Question 4 The phase currents in a delta-connected three-phase load are as follows: between the red and yellow lines, 30 A at p.f. 0.707 leading; between the yellow and blue lines, 20 A at unity p.f.; between the blue and red lines, 25 A at p.f. 0.866 lagging. Calculate the line currents. Round your currents to one decimal place and your phase-angles to the nearest whole number.

Question 4 The phase currents in a delta-connected three-phase load are as follows: between the red and yellow lines, 30 A at p.f. 0.707 leading; between the yellow and blue lines, 20 A at unity p.f.; between the blue and red lines, 25 A at p.f. 0.866 lagging. Calculate the line currents. Round your currents to one decimal place and your phase-angles to the nearest whole number.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.47P: Two three-phase generators supply a three-phase load through separate three-phase lines. The load...

See similar textbooks

Similar questions

Two three-phase generators supply a three-phase load through separate three-phase lines. The load absorbs 30 kW at 0.8 power factor lagging. The line impedance is (1.4+j1.6) per phase between generator G1 and the load, and (0.8+j1) per phase between generator G2 and the load. If generator G1 supplies 15 kW at 0.8 poir factor lagging, with a terminal voltage of 460 V line-to-line, determine (a) the voltage at the load terminals. (b) the voltage at the terminals of generator G2, and (c) the real and reactive power supplied by generator G2. Assume balanced operation.
Estimate the distance over which a load of 15000 KW at p.f-0.8 lagging can be delivered by a 3-phase T.L having conductor each of resistance 0.8 2 per km the voltage at the receiving end is to be 132 KV and the losses in the line is to be 5% of received power
A single phase line has resistance of 5Ω per conductor and inductance of 25 mH per conductor. The line delivers 1000 kW power at 22 kV at 0.8 lagging power factor. So Find (1) voltage regulation (2) efficiency and (3) sending and power factor.
In the system given below, Za=Zb=Zc= (25+j5) Ω.a) Find the line currents?b) Calculate the total average, reactive and complex powers?
In the above circuit VL=239 and ZL= 28 + j47, fond the Ib line and IAB phase currents
Given the symmetrical components to be V0 = 10<0 V , V1 = 80<30 V , V2 = 40<-30 V determine the unbalanced phase voltages Va, Vb, and Vc.(b) Using the results of part (a), calculate the line-to-line voltages Vab, Vbc, and Vca. Then determine the symmetrical components of these line-to-line voltages, the symmetrical components of the corresponding phase voltages, and the phase voltages.
The sequence component line currents of a three-phase, 4-wire system are the following: Ia0 = 50cis(180); Ia1 = 52cis(-50); and Ia2 = 46 cis(70) amperes. What is the magnitude of line current lc in amperes?
For the three-phase system shown, determine: A) The magnitude of the line current. B) The magnitude of the current at each stage of the load. C) P, Q, S in each phase D) S, P, Q and f.p.
NOTE :( Just solve only for the Symmetrical components of the corresponding phase voltage) Given the symmetrical components to be V0 = 10<0 V , V1 = 80<30 V , V2 = 40<-30 V determine the unbalanced phase voltages Va, Vb, and Vc.(b) Using the results of part (a), calculate the line-to-line voltages Vab, Vbc, and Vca. Then determine the symmetrical components of these line-to-line voltages, the symmetrical components of the corresponding phase voltages, and the phase voltages.
A three-phase transmission line has an impedance of 2 + j8 Ω per phase. The linesupplies the following two three-phase loads:Load 1: 600 KVA at 0.8 power factor lagging.Load 2: 300 KVA at 0.9 power factor lagging.The phase voltage at the loads is Vr = 2000∟0◦ volts.Determine:a) The phase voltage at the sending end (Vs).b) Three-phase real and reactive power losses in the transmission line.c) Three-phase real and reactive power supplied at the sending end.
The sending-end and receiving-end voltages of a three-phase transmission line at a 200 MW load areequal at 230 kV. The per phase line impedance is j14 ohm. The maximum steady-state power that canbe transmitted over the line is
Using the more complete model on slide 24 of the 3-phase systems ppt, assume we have a Y-Y system with generator phase voltages of 120Vac and generator phase impedance of 0.1+j0.2 Ω, connected through transmission lines with impedance of 0.5+j1 Ω to a load with phase impedance of 15+j10 Ω. Assume the “a” phase of the generator is at 0°. Use single-phase analysis where appropriate. a)What are the current phasors through the transmission lines? b)What is the voltage phasor across each of the generator impedances? c)What is the voltage phasor across each of the transmission line impedances? d)What is the voltage phasor across each of the phases of the load? e)What is the power factor of the load?