Question 12 When measuring the dimensions and-or form deviations of an extremely accurate metal part: a) moisture, wind and airborne particles must be controlled b) operator's body temperature and blood sugar level must be controlled c) thermal conductivity must be determined to identify the temper d) coolant must be used during production to keep temperature low e) none of the above

Question 12 When measuring the dimensions and-or form deviations of an extremely accurate metal part: a) moisture, wind and airborne particles must be controlled b) operator's body temperature and blood sugar level must be controlled c) thermal conductivity must be determined to identify the temper d) coolant must be used during production to keep temperature low e) none of the above

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 2R: A major hazard involved with water heaters is that they operate under whatever pressure the serving...

See similar textbooks

Similar questions

Which of the following is the standard by which electrical installations are measured in the United States? a. National Electrical Code b. United Electrical Code c. Basic Electrical Code d. none of the above
A good rule-of-thumb to estimate the expected life of a motor, a ballast, or other electrical equipment is that for every ____________ C above rated temperature, the expected life will be cut in __________________.
Indicate the allowable ampacity of the following Type THHN (copper) conductors. Refer to Table 310.15(B)(16). a. 14 AWG __________ amperes b. 12 AWG __________ amperes c. 10 AWG __________ amperes d. 8 AWG __________ amperes e. 6 AWG __________ amperes f. 4 AWG __________ amperes
Which of the following is the best insulator? a. wood b. thermoplastic c. copper d. cast iron
What is the name of an appliance that is used to remove moisture? a. humidifier b. dehumidifier c. air conditioner d. both a and c
A major hazard involved with water heaters is that they operate under whatever pressure the serving water utility supplies. Water stays liquid at temperatures higher than the normal boiling point of 212F (100C). If the high-temperature limit control failed to operate for whatever reason, should a pipe burst or a faucet be opened, the pressure would instantly drop to normal atmospheric pressure, causing the superheated water to turn into ______________ that could result in ______________. To prevent this from happening, water heaters are equipped with pressure/temperature relief valves.
During its use, the temperature of the aluminum wire has increased from room temperature to 80 degree Celsius. Calculate the increase in the resistivity of the aluminum wire. The resistivity of the aluminum at room temperature (20 degree C) is 2.75 x 10^(-8) ohm-meter, and the temperature coefficient of resistivity is 0.00039/degree C.
Electrical Engineering - High voltage system EENG451 Please solve the question quickly
Asap plz plz within 20 minutes all parts
At a temperature of 25°C (common temperature for components in an enclosed operating system), determine the thermal voltage VT.
Explain properly and weite in detail.
Introduction of Geothermal Energy and Geothermal PowerPlant Articles and Studies (3 PARAGRAPHS)