Answered: Question-07 A short transmission line…

Question-07 A short transmission line has a total resistance of 2p.u, reactance of 3p.u, current of 125 A and pf 0.8. Regulation in percentage is equal of (a) 1.9 (b) 0.38 3.4 (d) 0.19

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2MCQ: Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False

See similar textbooks

Related questions

Q: In the network in Fig. P7.12, find i (t) for t> 0 using the differential equation approach. bodom…

Q: Linearize the graph and identify the following: (1) Linear regression equation; (2) Coefficient of…

A: Given values are change in current with increase in conductance value. Regression formula is given…

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA( a. 90 V…

A: Given data, Circuit diagram is given as,

Q: Group the terms in your KCL equations and rewrite your equations in terms of V₁, V2, V3 .. [example:…

A: In the given circuit we have three nodes v1 , v2 , v3 with voltages v1 , v2 , v3 .here we have to…

Q: Calculate IT IR1 IR2 IR3 VR1 VR2 VR3 PR1 PR2 PR3

A: Given data, VT=220 VR1=10 ΩR2=20 ΩR3=40 Ω The given circuit is redrawn below

Q: Microprocessors and their accompanying systems have progressed to the point where limiting variables…

A: Given: Microprocessors and their accompanying systems have progressed to the point where limiting…

Q: Explain the function of the circuit. 1 V Ri 192 Rinternal = 00 RL V Figure 4-1. Measurement of the…

Q: Find the trigonometric Fourier series for the function below. Show the details of your work. Write…

Q: For a Pentium II descriptor that contains a base address of 0004B100H, a limit of 00FFFH, and G = 1,…

Q: 2. Solve for I and V. 14V + 4Ω www 2Ω 4V + + > 1 V 12Ω www 4Ω

A: Circuit is said to have super node , if there is a voltage source between the two non reference…

Q: CREATE A STATE TABLE GIVEN STATE DIAGRAM

Q: Find the transfer function for each operational amplifier circuit, G(s) = Vo(s)/Vi(s)

A: Given here opamp based circuit and asked to find the transfer function.

Q: Determine the transfer function Vo/Vi of the network below. R₁ www C₁ C₂ CR₂

Q: Solve for I. 24V + 8Ω www 8Ω www 5Α www 4Ω ww 8Ω Μ 8Ω 8V

Q: A BJT amplifier circuit shown to the right. Vcc=10V, I=1mA, and VT 25 mV at 300K. a)Type of…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: USING NODAL ANALYSIS NUMBER 1 SOLVE FOR I WITH COMPLETE SOLUTION USING NODAL ANALYSIS ONLY( AS IN…

A: Given- Current source = 12 A, 2A Resistance value = 40 ohm, 10 ohm, 20 ohm To find- Value of current…

Q: The input-output relation for a given system is x(t) → y(t) = t² log₂ [x(t) + 5x(t-2)], 2≤t≤32…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: The dangers and failure in it and How can we be protect from these dangers and defects of…

Q: Determine the laplace transform

Q: Problem 2 Find the Thevening and Norton equivalent circuits for the network shown below. 3Ω www 50 V…

Q: Find the time constant for the circuit below. 19

Q: What is the function of the fridge drawer?

A: . SOLUTION FRIDGE DRAWER FRIDGE DRAWER is also known as CRISPER DRAWER,…

Q: Draw the schematic symbol of Shockley diode and explain how it is triggered.

A: The schematic symbol of Shockley diode is shown below:

Q: 3. Determine the currents i₁, ₂ and 13 8 A 10 A A 2 A 12 A 4 A 12 B C 14 A E 13

A: This problem is based on kirchhoff's current law (KCL). According to KCL sum of all incoming…

Q: 4.46 Use the mesh-current method to find the total power developed in the circuit in Fig. P4.46.…

A: In this question, We need to determine the total power developed in the circuit. We know power P=…

Q: The center frequency of a bandpass filter that has an upper cutoff frequency of 121 krad/s and a…

A: Given a band-pass filter has, Upper cut-off frequency, ωH=121 krads. Lower cut-off frequency, ωL=100…

Q: Questions (T/F) Time shifting a signal g(t) changes its spectral density g(f) = G(f)1². A signal…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: αν 60 V + 120 Ω ΟΣΑ 50 Ω3 + Vab - b (Do |6A 200 Ω

A: Given: Required: vab in the given question.

Q: For the transfer function given, write the corresponding differential equation: G(s) = = X(s) F(s) =…

Q: Find the transfer function G(s) = = vi(t) R1 202 Vo(s) Vi (s) + L1 4H using Mesh analysis C1 HH 3F…

Q: A Czochralski Si crystal was pulled from the Si melt containing 10¹5 cm³ boron (B) and 5x10¹4 cm²³…

Q: a) The voltage, Vc in a capacitor is given by: where C is the capacitance in Farads (F), i is in…

Q: a. Give a personal practical experience for each of the following: controls system the exhibits…

A: SOLUTION SATURATION In control system SATURATION is defined as "…

Q: After a long time, the switch S₂ is opened and the switch S₁ is closed at t = 0. Find v(0). 2. Find…

A: In this question we need to find a voltage across capacitor at given time and instantaneous power…

Q: How do I find the power developed by a current source in a circuit

Q: As shown in the figure, a 10 resistance is connected across a source that has a load line v + i =…

A: Given- Load line- v+i=100,R=1 Ω, To Find- The current through the resistance (i).

Q: One 12 V battery supplies 100 mA to a boom box. How much energy does the battery supply in 4 h? Ⓒa.…

A: Given data, Supply voltage V = 12 V. Supply current i=100 mA. Time t=4 hour =4×60×60=14400 sec.

Q: Explain the function of the circuit. 20V + * 싸 1 k2 Figure 4-2. Circuit to determine maximum power…

A: Given circuit,

Q: In Figure 2, BJT external bias voltages VBE =VB-VE and VBC =VB-Vc are shown. For example, in region…

A: We need to identify from the given figure in which operating region BJT is acting on.

Q: The diodes D1 and D2 in this circuit are conducting with constant voltage drop VD = 0.7 V. Determine…

Q: Three single-phase step-up transformers rated at 50 MVA, 13.2 kV/80 kV are connected in wye- delta…

A: Given that: Three single-phase transformer winding rated at 50 MVA, 13.2kV/80kV in star delta on 80…

Q: Solve for VCB and VCE. 10 με 47 ΚΩ B 10 ΚΩ - – 2V '2.4 ΚΩ C - ΦΕ E 18 V 10 με H + VCE B = 120 1.1 ΚΩ…

Q: This circuit incorporates a 400-2 linear potentiometer with the indicated setting. What is the…

Q: 3) The results of an open circuit test and a short circuit test In a 450 kVA transformer, 42000/2400…

Q: 5 V 390 one's private de Figure 1 Bridge circuit 47052 Action 3.3 k R₁ - 33052 ww Love 1.2 k

Q: 1) A 12 KVA, 480/120 V transformer is tested to determine its equivalent circuit. The test results…

Q: Circle the right answer(s) The Secondary source(s) of solar energy is/are: Wind Energy Hydropower…

A: Given: Various energy sources To find: We have to select the secondary source of solar energy out of…

Q: Figure 18.5 R₁ A TIT X V 1/₂ B + R₁ OV

Q: 5 V 390 R₁-3305 ww 47052 Action Figure 1 Bridge circuit 3.3 k Love 1.2 kn

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False
What is the maximum length in km for 1 phase transmission line having conductor of 0.875 square centimeter area over which 220kW at 0.8 power factor and 3500V are to be delivered? The efficiency is 80% and specific resistance is 1.825 micro cm
What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square centimeter area over which 220kW at unity power factor and 3500V are to be delivered? The efficiency is 80% and specific resistance is 1.825 micro cm.:
For the network below, determine fLD. I need answer ASAP!! THANK YOUUU!!
One advantages of load balancing is that each phase conductor carries the ? current value
10- If power factor is less than unity then it will result in a. Large kVA rating of equipment b. Large copper losses c. Greater conductor size d. Large kVA rating of equipment, Greater conductor size and Large copper losses
Q: For the following OLD, take Sg = 50 MVA and VB = 22 kV at thetransmission line to find the short circuit current if a 3-ph fault occurs atthe middle of transmission line.15 MVA20 MVAX = j0.6 pu(15:35) kVG-EX = j0.3 pu25 MVA(40:15) kV15 MVA(6+j8) Q23 kVM18 kVT.LX = j0.5 puT1T2´x = j0.3 pu
Determine the current in the neutral conductor and the current in each line conductor (i.e., IR, IB and IY) using the given information below. The powers 12 kW, 18 kW and 24 kW are the loads of a purely resistive loads which are between the yellow and blue, the red, and neutral phases respectively of a 3-Φ, four-wire system.415 V is the line voltage.
One of the following factor, which will not affect the resistance of the transmission line. a-Weight of the conductor b-Temperature c-Frequency d-Spiraling
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
The recommended limit of voltage drop on a power circuit for a single-phase supply as per IEE Wiring regulations is equal to 12 V. Then the value of supply voltage is a. 200 V b. 400 V c. 240 V d. 230 V
If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line reactance is 5(ohm) Find value of active power and reactive power at receiving end of line.