Question 3 a. Generate the BCD equivalent of 927810  b. An imported system was detected to work only on grey codes, Generate the grey code of 5476532108 to be fed into the computer. c. Subtract 763.558 from F11.6416 and store the answer in base 4 d. Explain the step you took to obtain your answer in “c” above

Q: 2.Which of the following has 4 input lines and 16 output lines ? 2. Encoder 1. Decoder 3. 16-Segment…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Question 3: Consider the multiplexer to the right. With F(x,y,z) as output function. Fill in the…

A:

Q: A Using the CRC generator (1011)2; a- Verify that the code word (100010100); is received correctly.…

A:

Q: 2- The FM modulator has k 30 kHz/V modulated with frequency deviation =127.2khz . Calculate the rms?

A:

Q: 4 x 4 decoder possible?

A: Decoder : Decoder is a combinational circuit that has ‘n’ input lines and maximum of 2n output…

Q: Q3: Draw the waveform (Q) for 4-Bit Up/Down synchronous Binary Counter? CK 18 10 11 12 13 14 15 Up/…

A: A synchronous binary up/down counter is built, which has input of 4 bits. The waveform and the logic…

Q: The carrier waveform has a frequency of 50 kHz and a peak value of 20 kV. Write the two lines of…

A: We need to write code to assign given data to given variables We need to assign 50kHz to fCar and…

Q: What is the significance of the J and K terminals on the J-K flip-flop? a) There is no known…

A: Q. What is the significance of the J and K terminals on the J-K flip-flop? a) There is no known…

Q: Create a software in MIPS (MARS) that will convert an 8-bit binary digit to a binary-coded decimal…

A: Given: AL and BL are the registers in the programme.Transfer the data from 2000 to AL. Change the…

Q: Generate the BCD equivalent of 92781. b. An imported system was detected to work only on grey codes,…

A: the solution is given below :

Q: 12 Verify the truth table of decoder driver 7447/7448. Hence operate a 7 segment LED display through…

A: Question :-

Q: 21. Given below is the digital data, write a MATLAB program to plot the digital data and the…

A: Write a MATLAB program to plot the digital data and the unipolar nrz signal of the given digital…

Q: 1. (a) What is the minimum number of flip-flops required for a decade counter?

A: Based on our rules, when multiple questions are posted, we should answer only the first question.…

Q: Question: 1 Write an AVR program that read the potentiometer voltage measurements as analog data…

A: Note : As per the policy we can only a question at a time. If you want the solution of the next…

Q: 3) Multiply Bl with the content of the memory location pointed by SI+30, store the result into Dx?

A: Consider 8-bit multiplication, we can use MOV and MUL instructions here. MOV destination, source…

Q: The question is in the picture below.

A: Given 3 Decoding circuits, Input variables= {D0, D1, D2, D3} Output variable= Y Given that, HIGH is…

Q: Analog computer works on the supply of a) continuous electrical pulses b) Electrical pulses but not…

A: Given that: Analog computer works on the supply of a) continuous electrical pulses b) Electrical…

Q: (1000), + (1001), in BCD is O (1000 1000), O (1001 0000), O (11010), (0001 0111), (10001), 2

A: Given: (1000), + (1001), in BCD

Q: Specify the size of a ROM (number of words and number of bits per word) that will accommodate the…

A:

Q: a- Define Mealy and Moore machines? b- Design a sequence detector of the pattern 0100 where the…

A: The solution to the given problem is below.     ***Note: According to Bartleby policy we are not…

Q: (ъ) Answer each of the following for the BCD-to-decimal decoder shown in Fig. 3(b): (i) Briefly…

A: 1. Briefly explain the function of a BCD-to-decimal decoder.2. What do the inversion bubbles on the…

Q: Build the 7 Segment Decoder and convert it into symbol (block).

A: Theory: A Digital Decoder IC, is a device that converts one digital format into another and one of…

Q: Use VHDL to implement a 16-to-1 Multiplexer. The inputs are w0, w1, w2, w3, w4, w5, w6, w7, w8, w9,…

A:

Q: 8- (A.B) + (A.C) =? 9- In BCD (0100) + (0110) =? 10- (A.B.C) + D=?

A: 8.AB+AC 9.  0100      0110 ......................      1010         as sum is  greater than 10 ,add…

Q: 17. Determine the output of the DAC in Figure 12–48(a) if the sequence of 4-bit numbers in part (b)…

A: Given:

Q: 4- Draw the circuit required to generate the BRDY signal that needed by the Pentium processe…

A: It is defined as the Railway semaphore signal is one of the earliest forms of fixed railway signals.…

Q: Q2) Answer one of the following A) Write a VHDL code to implement 3-state buffer shown below must…

A: A) library ieee;use ieee.std_logic_1164.all;   --Entity named tri_buff   entity tri_buff is   port(…

Q: 1) a- Which of the following are integrated circuits? (Can be Encoder, Decoder or Multiplexer)   b-…

A: a) Given two diagrams represents the combinational circuits which is a type of integrated circuit.…

Q: Q7a-For the message 1010110000111011011 give the DPSK system. b-Compare between PCM, DPCM, DM and…

A: Below are the required answers:

Q: 10.Assume the input frequency (fm) is 256kHz. The output frequency (fou) will be a. 16 Hz b. 1 kHz…

A: In digital electronics, a binary decoder is a combinational logic circuit that converts binary…

Q: Given below is the digital data, write a MATLAB program to plot the digital data and the unipolar rz…

A: Write a MATLAB program to plot the given digital data and the unipolar rz signal of the given data.

Q: Problem_#02] Given the inputs shown below to a 4-bit comparator, what are the outputs. A3 is MSB Ao…

A: We are given a 4-bit comparator and we are going to find the output for the given inputs which are…

Q: 3.1 You are given a timing waveform below that simulates a logic circuit. The values are represented…

A: Given Hexadecimal values are, A= F4 B=2D Z=C7 The decimal value of F4 is, 15*16+4*160= 240+4= 244…

Q: g) The smallest unit of binary data is the 1. bit. 2. byte. 3. word. Diec h) Which of the following…

A: According to the information given :- We have to fill in the blank on the basic of option mentioned.

Q: 1. When the output code of ADC is missed, this error named as......... a. Incorrect error. b. Offset…

A: Note : As per the bartleby policy we can only answer single question at time. If you want the answer…

Q: 7) Study the data transfer counter program of the figure below and answer the following questions:…

A:

Q: Which of the following is an valid state in an 8421 BCD counter?      (a) 1100     (b) 0010     (c)…

A: The correct answer is given in step 2.

Q: 1) Design a system same as that shown in Fig. 8 to transmit a data from 4-bit with odd parity bit.…

A:

Q: QUESTION 1 Burst error must occur in consecutive bits True O False

A: The term burst error means two or more bits in the data unit have changed from 0 to 1,vice versa

Q: Problem_#03] If the output is a "1" for the decoders shown below, Find the input given that A3 is…

A: in question given that, output of decoder is 1 so we have to find input A3.

Q: e) Analyse the suitability of the generator CRC-10 polynomial x0 + x° +x +x* +x? +1 that is…

A: Solution:

Q: Question 3: Consider the multiplexer to the right. With F(x,y,z) as output function. Fill in the…

A: It is defined as logic, chart that shows the truth-value of one or more compound propositions for…

Q: 6. Given the following 4x1 multiplexer, which input passes through to y? i3 i2 i1 y io s1 so 11

A: - We need to highlight the input that is passed through to y.

Q: You have received a security Binary Coded Decimal (BCD) corresponding to 568310. You are to…

A: Here is the answer :-

Q: way (a) Give one major advantage of using RPN rather than infix in computers. (b) Find the result of…

A: A)  Reverse polish notation is also called postfix notation.  In reverse polish notation, we don't…

Q: 1- Find and plot the output signal of the following system:

A: MATLAB : MATLAB is a programming platform designed specifically for engineers and scientists to…

Q: 1. Compare between BCD code & Excess-3 code? 2. What is the reason of inventing Excess-3 Codes? 3.…

A:

Q: (a) Write the BCD code for 9   (b) Write the BCD code for 6  (c) What is the BCD code for 15?…

A: 9 is represented as 1001 6 is represented as 0110 15 is represented each digit individually as 0001…

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.