape weighs0.65 kg , 30.00m long at 20°C under a 50N pull. During the actualobservation the temperature was 5°C and the tape was suspended undera 75N pull. It was also found that the tape is 3.00mm too long. If the linewas inclined at 3%. E = 200GPa, A = 2.50mm² and the coefficient of linearexpansion is 0.0000116 m/°C.(a) What is the actual inclined distance?(b) What is the actual horizontal distance.
Q) All answers of second moment of area shall be in \times× 106 mm4 Solve it early
A pipe carrying oil of sp gr 0 877 changes in A pipe carrying oil of sp gr 0.877 changes in size from 150mm at section E to 450mm at section R Section E is 3 66m lower than R section R. Section E is 3.66m lower than R and the pressures are 91.0kPa and 60.3kPa, respectively. If the discharge is 0.146m3 respectively. If the discharge is 0.146m /s, determine the lost head and the direction of flow.
An engineer used a 30 m tape in measuring an inclined ground 459.20 m long. The difference between the starting point and end point is 1.20 m. The tape is of standard length at a temperature of 100 C and a pull of 50 N. During measurement the temperature reading was 15 0 C and a pull of 75N applied at both ends. A= 6.5mm2 ; E = 200GPa; K = 0.0000116 m/C0 . The mass of the tape is 0.075kg/m. Determine the horizontal distance.
oil (SG = 0.88) dischargesfrom a pipe (D = 13 in.) through a sharp-crested, round orifice (diameter = 5 in.), as shown. the coefficients of contraction and velocity are 0.619 and 0.967, respectively. find the actual velocity (in ft/s) in the jet. Point (1) is a point collinear with the orifice at point (2). Point (3) is the free surface of the manometer containing mercury. use h = 2.84 ft., and y = 7.42 in.
Optimum Mechanics Co. lifted a car weighing 3184 lbf using the system presented. The platform was supported by four (4) cables (Cable AB, AC, AD, and AE). Determine the following: (Take AB = AE). note: Express your answer in units.Observe 3 decimal places.The error threshold is ± 2.50% Relative to the right answer. A: < 0 0 10.143 >ft B: < 4.954 4.997 0 > ft C: < 6.66 -4.997 0 > ft D: < -7.029 -4.534 0 > ft E: < -5.439 4.997 0 > ft 1.) Determine the x-component of the Tension in AC. 2.) Determine the y-component of the Tension in AC. 3.) Determine the z-component of the Tension in AC.
Optimum Mechanics Co. lifted a car weighing 3184 lbf using the system presented. The platform was supported by four (4) cables (Cable AB, AC, AD, and AE). Determine the following: (Take AB = AE). note: Express your answer in units.Observe 3 decimal places.The error threshold is ± 2.50% Relative to the right answer. A: < 0 0 10.143 >ft B: < 4.954 4.997 0 > ft C: < 6.66 -4.997 0 > ft D: < -7.029 -4.534 0 > ft E: < -5.439 4.997 0 > ft 1.) Determine the TENSION IN CABLE AE.
E = 2.05×10^5 N/mm^2 correct solution only
An open tank with piezometers attached on the side contains two different liquids.Determine the elevation of the liquid in piezometer Achoices are:A. 2.2mB. 2mC. 2.4mD. 2.1m Find the pressure at the bottom of the tankchoices are: A. 18.59 Kpa B. 18.85 kPa C. 19.85 kPa D. 18.95 kPa Find the elevation of the liquid in piezometer Bchoices are: A. 0.918m B. 0.819m C. 0.189m D. 0.889m