Referring to the given circuit, what is the power dissipated for the load resistor? VS 30 V R1 220 Ω R2 680 +411 RL 1 ΚΩ B R3 470 Ω R4 560

Q: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating…

A:

Q: Problem Solving A 3200/240-V, 60-Hz, 1-phase transformer is built on a core having an effective…

A: 1-phase transformer,             E1E2=3200 V240 Vf=50 HzA = 125 cm2N2= 80

Q: In the given ideal operational amplifier circuit, a) Express vo in terms of v.. b) If v, (t) =…

A: casecaded op-amp circuit

Q: A square-wave inverter supplies an RL series load with R = 25 2 and L = 58 mH. the output frequency…

A:

Q: Illustrate the basic concept of standard amplitude modulation

A: Amplitude modulation is the technique of modulation where the amplitude of the carrier signal…

Q: An 11 KV generating station has four identical 3-phase alternators A,B,C and D and each of 10 MVA…

A: Here,  Every generator is having a reactance of 0.12 Pu G1∥G2=0.12∥0.12=0.12×0.120.12+0.12=0.06…

Q: A sine wave has a maximum value of 10 V. Its value at 450 is 450 V Q 14.14 VO 7.07 V 4.5 VD

A: A sine wave has a maximum value of 10V with an angle of 45o

Q: A 12kVA, 300V/150V transformer has been tested to determine its equivalent circuit. The open circuit…

A: open circuit data: current IOC = 1.8 A power loss POC = 100 W short circuit data : voltage applied…

Q: What is the input resistance, Rin, in the circuit in Figure 4 when n=2 Rin 100 Ω n:1 || 4Ω

A: Number of turns in primary side of transformer n = 2.

Q: (c) (i) A communications channel with a bandwidth of 3MHz has a signal-to-noise ratio of 30dB.…

A:

Q: Problem 1. For the circuit below find v(t) using Laplace transformation at t>0 i,(0) = 3A, vc…

A:

Q: B: Mention four factors (physical state- by them.

A: Mention the four factors (physical state& condition) that the phenomenon of corona is affected-:

Q: A seated musician plays a C4 note at 262 Hz. How long does it take for 196 air pressure maxima to…

A: Seated musician plays a C4 note at 262 Hz  The objective is to find the duration for 196 air…

Q: 10. Consider exponential illustrated in Figure 10. Find the Fourier Transform X(w) of x (t) 0 x (t)…

A: here we have to find the fourier transform of the signal x(t).

Q: e Q1: let the sequence x(n)= n³ 1≤n≤2 -2≤n<0 other wise 1-y₁(n)= 3x(3n+1) 2-y₂(n)=2u(-n-2)-x(n) 4-…

A: Given Data: A sequence of, xn=e-n2+11≤n≤2n3-2≤n&lt;00Otherwise To Find: 1. Plot of y1n=3x3n+1 2.…

Q: CALCULATE REACTANCE

A:

Q: The number n of free electrons per m3 in the current carrying cable is iBL/VHeA. (A is the…

A:

Q: Problem Solving A 3200/240-V, 60-Hz, 1-phase transformer is built on a core having an effective…

A: 1-phase transformer,             E1E2=3200 V240 Vf=50 HzA = 125 cm2N2= 80

Q: 9. A block diagram of an indirect (Armstrong) FM transmitter is shown in Fig. below. Compute the…

A: f1=200 kHz,fLO=10.8 MHz,∆f1=25 Hz,n1=64,n2=48

Q: Q4) Using the block reduction method, compute the transfer function G (s) = C(s) R(S) R(s) G₁ H1 G₂…

A:

Q: A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 200…

A: In this question we need to choose a correct option

Q: PH www

A:

Q: 2. An electric train runs between two substations A and B 10 km apart maintained at voltages 600V…

A: We need to find out the distance for given track for given voltage.

Q: Q14. Two circular conductor loops with radii R₁ and R2, respectively, having the same current I. If…

A: In the question 14, We need to choose the correct options What is magnetic field at the center if…

Q: A function (A, B, C) defined by three boolean variables A, B, and C when expressed as the sum of…

A: Step-1-&gt; we have the boolean expression-: F(A,B,C,D)=¯¯¯¯A.¯¯¯¯B.¯¯¯¯C+¯¯¯¯AB¯¯¯¯C+A.¯¯¯¯B.¯¯¯¯C

Q: BO 300 600. 1200 1200 -ОА

A: The values of the resistances are: R1=600 ΩR2=1200 ΩR3=300 ΩR4=1200 Ω

Q: Question 1. An industrial load consisting of a set of induction motors connected to a 220 V 60 Hz…

A:

Q: Problem (8): Transformer Q15. If the number of the turns in the primary side of the transformer is…

A: Q15) here we have to find the voltage on the secondary side.Q16) here we have to give the reason for…

Q: Q3) For the control system shown in below. Obtain the closed-loop transfer function C(s)/U(s). where…

A: here we have to find the closed-loop transfer function CsUs

Q: 1. EC9Q1 Non-identical Light bulbs A and B are connected in series to a 46-Volt energy source. The…

A: In a series circuit, when multiple components are connected one after the other, the total voltage…

Q: the rotor frequency of a four-pole, 60 Hz induction motor with 5% full load slip is ★ 50 Hz

A: Number of poles P = 4. Frequency f = 60 Hz. Slip s=5%=0.05

Q: . Design a combinational circuit to convert a 4-bit binary number to gray code using (a) standard…

A:

Q: 11.66 Obtain the average power absorbed by the 6-kΩ resistor in the op amp circuit in Fig. 11.85.…

A: Operational amplifier is a differential amplifier.  It is direct coupled high gain amplifier.  It…

Q: Given a pass-band amplifier in 66MHz, design a frequency mixer that receives a 199.25 MHz signal and…

A: Given -  Given a pass-band amplifier in 66 MHz, design a frequency mixer that receives a 199.25 MHz…

Q: 2. In what region are these bipolar junction transistors working?

A: For the given BJT circuit the region of operation of the transistor needs to be calculated based on…

Q: Implement the Boolean function F(A, B, C, D) = Σ ( 1, 3, 4, 11, 12, 13, 15) using (a) decoder and…

A: Given: Boolean function, F(A, B, C, D) = Σ ( 1, 3, 4, 11, 12, 13, 15), To do: We have to implement…

Q: A layer of dielectric with a refractive index of 1.64 is deposited on the surface of a GaAs…

A:

Q: Q1) The equivalent low-side parameters -0.00920 52 and X eq transformer are R eq.IS operated in the…

A: Given,For a low-side transformer,S=250kVAVload=4160 VV=480Vf=60HzReq,LS=0.00920 ΩXeq, LS=0.0433…

Q: What the function of circuit below Lo I₁ Select one: O 4-1 Encoder 2-4 Decoder 3-4 Decoder 4-1 MUX…

A: Given circuit can be used to impliment 4:1 MUX. In 4:1 MUX there are 4 input and corresponding there…

Q: Determine the input resistance (Rin Vin/Iin) of the circuit shown = R₁ + Vin R₂ R₂ Vout

A: The above question is based on the input impedance of an ideal non-inverting opamp circuit. Virtual…

Q: 3.) What is the Voltage Drog что г Resistor ? 120v. ww ww across the 02 800 34022

A: The circuit diagram,

Q: The half-bridge resonant inverter with bidirectional switches is operated at a frequency of fo =3…

A: In this question we need to choose a correct option

Q: 3) VDD=VSS=1.5 V, µpCox=250 µA/V2, µn=2.5-up, Vthn=0.5 V, Vthp=-0.5 V, λn λp=0.1 V-¹ is given for…

A:

Q: 2u(t) www 1 + ܝܚ 2 W (2u(t-2)

A:

Q: A 54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is…

A: In this question we will find total inductance of single phase line.

Q: A: A single core cable covered by the lead, if the radius of the conductor is r and the insulator…

A: Cross Section of Underground Cable:  Given: Single Core Cable covered by Lead  Radius of conductor…

Q: G(s) = 15 s2+5 s +56 a) Find the poles and zeros b) Find the damping ratio (C), and the natural…

A: The given transfer function is,Gs=15s2+5s+56.

Q: Q1:let the sequence x(n)= n(n+1) 4 e-n +3 0 1≤n <3 -2<n≤0 other wise 1-y(n)= -2x(-n-3)…

A:

Q: Discuss briefly the following Boolean Algebra terms and give at least five ( 5 ) examples each : a.…

A: Here asked to explain briefly about Boolean algebra and mention atleast 5 examples of a)SOP b)POS

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.