Q9: CO is oxidized to CO, in an excess of air in afterburner entering atTo= 298 K. Assuming that air consists of 20% O2 and 80% N, andthere is no dissociation find the required air/fuel ratio if the finaltemperature is 1000 K.

Answered: Image /qna-images/answer/cc3223c7-805c-4ce0-ac07-1a66d2e5d2cf.jpg

Q9: CO is oxidized to CO, in an excess of air in afterburner entering at To= 298 K. Assuming that air consists of 20% O2 and 80% N2 and there is no dissociation find the required air/fuel ratio if the final temperature is 1000 K.

Q9: CO is oxidized to CO, in an excess of air in afterburner entering at To= 298 K. Assuming that air consists of 20% O2 and 80% N2 and there is no dissociation find the required air/fuel ratio if the final temperature is 1000 K.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter3: Refrigeration And Refrigerants

Section: Chapter Questions

Problem 15RQ: What is meant by desuperheating a vapor?

See similar textbooks

Related questions

Q: (b) The 60° V-belt of a machine is pass around the pulley A of a motor and over a pulley B as shown…

A: (a) Tension on tight side: Tt = 131.22 N. (b) Tension on slack side: Ts = 14.55 N.

Q: e necessity of power steering in an automobile. Sketch any power steering system and explain its…

A: Power steering helps the drivers steer the vehicle by reducing steering effort which is needed while…

Q: 03/ The manually - operated hoist shown in figure (13) is based on an epicyclic gear train. The sun…

A: Given: The number of teeth on annulus, Za = 90 The tangential force on handle = 25 x load lifted

Q: Why is it necessary to have oil under pressure in a torque convertor? During torque conversion what…

A: Torque converter is a sealed unit it consist of automatic transmission fluid.It works as the fluid…

Q: Steering geer system Give a small explanation of key understanding of Control unit Transmission…

A: Steering gear system : Control unit The system of steering gear system mainly consists of three…

Q: cle and a ridêf 8f km/hr on the level road. A brake is applied to the which 0.70 m in diameter and…

Q: CENTROIDS AND CENTER OF GRAVITY: The following problems are to locate centroids of areas and lines.…

A: To find centroid

Q: NOTE: This is a multi-part question Once an answer is submitted, you will be unable to return to…

Q: The horizontal force P = 67 N is applied to the upper block with the system initially stationary.…

A: Given DataP=67NmA=13kgmB=7kgTo find the F1=?F2=?

Q: *with heat Source energy balance

A: When constructing a heat exchanger, an energy balance calculation is frequently used to calculate…

Q: В 12' F 16' 16' 16' 12' 60kips D

Q: A 2-kg small block B fits inside a smooth slot cut in arm OA. The arm rotates counterclockwise in a…

Q: 2 kN.determine the deflection (in

A: To find deflection of Point-A

Q: etermine the coordinates of the mass center of the welded assembly of uniform slender rods made from…

Q: y •r = 100 mm 50 mm -180 mm 1.

Q: The conical spool rolls on the plane without slipping. The axle has an angular velocity of wwi = 3.4…

Q: The volocity fiold for a flow is given by: V= (5x + 6y- 72) i- (6x + 5y + Sz)j + (3x + 2y + Az)k and…

A: This question is related to the kinematics of fluid. the conservation of mass means velocity field…

Q: Determine the reaction at the supports A and C of Structural Truss shown.

Q: An air turlane with one inlet and one exit operates at Steady State, and has heat trans fer to the…

Q: A Cascade refrigeration system using flash tank and intercooler is operating an evaporator with a…

A: INTRODUCTION : The refrigeration is a process of maintaining a place at a lower temperature as…

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of vavg = 1.15 m/s.…

Q: 3. A vapour compression refrigerator uses R-12 as refrigerant and the liquid evaporates in the…

A: Given: h1 = 180.88 kJ/kg h3 = h4 = 45.4 kJ/kg, h1 = 191.76 kJ/kg, s1 = 0.7051 kJ/kg K sg2 = 0.6921…

Q: SITUATION: A cylindrical tank with radius 0.5 m and 2 m high weighs 1200 N. The tank is to float in…

A: Disclaimer: Since you have posted multiple questions we will solve the first question for you. If…

Q: A manometer is used to measure the pressure of a gas in a tank. The fluid used has a specific…

Q: Steam is generated at 4.1 Mpa and 440 degrees Celsius and the condensing pressure is 105 Kpa. Find…

Q: An adiabatic turbine running on an ideal gas (R = 2.079 kJ/kg K, k = 5/3) has at the entrance 35 m/s…

Q: Problems 1 and 2. Locate the centroid of the shad y -r = 100 mm 50 mm -180 mm 1. 2.

A: Divide shaded area into 3 basic elements as shown above

Q: A gate rotates at point A and releases water when the water's depth, d, exceeds a certain value. The…

A: Given data: d=4.82 fth=2.41 ftb=2.95 ftγw=62.4 lb/ft3 Need to determine the magnitude of the…

Q: A = 5 in^2 E = 29,000 ksi I = 5 in^4 Setup [k] and Solve for the displacemen

Q: An open coiled heilcal spring made of 6 mm diam- eter steel wire and 60 mm mean coil diameter, with…

A: We know that an axial torque T is applied to an open coiled helical spring made of 6 mm diameter…

Q: 2. Find the number of corrugated roof sheets and its accessories if the plan specify 2-1/2 side lap…

Q: Q3/ The brakes of a truck travelling at 43 km/h are suddenly applied to avoid a vehicle which has…

Q: Consider the dynamic system shown below. The input f(t) is a force applied to mass m1. The…

Q: A truck weighing 200kN descends a 250m hill with brakes engaged at a constant speed. These brakes…

Q: When the pressure inside a vessel is 22.75 psig. then the absolute pressure equal to:

Q: O I'd love ice-cream I love ice-cream

A: Correct is I love ice-cream.

Q: . . coffee at breakfast O drinks O drink O drank

A: Drinks- present Drank- simple past Drunk- past principle

Q: (e) Out of the camber and caster, which is measured first and why? How the cambe angle can be…

A: Tire wear on the outside tread of the tyre is caused by positive camber. A car will pull to the…

Q: A 2-meter long prism with square cross-section of side 0.1m is made of stainless steel with a…

Q: (a) Distinguish between semi-floating and fully-floating rear axles with the aid of suitable…

A: Given question Distinguish between semi-floating and fully-floating rear axles with the air of…

Q: PROBLEM#4 WRITE SHEAR AND MOMENT EQUATIONS FOR THE BEAMS IN THE FOLLOWING FIGURE IN EACH SEGMENT,…

Q: Consider the gate shown The gate has a width of 1 m. ρw = 1.0 Mg/m^3. Suppose that a = 2.5 m, b =…

Q: Problem 4 An U tube of radius R and length L is filled with water. In equilibrium position the water…

A: Given data A u-tube of radius R and length L is filled with water. If the level of water is…

Q: Saturated water undergoes process 1-2-3-4, as shown in the figure. The initial pressure is 0.2 MPa…

Q: The volocity fiold for a flow is given by: V- (5x+ 6y+ 7z) i + (6x + 5y + 9z)i+ (3x + 2y + Az)k %3D…

A: Use generalised continty equation to solve the problem,

Q: What is perfect steering? Derive expression for the basic condition for a perfect steering mechanism

Q: Q1 Two spur gears in a simple train shown in Figure Q1 are having the same module, m = 2 and their…

Q: Problems 1 and 2. Locate the centroid of the shaded area y y -r = 100 mm 100 mm 140 mm 50 mm 140 mm…

A: Given Figure

Q: Two equal masses m move without friction on a plate. They are connected to each other and to the…

Q: Q3. (a) 2 kg of powder A and powder B (as shown in the table below) were filled inside separate…

A: Given: Density of the powder A→ρi,A=1200 Kg/m3 Initial height of the powder A→Hi,A=30 Cm=0.30 m…

Question

Q9: CO is oxidized to CO, in an excess of air in afterburner entering at
To= 298 K. Assuming that air consists of 20% O2 and 80% N, and
there is no dissociation find the required air/fuel ratio if the final
temperature is 1000 K.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given Data

VIEW

Step 2 Calculation

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Gaseous hydrogen (H2), has been proposed as a “green” fuel. Consider burning H2 in 154% of theoretical air (lean mixture) at 25oC and 75 kPa. Find the following: The adiabatic flame temperature. Tad flame = ___________ oC (+ 10 oC) The dew point of the exhaust. Tdp = _________ oC (+ 1oC)
Pls anwer thank you! Methane burns with stoichiometric quantity of air. The air/fuel ratio by weight is?
a. A winter fuel has10% and 90% evaporation temperatures of 122°F and 360°F with midpoint boiling temperature of 190°F. Find its drivability index, DI. b. A fuel blend has a density of 700 kg/m3 and a midpoint boiling temperature of 90◦C. What is its cetane index?
how do you apply the 80 percent of the exceeded air to the combustion equation, as there is a ratio of 1.8 and 0.8 in places? also explain how from the energy balance equation the Qout was obtained?
In a gas turbine unit, air enters the combustion chamber at 550 kpa 275oC and 45 m/s. The products of combustion leave the combustor at 511 kpa, 1000oC and 180 m/s. Liquid fuel enters with a heating value of 43000 kJ/kg and fuel-air ratio is 0.0229 by mass. Take cp = 1.00 kJ/kg-K for air and cp = 1.08 kJ/kg-K for flue gas. Determine the combustor efficiency?
Q4) A small, low emission, stationary gas turbine engine operates at full load (3950 KW) at an equivalence ratio of 0.286 with an air flowrate of 15.9 kg/s. The equivalent composition of the fuel (ethane) is C2 H6. Determine the fuel mass flowrate and the operating air-fuel ratio for the engine
Propane C3H8 is burned with 50% excess air. What will be the equivalence ratio?
Diesel Fuel C14.4H24.9 is burned with atmospheric air in a stoichiometric ratio. The number of moles of N2 is?
A 0.064 kg of octane vapor (MW=114) is mixed with 0.91 kg of air (MW=29) in the manifold of an engine. The total pressure in the manifold is 86.1 kPa, and a temperature is 290K. Assume octane behaves ideally. What is the partial pressure of the air in the mixture in kPa?
Compute for the internal energy, enthalpy and entropy. 10. Saturated steam at 29.875 MPa, 415. 25 deg C
In an oil-gas turbine installation, air is taken at pressure of 1 bar and27°C and compressed to a pressure of 4 bar. The oil with a calorificvalue of 42,000 kJ/kg is burnt in the combustion chamber to raisethe temperature of air to 550°C. If the air flows at the rate of 1.2kg/s; find the net power of the installation. Also find the air-fuelratio. Take CP = 1.05 kJ/kg K.[Hint: Determine the mass of fuel burnt by dividing the heat supplied to air by thecalorific value of fuel. Air-fuel ratio is the ratio of mass of air to the mass of fuel.Mass of fuel burnt per second = (Heat supplied to air/ Calorific value of fuel)Air-fuel ratio = (Mass of air/ Mass of fuel)]
Question No.16: PropaneC3H8 is burned with 75 percent excess air during a combustion process. Assuming complete combustion find air- fuel ratio.