Question 24 Not yet answered out of For the op-amp shown in the following figure, the midrange voltage gain is equal to- 3 kn m Select one: Oa-26.7 Ob.-27.7 Oc 27.7 d. 26.7 80 kn m

Q: B- A Blood warming device contains a 20 mm diameter copper pipe is used to carry warm water, the…

A: SOLUTION   GIVEN--->     Blood Warming device diameter= 20mm ==>…

Q: three point-charges are located at rest in the same plane as shown in the given figure. the charge…

A: Using the horizontal equilibrium condition for the given diagram,  Tsin300=Fq3q1 Plugging the known…

Q: A single-phase thyristor controlled bridge rectifier is supplying a dc load of 1 kW. A 1.5 kVA…

A: Given- Single phase thyristor controlled bridge rectifier- DC load Po=1 kW=1000 W1.5 kVA isolation…

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A:

Q: Two wire distributors ABC A is feeding on 240 v. AB Loop Impedance is 0.05 + J 0.150 and section…

A:

Q: Investigate the stability of the following system (Consider quadratic Lyapunor system) 4 ==G (-1) {…

A:

Q: What is RG rating of coaxial cable. Please give me detailed information. Don't copy previously given…

A:

Q: Simplify the following equations: X = ABC + AC

A: Given, The expression is X=ABC+A¯C.

Q: Find the attached file.

A:

Q: The following data are obtained for 7.5 hp, 28A, 4-pole, 208V, 60Hz, Y-connected stator squirrel…

A: The electromagnetic induction is optimized in squirrel cage motors by the rotor bars interaction…

Q: The equivalent resistance and reactance referred to the secondary side of a 10 kVA, 2200/440 V,…

A: Given here the equivalent resistance and reactance referred to secondary side are 0.3 ohms and 1.2…

Q: Evaluate both sides divergence Theorem c/m² D = 2xy ay + x² azt and the rectangular Parallele piped…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Determine the efficiency of a high frequency induction furnace which takes 10 minutes to melt 1.815…

A: Given- Mass of aluminium m=1.815 kgInitial temperature t1=15oCtime t=10 minutesinput power Pi=5 KWTo…

Q: Convolution with Impulse (Dirac) Function Convolution with impulse function can be performed by the…

A:

Q: An appliance uses 114 watts and is on 8 hours per day. If electricity costs 18 cents per…

A:

Q: In the circuit shown below each resistor are 10052. If the battery has 30 V potential differences…

A:

Q: In the following circuit, find the current Ix, and the power associated to the dependent source.…

A: Given data, V=5 V, Vx=1 V Circuit diagram is given as,

Q: 3.1 Find in From the circuit in Figure 3. 3.2 Find Q b ww Σ10 Ω ข้อที่ 3 รูปที่ 3 10 mH 3.3 If a…

A:

Q: What substance acts as the moderator in a pressurized water generator?

A: Pressurized Water Generator:- The water in the core is heated by nuclear fission and then pumped…

Q: A coil of resistance 82 and inductance 0.5 H is connected to 110 V d.c. supply. Find (i) rate change…

A: We have an coil of resistance and inductance with,   Resistance (R) = 8 Ω   Inductance (L) = 0.5 H…

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given- Three phase load-Wattmeter readings=400W  & (-35) WTo Find-The total active power Pactive

Q: A power station has a maximum demand of 100 MW and produces 1008 × 10^3 units per day. The power…

A:

Q: Find the inverse transforms 100 F₁(0) = jo 100 F₂(0) = F3(0) = 500 (jo+100) (jo+500) 500 jo…

A:

Q: A sequential circuit has two JK flip-flops A and B, two inputs x and y, and one output z. The…

A: Given input equations and circuit output equations, JA=Bx+B'y'KA=B'x+yJB=A'xKB=A+xy'z=A+Bx'y'

Q: 2. Consider a linear time-invariant continuous (LTC) system having an impulse response -2…

A: GIVEN:  impulse h(t)=e-2t sin(3t) u(t) FIND: a)transfer function of the system           b)…

Q: True or false: For a ring with P nodes, the ratio of the total network bandwidth to the bisection…

A: Network Bandwidth:  It represents the best case. NB = bandwidth of each link × no. of link Bisection…

Q: Consider the system shown in Figure (1). This is a PID control of a second-order plant G(s). For the…

A:

Q: A d.c. 2-wire system is to be converted into a.c. 3-phase, 3-wire system by the addition of a third…

A: A DC 2-wire system is to be converted into 3-phase 3-wire system.   We need to calculate the…

Q: . A power supply is having the following loads : Max. demand (kW) Type of load Diversity of group…

A: We have given loads of a power supply with its diversity of group and demand factor.   Overall…

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: I am attaching detailed solution image of this question.

Q: 750kW alternators are operated in parallel. P₁ = 750kW, P₂ = 750kW Speed regulation of one machine…

A:

Q: 10. A 47 resistor and a capacitor with a capacitive reactance of 120 are in series across an ac…

A: SOLUTION GIVEN-->           LET                   RESISTOR = R ohm…

Q: ww 50 A ww 20 A wwwww 400 www. 70 A Figure 2. 200 200 220 V

A: I am attaching detailed solution image of this question.

Q: Check which of the following systems is dynamic. a. y(n) = x(-n) b. y(n) = x(n) + x(n-1)

A: Given governing equations of two system. Asked to check which are dynamic?

Q: A parallel resonant circuit has a capacitor of 250pF in one branch and inductance of 1.25mH plus a…

A: One capacitor in one branch and  Inductance and resistance in series and this combination is in…

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: The detailed solution is provided below.

Q: What semiconductor materials would be more suitable for a single junction pv device for ground or…

A: GIVEN: Graph between normalized absorbance and wavelength FIND: Based on data, suggest a…

Q: Low power factor has some adverse impact on both the transmission line and on the consumer…

A: “Low power factor has some adverse impact on both the transmission line and on the consumer…

Q: H.W A15nc point charge is V₁ in Free Space calculate is beated P₁ (-2,3,-1) and X √ref= V=0) at…

A:

Q: Consider a continuous-time signal x(t) defined by x(t) = 0 for |t| > 1, and x(t) = 1 - It| for It| ≤…

A: Given- Continuous time signal- xt=0 for t>1&xt=1-t for t≤1 To Find- The maximum magnitude of…

Q: 12 v 100 Ω B 200 Ω · A C E 300 < What is the Equivalent Resistance through A to E?

A: Given circuit:

Q: 2.21 For the circuit of Figure 2.54, you want to determine (a) IL, (b) VSWR and (c) Zin. (d)…

A: Given, Characteristic impedance Z0=50Ω Load impedance ZL=30+j6.37×10-9Ω Length L=λ8 Source voltage…

Q: A 220 V, 4 pole d.c. A shunt motor has a flux counterpole of 15 mWb and 1800 armature conductors…

A: Solution: Given data: shunt motor; V=220 V, pole P= 4, ϕ=15 mWb   =15 * 10-3 Wb, armature conductors…

Q: Q3) Suppose that x(t) is real-valued signal, then show that: 5 a) x² (t) dt = X(f)1² df b) if x(t)…

A: A complex signal at any moment takes its value from the set of complex numbers, while a real signal…

Q: 5) Find the Thevenin and Norton equivalent circuits between terminals/points (a) and (b) for the…

A:

Q: A 33 kV, 50 Hz. 3-phase underground cable, 6 km long uses three single core cables. Each of the…

A: We have been given an 33 KV 50 Hz 3-phase underground cable as,   Length (l) = 6 Km = 6000 m Line…

Q: -66 Draw direct form I and direct form II implementa- tions for the following difference equations:…

A: Since you have asked multipart questions, we will solve the first three question for you. If you…

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given  The two wattmeter method is used for measure the power of three phase load. The readings of…

Q: Design a sequential circuit with two JK flip-flops A and B and two inputs E and F. If E=0, the…

A: We have to design a sequential circuit with JK flip-flops A and B giving two inputs E and F. When…

Q: What is RG rating of coaxial cable. Please give me detailed information. Don't copy previously given…

A: RG RATING RG is stands for RADIO GUIDE. This term is used during WORLD…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.