Required information An ac motor with impedance ZL = (3.2 +3.20) 2 is supplied by an RMS value of 220-V, 60-Hz source. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Find the power factor, the average power, and the reactive power. The power factor of the given ac motor is The average power of the given ac motor is The reactive power of the given ac motor is KW. KVAR.

Required information An ac motor with impedance ZL = (3.2 +3.20) 2 is supplied by an RMS value of 220-V, 60-Hz source. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Find the power factor, the average power, and the reactive power. The power factor of the given ac motor is The average power of the given ac motor is The reactive power of the given ac motor is KW. KVAR.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
A single-phase AC voltage controller has a resistive load R = 10 Ohm, and the RMS input voltage is Vs = 230 V, 60 Hz. The delay angle is 120 degree. Then power factor of the circuit is: Select one: O a. 1 O b. 0.75 O c. 0.44 O d. None of the above O e. 0.9
In DC choppers the wave forms for input and output voltages are respectively a. both discontinuous b. discontinuous,continuous c. both continuous d. continuous,discontinuous
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
The ripple factor for pure dc is Answer:
The single phase AC sinusoidal voltage then the rms value of the voltage v is .........
A synchronous generator generates 370 V at 55 Hz when the field current is 4.4A. The e.m.f generated when the frequency is 35HZ and the field current is 2.9A is ..... .......
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequeney of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms . (iii) Determine phase relationship between voltage and current waveform.
What is the average of A. a sine function over one cycle? Justify this mathematically. B. the square of a sine function over one cycle? Justify this!
RMS value.
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?