rectangular values is equivalent to the polar form

Q: Q4. The asymptotic Bode plot of a transfer function is as shown in the figure below. The transfer…

A:

Q: nd Vo from the op-amp circuit shown below 2 kN 200 mV W 6 kN 24 k2 100 mV oW 3 k2 100 mV W 1 kN 10…

A:

Q: in = 10 mV p-p what is the output voltage from the circuit shown below? + 20 V R, 2.2 kN C, 4.0 ms…

A:

Q: Determine the cutoff frequency of an op-amp having specified values B1=4 MHz and AVD= 171 V/mV.

A: Given  Bandwidth and voltage gain of an op amp.we need to determine the cutoff frequency. Please…

Q: In an A.C. circuit, the current is given by i= 100 sin 200xt amperes. The time taken by the current…

A: Given an A.C. circuit with, Current, i=100 sin 200πt Amp

Q: unction of an analog multi-meter that does not require a battery? none of these capacitor tester and…

A: In this question we will write about analog multi meter...

Q: oblem 7 V = 1.2 V Ro K = 0.7 mA/V VDD = 12 V %3D ㅜ Voo Vss = 3.3 V Rp = 4K RI 85K R2 = 100K

A:

Q: To draw from point (190,180 point (265,18O), we should use instruc 190,180 265,1 =1 Width Width=20…

A: Construction lines are nothing but the free hand sketching generally done in a quick to represent…

Q: H.W.2: Design a bandpass filter of the form in Fig.1.6 with a lower cutoff frequency of 20.1 kHz and…

A: In this question we need to disign a band pass filter .

Q: e condition for positive feedback is that the phase shift around the feedback loop must be D a. 90 O…

A: These are the few questions related to the understanding of significance of negative sign in the…

Q: A3 Two coils A and B have, initially, a mutual inductance of 250 mH, and the current in coil A is 2…

A: In this question we need to find a induced voltage in coil B

Q: Find Vo from the op-amp circuit shown below 2 kN 200 mV o m 6 kN 24 k2 100 mV oW 3 k2 100 mV oW 1 ΚΩ…

A: We need to find out output voltage for given circuit

Q: Determine the reading on the meter when VCC = 10 V, RC = 5 k2, and IC = 1mA. Re E O a. -5V O b. 0.7V…

A:

Q: 1052 3052 H.W: for the network in Fig. Calculate the equivalent resistance, total current and total…

A:

Q: 4. A delta connected balanced load is connected to a 3 – phase, 400 V supply. The line current is…

A: given here a delta connected balanced load is connected to 3 -phase, 400V supply. so  VP =400∠0° V…

Q: 7. Find V, for the circuit given below. -Vec R, -Vcc

A: The cascade configuration of amplifiers include two or more operational amplifiers connect head to…

Q: Calculate the capacitance between surfaces r= 4 and r= 10 with dielectric of er=3 ? between these…

A: Given, Outer radius=rb=10Inner radius=ra=4εr=3Charge=Q=50Potential between two…

Q: H.W.(2): Determine the cutoff frequency of the lowpass filter described by 4 H(@) = 2 + jw10 Find…

A:

Q: ermine the Fourier series coefficient of the signal zp(t] -1 +2 +3 +4.

A:

Q: 2. Consider an LTI system with x [n] = 5 cos( 0.5nn) h[n] = ()" u[n] and find y[n] where y [n] = H…

A:

Q: RESIS FANCE Stれ」E CompurE 10.TAL AND VO LTAGE IN 14nr [-1A 23 k 28 KA 12 v

A:

Q: 4. a) Define the function of opamp circuit given below. b) If the voltage gain is 50 for the circuit…

A:

Q: Determine the condition of the silicon and germanium diode, then determine Vo from the circuit shown…

A: In this question,  We need to choose the correct options Assume forward bias voltage drop for si…

Q: Calculate the open circuit voltage (in Volts) of a 3-phase, star-connected alternator, 4-Pole, 60Hz,…

A: In this question we will find open circuit voltage of 3 phase star connected alternator....

Q: A3 Two coils A and B have, initially, a mutual inductance of 250 mH, and the current in coil A is 2…

A: In this question we need to find a average value of induced voltage in coil B during 0.2 sec period

Q: II. Use the Table of Laplace Transform to find the Laplace Transform of the given function. a. te-3t…

A:

Q: A 4MVA, 13.3kV, 60Hz, 3-phase, wye-connected alternator has an effective resistance of 5.2 ohm per…

A:

Q: Vheabilmse Find the franster funchion for CRIS- Por the fallowing Control systens by using block the…

A:

Q: Both the Biot-Savart and Coulomb's laws exhibit an inverse-square relationship between field and…

A: magnetic field due to moving charge calculated using Biot savart law is B = (μo/4π) × idl(sinθ)/r^2…

Q: d q2 = -2q q3 = -3q Find the direction and magnitude of net electrostatic d d force excert on the…

A: Same type of charges repel each other Opposite type of charges attract each other Find the force on…

Q: Find the basis functions of the two sighais OSISI S()% 1 S, (1) =e 0SISI

A:

Q: For what value of Id is gm equal to 0.5 gm0? O a. 0.25 Idss O b. O mA O c. 0.5 Idss O d. none of…

A:

Q: A 400 – volt, three-phase, 50 Hz supply has three inductive coils each having resistance of 16 ohms…

A:

Q: Calculate the Capacitive Reactance (Xc) of the circuit of Figure 7 below: 100,000 a R1 240 V .1 uF…

A: Given data,

Q: Consider the SRAM binary cell above and answer the following: Input S Output R Da Read/Write (a) If…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Calculate the total offset voltage for the circuit shown below for op-amp specification values of…

A:

Q: Identify the transfer function IA, of the RL circuit shown below. Express the transfer function…

A: Given: A parallel RL circuit Use  ω0=R/L

Q: ? Electric charges in motion constitutes a Surface current density O Current sheet O Current O…

A: In this question we need to choose a correct option

Q: device that selects one of many inputs and links it to a single output. a Display of seven segments…

A: In this question we will write about  device that selects one of many inputs and links it to a…

Q: _10. Determine the magnitude of the electric field intensity of an infinitely long, straight line…

A:

Q: Given in Figure la is an operational amplifier used as a summing amplifier that accepts three…

A: Summing amplifier is used to process analog signal.summing amplifier is used in a audio amplifier.…

Q: H.W.(2): Determine the cutoff frequency of the lowpass filter described by 4 H(w) = 2 + jw10 Find…

A: In Low pass filter, it passes the low frequency components and block the higher frequency component…

Q: 1 kN +, 20V 2 kN . 20V . 2V +1

A: In this question the basic understanding  operational amplifier is being discussed.It is no -…

Q: 15. If v¡ is 6V, determine v.. 10 k2 10 ka ww O to 48 2 5 k2

A:

Q: Determine the PF associated with a load: (a) consisting of a 6.25-µF capacitor in parallel with the…

A: In this question we need to find a power factor.

Q: Determine the value of Voltage V2. 0.6 A 15 0 12 V 9Ω V2 0.125 V 0.525 V O 1.125 V O 1.925 V 3 925 V

A: Given, The circuit is

Q: A 50 KVA, 4,400/220V transformer has R1 = 3.45 ohm ,R2 = 0.009 ohm.The values of reactances are X1 =…

A: given a 50 KVA , 4400/220V transformer has R1=3.45Ω, R2=0.009Ω, and reactances are X1=5.2Ω,…

Q: In an A.C. circuit, the current is given by i = 100 sin 200rt amperes. The time taken by the current…

A:

Q: An A.C. supply voltage source v(t)=12 sin (377t) volt is connected in series with 50 N resistor. The…

A:

Q: b) If ß = -0.015 and A = -5×10*, determine the closed-loop gain Ar.

A: Given, Negative feedback, β=-0.015 Open loop gain, A=-5×104

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).