QUESTION 6A rectangular loop of length a-4.00 cm and width b-2.00 cm is put in a region of uniform magnetic field of magnitude B-2.54 T that is parallel to theplane of the loop. If the loop experiences an initial torque of 2.16 mN.m, find the current passing by the loop (in A).Click Save and Submit to save and submit Click Save All Answers to aave all answers.

Given data : Length of rectangular loop a=4 cm=4×10-2 m Width of rectangular loop b=2 cm =2×10-2 m…

QUESTION 6 A rectangular loop of length a-4.00 cm and width b-2.00 cm is put in a region of uniform magnetic plane of the loop. If the loop experiences an initial torque of 2.16 mN.m, find the current field of magnitude B-2.54 T that is parallel to the passing by the loop (in A).

QUESTION 6 A rectangular loop of length a-4.00 cm and width b-2.00 cm is put in a region of uniform magnetic plane of the loop. If the loop experiences an initial torque of 2.16 mN.m, find the current field of magnitude B-2.54 T that is parallel to the passing by the loop (in A).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Two circular loops, L1 and L2, of radius 50 cm are carrying currents of 10 mA in thesame direction. If L1 is at z=0 and L2 at z=10 cm, find the total magnetic field due toboth loops at (0,0,50 cm). Draw neat diagrams to explain the concept.
It is helpful! Can you help me with this part? (d) Suppose we start with N particles. We first pass them through a magnetic field in the z-direction, and block the beam that goes down. After this process, you find that only N 2 particles remain. They then go through a magnetic field in the x-z plane, an angle θ from the z-axis, and the beam that goes against the direction of the field is blocked. Then you have a magnetic field in the z-direction again, and block the beam that goes up this time. How many particles come out? Compare with the case without the middle magnetic field.
As shown in the figure below, a circular ring with a radius of was folded along a line across the diameter so that the two semicircles were at right angles. Obtain the torque acting on the ring in a space where the current of i flows through the ring and uniform magnetic field hangs in a single semicircular plane and in a direction that is parallel to the picture.
A rod with mass m = 0.720 kg and radius r = 6.00 cm rests on two parallel rails, as shown in the figure. The rails are separated by a distance d = 12.0 cm and have length L = 45. cm.The rod carries a current I = 48.0 A in the direction shown in the figure and rolls on the rails without slipping. There is a uniform magnetic field of magnitude B = 0.240 T perpendicular to the rails and the rod. If the rod starts from rest, what is its speed when it leaves the rails?
An ideal core (assume relative permability is infinity) with a crossectional area of 12 cm2is excited via 10A current flowing through coil with 200 turns. On the one side of the coil, a 1 cm long paramagnetic material (µr=1) is placed. Calculate the magnetic field on paramagnetic material
Consider viewing down on a square wire loop, side 25 cm, with an effective resistance of 20 Ω. The loop has a uniform magnetic field passing though it perpendicular to the loops’ area and pointing out of the page. The magnetic field strength changes from 3.2 T to 6.8 T in 0.5 s.(a) What is the magnitude of the induced current in the loop?(b) What is the direction of the current?
Below is the magnetic circuit with two windings and two air gaps. The cross-sectional area is constant in the parts of the air gaps and within the whole core and is shown with Ac. g1 = 1 mm, g2 = 0.5 mm, Ac = 200 mm2, i1 = 5 A, i2 = 3 A, N1 = 100, N2 = 50. Also, the magnetic permeability of the core can be accepted as μr = ∞. According to this information, a) Magnetic flux density in the air gaps,a) Self inductance of the windings, b) Calculate the mutual inductances between the windings.
The figure shows a cable through which a current I flows, which is composed of a straight segment of length L and parallel to the z axis, then a semicircular segment of radius R and contained in the xy plane, and then another segment of length L, parallel to the x axis. In all space there is a uniform magnetic field B (with arrow) = Bz (z with hat), find the total magnetic force on the three segments of the wire. (The answer must be expressed in terms of I, B, L and R)
The parallel-plate capacitor shown to the right is discharging so that the electric field between the plates decreases. Answer the questions below and explain your reasoning. The bulk of the credit will come from your explanation. What is the direction of the magnetic field at point P?
Consider the arrangement shown in the figure. Assume that R = 6Ω, l = 1.20 m, and a uniform magnetic field of 2.50 T directed down the page. How quickly must the rod move to produce a current of 0.500 A in the resistor?
Four long, parallel conductors carry equal currents of I = 5 A. The figure shows one end of the conductors. The direction of the current is towards the page at points A and B (indicated by the crosses) and out of the page at C and D (indicated by the points). Calculate the magnitude and direction of the magnetic field at point P, located in the center of the 0.200-m square.
As shown in the figure, two parallel conductors carry current in opposite directions. The current passing through one of the conductors is 10 A. If point A is the midpoint of the distance between the wires, point C is d/2 to the right of the wire carrying 10 A current. The distance d is given as 18 cm. If the current I is set so that the magnetic field at point C is zero, find the current I value and the magnetic field value at A.