Refer to the circuit shown in Figure Assume that the inductor has a wire resistance of 0.2 Q and the resistor has a value of 250 N. If a current of 3 A is flowing through the inductor, what will be the maximum induced voltage when the switch is opened? FIGURE The resistor helps prevent voltage spikes caused by the inductor. Switch Battery Copyright ©Cengpe learning.

Refer to the circuit shown in Figure Assume that the inductor has a wire resistance of 0.2 Q and the resistor has a value of 250 N. If a current of 3 A is flowing through the inductor, what will be the maximum induced voltage when the switch is opened? FIGURE The resistor helps prevent voltage spikes caused by the inductor. Switch Battery Copyright ©Cengpe learning.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Similar questions

You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
What do you think will happen to the current if the frequency is adjusted higher in the pure inductance experiment? and what will happen to the current if the frequency is adjusted lower in pure inductance experiment? explain why please
Determine the equivalent capacitance of each of the circuits in the figure shown. Note: I leave the image of the exercises in Spanish, but it is easy to understand. Also in the other image is the correct final answer, for checking.
Q2 b) Illustrate the current waveform for a 100 mH inductor, if the voltage across the inductor is given by Figure Q2(b). c) Calculate the minimum and maximum equivalent inductance that can be given by five 5 mH inductors.
Consider the mutually coupled inductors shown in Figure 3.25(a), with a short connected across the terminals of L2. Derive an expression for the equivalent inductance seen looking into the terminals of L1.
P2 Please solve this problem very clearly and briefly with step by step explanation. Question - Ignoring any mutual inductance, what is the equivalent inductance of two inductors connected (a) in series, (b) in parallel?
Find the equivalent capacitance between terminals x and y for each of the circuits shown in Figure P3.25.
What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?
Having stabilized the fuel, you look to your computer for next steps. You are told that the spacecraft uses a "start capacitor" that must reach a required voltage in order to start its engine. This voltage is determined by the fixed capacitance and charge as a function of time, q(t) . These capacitors are charged and stored in your current location and must be brought to the spacecraft. Your computer provides you with the following definitions: Charge: The charge as a function of time is q(t)=∫i(t)dt , where i(t)=36t^5+15t^2−6 is the current as a function of time. You need to provide the computer with the function q(t) in order for it to appropriately charge the start capacitor. If an unknown constant is needed, it can be included using "+ C", being sure to use a capital letter as the lowercase is used for capacitance. q(t)=
The figure shows an electrical circuit with an ideal source ε1 = 12 [V], a real source ε2 = 9 [V] and r1 = 1 [Ω], eight resistors and two capacitors. Switches A and B areThey are originally open and the charge on the capacitors is zero. If switch A closes (B remains open), determine:a) The currents of the resistors R2 and R5.b) The potential difference between b and c, that is, Vbc. Indicate which point is at the greatest potential.c) The power supplied by the real source ε2.
Determine the equivalent capacitance of each of the circuits in the figure shown. Note: I leave the image of the exercises in Spanish, but it is easy to understand. Also in the other image is the correct final answer, for checking. IMPORTANT:Please, preferably the procedure should be digital, not on paper.This way I understand better.I would appreciate it very much!
It is required to grade a string having seven suspension insulators. If the pin to earth capacitance are all equal to C, determine the line to pin capacitance that would give the same voltage across each insulator (C1, C2, …….C6) of the string.