Redraw the block diagram below using a consistent block size and even spacing.

Q: - What is the value of the 'step' * ? block Step

A: 1) A system can be represented by the use of blocks . 2) In general, Source block has no inputs and…

Q: If the voltage on pin A3 is 0.806V, what value will analogRead(A3) return from the ADC?

A: Take reference voltage Vref=5V and 10-bit ADC. By using 10bits we can able to represent data  in…

Q: For each of the root loci shown, state the all the reasons why, or why not, the sketch can be a root…

A:

Q: Calculate the currents through and voltages over C1,C2,L1,R1 and R2

A:

Q: Hello dear all, I have build this Karnaugh Map but I always struggle with the functions. I would…

A: 4 Karnaugh maps are given in the question. Find the functions of all Karnaugh maps. Karnaugh map is…

Q: L2 L3 FO F2 K1m K2m| F1 C F3 C VI m1" 3- m2 3-

A: Terminology:   (1). Reach: The length of the line(distance) is protected by the distance relay is…

Q: Determine the power across resistors R1, R3 and R5 using Kirchhoff's Law.

A: It is given that:

Q: One-line diagram is diagrammatic representation of power system in which _______________ are…

A: The explanation is as follows.

Q: Draw bond graph model of the following system. R3 C3 T3 R2 C2 93 R1 C1 92 To T1 T2

A: Bond graphs- Bond graphs are used to represent physics of systems.  Mathematically explained, bond…

Q: Q5. A sensor resistance varies from 520 to 2500 N. This is used for R1 in the divider circuit below,…

A: Given R1 varies from 520 to 2500 Ω        R2=500 Ω        Vs=10V Let current 'I' is flowing…

Q: Simplify using k-map (A+B + D) (B+ C+ D) A

A:

Q: a. Draw a spanning tree that does not include the branches R3 and R.

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The YÇD Company needs to connect 10 mainframe (A-J) computers with cables in a network as shown in…

A: We need to realize the network at minimum cost, i.e. minimum total length of cable. Each computer…

Q: Create a circuit and apply kirchhoffs laws

A:

Q: The ladder diagram of OR gate will have two Normally closed contact in parallel. Select one: True…

A: Ladder diagrams can be used to represent boolean functions. Ladder diagrams are made of controlled…

Q: For loop CEFDC, what is the total voltage with 40 V for V4 , 80 V for V5 , and including 120 V for…

A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current…

Q: (roir02|C,) Out =-gm sCL in =-6. 667 x ( 20 × 10'||20 x 10- sx31.83x10-12 6.667x104 1+sx3.183x10-

A: In this question we need to simplify the given voltage gain.

Q: Using Venn diagrams, prove that: a.(b+c) = (a.b)+(a.c)

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: what are R1, R2, R3?

A:

Q: When using the K-MAP, each group should contain at least one zero.

A:

Q: a. Prove that the block diagrams of the system shown in figure 3 can be reduced to a single block.…

A:

Q: c) If you want to 'clip' voltages that are s-10 volts as well, show how you would modify the…

A:

Q: The V-I characteristics of IGBT is a plot of a. Ic as a function of VGE with VCE as a parameter…

A:

Q: What is the value of R1 and R2

A:

Q: Draw a Circuit using 7-segment display that will display the following: 1. 8457 2. 8537 Example:

A:

Q: The Wheat stone Bridge circuit is used to measure the unknown resistance Rx. At balance condition,…

A: Given    Wheat stone bridge R1=581 ΩR2=100 ΩR3=743

Q: wish to carry out a subtraction using the circuit shown below.  We will subtract A - B where A = 3…

A:

Q: Investigate and explain the application areas of Wheatstone bridge in engineering applications

A: Wheatstone Bridge electrical circuit which is used to measure the unknown parameter such a…

Q: Question 1 Design the following circuits by using only 2x1 MUXs and NOT gates. a. 4X1 MUX b. 8X1 MUX…

A: Note: As per our policy, I have attempted the first three subquestions.

Q: H.W 1- Draw the diagram for this counter 2- Design the last counter by using J-K F.F

A: SR FLIPFLOP

Q: a. Kirchhoff's theorem is paramount in the determination of current and voltage in circuit theorem;…

A: PRESENCE OF SOURCE: In the presence of sources, all the passive elements which are R, L and C always…

Q: Which is the correct statement of a degree of a vertex? * B E D d(A) = 1 d(B) = 4 d(C) = 3 d(F) = 3

A: The degree of vertex is the total edges connected the points.   Answer is option 2 d(B) = 4

Q: Find M1, M2, M3

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Redesign the block diagram shown below. Use only block shapes and standard symbols. Align the blocks…

A: The block diagram is redrawn in steps below,

Q: Find the voltage on the R3 resistor using the Super Position Method. After finding the voltage, find…

A:

Q: AB+ BE CA'+ DB + BC+ DB' A | A'B CA BE DB'

A:

Q: Draw a circuit diagram in which R1 and R2 are in series with each other but collectively R1 and R2…

A: According to given question  need to draw a circuit in which Two resistor that is R1 and R2…

Q: For the diagram shown characterize block G's function using list attached to the diagram.(enter…

A: Please refer the attached images for the complete answer..

Q: Problem 2: Draw block diagram V1 - input V2 - output R2 VI Vz

A: The given circuit diagram is shown below:

Q: 9- To remove small protrusions and thin connection from the image as below, you can use : a- Opening…

A: According to the question, we need to discuss the technique to remove small protrusions and thin…

Q: Design a four-bit variable resistor network DAC using R1-1 K ohm and RL=1000 K ohm resistors for (0…

A: Given: We need to design a four-bit n=4 variable resistor DAC with the following specifications:…

Q: The block diagram reduction process takes more time for complicated systems. Because we have to draw…

A: Its true that block diagram reduction technique takes more time due to draw blocks at every step.

Q: Write few points about combinational circuits

A: The Combinational circuits are those circuit which made up of a combination of different logic…

Q: A resistor of 450 and a bell of 600are connected in series. What voltage is required across this

A: An electric bell consists of an electromagnet made of coil on an insulated wire around an iron bar.…

Q: A null graph is (a) A graph with V(G) consists of one vertex only (d) A graph with one vertex. (b) A…

A: There are different type of graph, namely; Null graph Undirected graph Directed graph Multigraph…