Qy find the frequency thalasis for the Signal sown A 2
Q: 60. A capacitor is connected to a 84V supply. If the capacitor is being charged to 0.75W-s. What is…
A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…
Q: The output voltage equation for current to voltage Ov_o=-i_s R_f Ov_o=i_s R_f Ov_o=-v_in R_f…
A:
Q: 1.8 The voltage across a 1.1-kW toaster that produces a current of 10 A is: (a) 11 kV (b) 1100 V (c)…
A: Given data, Power (P)=1.1kW or 1.1×103W Current (I)=10A
Q: It is required to increase the power factor of a 750 KW three-phase balanced load from 70% lagging…
A: Given The line voltage and two power factors.we need to determine the capacitance required to…
Q: For the electric two-port circuit shown, write the ser us voltages w.r.t currents equations…
A: For the above given resistive network we need to calculate the value of open circuit parameters. In…
Q: The output voltage equation for current to voltage Ov_o=-i_s R_f Ov_o=i_s R_f Ov_o=-v_in R_f…
A: In the given questions, we need to design, current to voltage converter.
Q: A 100 W electric light bulb is connected to a 250 V supply. Determine: The current flowing in the…
A: Electric bulb current and resistance is calculate as-
Q: for the circuit shown below: The upper reference threshold 10v vin 5 simwt 02.5 O-2.5 02.4 O-2.4…
A:
Q: 1) The equivalent resistance when a resistor of 1/3 2 is connected in parallel with a 1/4 2…
A: Note :- As per guidelines we are supposed to answer only 3 questions. So I request you to please…
Q: Three watt-meters W₁,W2, W3 are connected to phases a, b, and c respec absorbed by the unbalnced…
A: Given Phase voltage and impedances,we need to determine the wattmeter readings and total power…
Q: Use the concept of current division to find the steady-state expression for io(t) in the circuit…
A:
Q: For the circuit of the following figure: Find the total admittance Y-T Find the voltages V ̅1 and V…
A:
Q: 3ZD Calculate the output voltage of an op-amp if a 100mV signal is applied to the non-inverting…
A: Given,For a non-inverting amplifier,Vin = 100 mVRf= 0 ΩRi = 0 Ω
Q: Sketch the following function in frequency domain plot: i. x(t) = 10 sin (20nt + n/2) ii. y(t) = 3…
A:
Q: A circuit has a lower cut-off frequency of 1 kHz and an upper cut-off frequency of 25 kHz. What is…
A: Given data, Lower cutoff frequency, fL=1 kHz Upper cutoff frequency, fH=25 kHz
Q: Q5) Determine the z-transform of the following signal. x(n) = n(-1)"u(n) 2-1 2-1 (1 + 2−1)2 · |²| >…
A:
Q: function, the By recording information is supplied by the measuring instrument as a deflection of a…
A: There are three types of measuring instruments, which are classified on the basis of their operating…
Q: N 15. What is the capacitance of a capacitor with 4.2m² plates cross-sectional area and 0.09m apart…
A:
Q: Q4. A boost regulator has an input voltage of 5 V. The average output voltage is 15 V and the…
A: Note :- As per guidelines we are supposed to answer only 3 sub-parts. So I request you to please…
Q: HOW TO EXTRACT THE VALUE OF C 1 F 2J√L.C 1 04*10 2+√ 3 1* 10³² *C
A:
Q: Q.4 For the two port network, Determine the Y parameters for the network shown in the following…
A:
Q: Q: Find the values of ID, VGs and Rp for this circuit of JFET has IDSS=5mA and Vp=-4v. +16v RG1…
A:
Q: A 100 W electric light bulb is connected to a 250 V supply. Determine: The current flowing in the…
A: Ohms law state that when a voltage is applied across an electrical circuits, it circulates a current…
Q: 3 Find the charge q(t) flowing through a device if the current is: (a) i(t) = 3 A, g(0) = 1 C (b)…
A:
Q: Q2/Find ((90)10/(36)8)* (F1)16+ (1100111)2=( )Gray O 100101100 1010100111 1000101100 O None of them…
A: given 9010368*F116+11001112=_____grayhere we have find the value which is suitable for blank
Q: Determine the approximate values for each of the following quantities in the following Figure: (a)…
A:
Q: The fan connector will have three or four holes. A three-hole connector can fit onto a 4-pin header…
A: The analog pulse modulation techniques are classified into three types, which are mentioned as…
Q: Q4) Two coils a coefficient of coupling of 0.5.between them are connected in series so as to…
A: With reference to the above given coupling coefficient and series adding and opposing equivalent…
Q: By using a mass scale, five readings were taken to measure a mass of 50
A:
Q: 7 A 4-A current charging a dielectric material will accumulate a charge of 24 C after 6 s. (a) True…
A: we know that current is defined as the rate of change of charge with respect to time. i = dQ/dt in…
Q: Q5/Find the solution of the following operation for binary numbers 11010.101- 100101.010…
A: In this questions we need to perform the binary substraction using 2 complement method.
Q: Q2. Find the z-Transform of the following function: . Sin bn
A: In this question we will find z transform of given function....
Q: Two resistors, R1 and R2 are connected in parallel. The individual resistance measurements, using…
A: The circuit can be draw as R1= 20.35ohm R2= 15.735 ohm
Q: Q3/The BCD7421( 1001 011 in hexadecimal number O 56 O 60 O 134 O None of them O 96 O 65
A: In this question we will convert BCD to hexadecimal...
Q: With a D'Arsonval movement with 100 internal resistance and 1 mA FSD current, it is required to…
A: In this question we need to find a value of series resistance of a multirange voltmeter.
Q: (A) Using nodal analysis, find the current in the circuit below. io 402 202 8 60 V 10 Ω wwww √√₂ 31…
A: In this question, We need to determine the current Io using the nodal analysis.
Q: 3F roblem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…
A:
Q: Ex Assuming rct=oilt and it is desired that ess Koroos, find the range of values of K for error to…
A: In this question we need to find a range of K for the given steady state error.
Q: Calculate the the input Voltage of an inverting op-amp with the following parameters Rf = 1 MOhms,…
A:
Q: 3. Given the signalsy₁ [n] = [−1 3 1 2 1] and y₂[n] = [−2 −1 3 −1 21]. Evaluate the output for…
A:
Q: The converter that employed to vary the root mean square voltage across the load at constant…
A: an ac chopper is a thyristor power converter that converts a fixed voltage, fixed frequency ac input…
Q: C series motor operates at 800rpm with a line current of 100A from 230V mains supply. Its armature…
A: Note: Name of motor is not given so considering it DC series motor and then solving the question.
Q: alternating currents
A: as per company rule , expert can give solution to only 3 MCQ, please repost other questions in site…
Q: Find the output voltage for the circuit below: Rid Ri2 www 5ΚΩ V2 ΣΚΩ U1 R13 06V V1 Hilt 1V 4ΚΩ Ri1…
A:
Q: 5) When the frequency of an a.c. circuit containing resistance and inductance is increased, the…
A: Given, frequency of an a.c circuit containing resistance and inductance increases. Due to increased…
Q: Q4/Find the solution of the following operation for hexadecimal numbers F26/ O None of them O…
A:
Q: Determine the transfer function for the electrical system shown in Fig.1.
A: Given: Consider the following system: To find: Determine the transfer function of the electrical…
Q: It is a concept based on the practical fact that the differential input voltage between plus (+)…
A: Types operational amplifier Inverting operational amplifier Noninverting operational amplifier…
Q: The output voltage equation for current to voltage Ov_o=-i_s R_f Ov_o=i_s R_f Ov_o=-v_in R_f…
A: For the above given question we need to derive the value of output voltage expression of the current…
Q: Derive an expression for the input impedance Zin in terms of the load impedance Z₁ and the…
A: Characteristic impedance:- It is also known as surge impedance of the uniform transmission line. It…
Step by step
Solved in 2 steps with 2 images
- Show that the frequency response on LHS is equal to the Right hand side.For the circuit below, R1=20 kOhm, R2=10 kOhm, RC=3.3kOhm and C1=C2=0.01 µF are given. Find the frequency value for the circuit for the given values. Draw the wave forms for O1, O2, VBE1 and VBE2.Find the average power of given signals in the both figure.