Ri=502 www www. lov VD (Volt) In the circuit below, find the current through the diodes R₂=55 ID (MA) D 200. 100 0.4 0.8

Q: On the circuit below, ten resistor are connected to a 15 volt battery in the manner shown. The…

A: Given

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: fotor #1 is a 50-horsepower, code B induct code H induction motor; and motor # 3 is a

A: Given as, The three motors are connected as, Motor 1=50 hp Motor 2 = 40hp Motor 3 = 50 hp

Q: 2. Determine the Fourier series of the sawtooth waveform in Fig. f(1) A Д И. -2 -1 0 1 2 3 1

A: Fourier series is the mathematical representation of complex circuits, which are represented as the…

Q: It generates an output waveform with a phase variation proportional to the modulating signal. Select…

A: Option-3  Direct PM transmitters

Q: 35. A wire of resistivity 2.8 x 10-82 m and length 20 m must dissipate electrical energy at a rate…

A: In this question we need to find a cross sectional area of wire

Q: Find I(t)

A:

Q: Seleccione una: 3 2 O a. 1 0 O b. -1 -2 1 0 -1 -2 -2 -1.5 -1 -0.5 www.yo -1 0 0.5 1 1.5 2 2.5 3 О с.…

A:

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. Η -j9 Ω -j9 Ω 10 Ω bo j6 Ω j6 Ω 20 Ω ell 20…

A: To calculate Zab from the circuit using star/delta conversion

Q: Consider the following block diagram 2 (cs) R(s). S+2 0.5 find the impulse, step, ramp and parabolic…

A: The given block diagram is shown below. We need to find the impulse, step, ramp, parabolic response…

Q: 5. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: In this question,  We need to determine the full load current if Power factor = 80% Voltage VL =…

Q: Q7. the equivalent circuit of XNOR gate could be implemented using

A:

Q: Draw the circuit diagram of a non-inverting comparator and inverting comparator

A: Circuit diagram of non- Inverting and Inverting Comparator:

Q: Q4) Determine the power and rms value for each of the following signals: a) (10+2sin3t)cos 10t b) 10…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q2) show that: X(0)8(f) a) Stx(t)dt → + x(f) 2π]f 2 b) if x(t) = x(-t) (even symmetery) then all the…

A: Given data, a). ∫-∞tX(t)dt = X(f)2πjf+X(0)δ(f)2. b). if X(t) = X(-t) (even symmetery)then all sin…

Q: find the value of ZT. 8 Ω -j12 Ω -j16Ω HH www 20 Ω ZT 10 Ω ww j15 Ω -j16 Ω Η 10 Ω 10 Ω

A:

Q: What is the minimum sum-of-products expression for the following Kmap? AB 00 01 11 10 0 1 0 0 1 1 0…

A: Shown K map solve by formation  of group of zeros for sum of product form formation of  group is…

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: 5. 10v | 12v | 1K IN4001 -Ov 1K IN4001 Find V₁, V₂ and V, with respect to Ov. The IN4001 is a…

A:

Q: A shunt generator supplies a 50-kW load at 400 V through cables of resistance 0.2. If the field…

A:

Q: Find I(t) t = 0 24 Ω 6A (1) Answer: 2e 12 Ω Μ 5 Ω 2Η A, t > 0. 8 Ω

A:

Q: Q2) Apply nodal analysis to find node voltage V, and V₂ and compute power supplied by 6A source.…

A:

Q: 1-Why transformer Rating in KVA? 2-Why is efficiency of transformer high compare to other electrical…

A: Given  We need to explain the reasons why a. Transformer rating is in KVA and efficiency is higher…

Q: Find the carrier and modulating frequencies, the modulating index, and the maximum deviation of the…

A:

Q: 1. A 68 2 resistor is connected across the terminals of a 3 V battery. The power dissipation of the…

A: Given, Resistance, R=68 Ω Potential difference, V=3 V

Q: Calculate the value of Zab in the network j6 Ω −9 Ω ασ m = -j9 Ω b a j6 Ω j6 Ω 20 Ω 20 Ω -j9 Ω 10 Ω

A:

Q: Expalin the 8085 flag rigister in detail

A:

Q: 3. The primary and secondary windings of a 30 kVA, 6000/230 V transformer have resistances of 10 and…

A:

Q: I need answers for V, Vi, Vii and Viii

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: In the dc-dc buck converter shown in the figure, Vin= 100 V and L = 0.5 mH. The duty cycle of the…

A: Assume that the inductor current is continuous.When the inductor current is continuous,…

Q: 5. The Traditionally applications for Satellite Communication Systems: a) Global telephone…

A: Satellite Communication:  A communications satellite is a man-made spacecraft that uses a…

Q: 4) Draw a logic diagram of a divide-by-14 counter using IC 7493 and 2-input AND gate.

A: Circuit diagram of inside the IC 7493 is as shown below:

Q: 3. What is the rated full-load current of a 34-horsepower, 208-volt single-phase motor?

A: In this question,  We need to determine the rated full load current of a 3/4hp , 208V single phase…

Q: Draw the logic diagram of the following logic functions: 1- P = (ABC) (ABC+C) A 2- F₂ CX5 +XY JZ +X…

A: Logic diagram: It is the logic circuit that is created by using the different types of the gates.…

Q: Q. The input for any circuit at lab experiments are O B. the switches OD. None of the above O C.…

A: While performing the experiments in Laboratory, the inputs is given at one terminal and switches and…

Q: With FM: Select your answer. During the modulating signal's maximal positive and negative peaks, the…

A: For FM signal which option is correct regarding frequency deviation: a.  During the modulating…

Q: 4. e principle of operation of a 3-phase. Induction motor is most similar to that of a (a)…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 1. The rotor of a 220-V., 60 Hz, 4-pole induction motor has a power input of 80 kW is observed that…

A: Copper loss: It is a loss in the form of the heat in the winding. This is undesirable for the…

Q: Given that Jamie worked 50 hours (Hours = 50) last week and earns $10.00 an hour (Kate =10), how…

A: Given data, Total number of hours = 50 Earning per hour is $10

Q: 6. What is the full-load current of a 600-volt, 3-phase, 50-horsepower induction motor?

A:

Q: Draw the circuit diagram and explain the operation of power factor improvement by using (i)…

A:

Q: Why is it not safe to reset a Circuit Breaker that tripped twice in a row?

A: Given: Circuit breaker

Q: It's simply the proportion of the actual frequency deviation to the maximum frequency deviation.

A: Percent modulation is the proportion of the actual frequency deviation to the maximum frequency…

Q: 1) Determine iff the system bellow is controllable and/or observable 1 0 x (k+ 1) = -1 (4) + [ - ]…

A: It is given that: xk+1=10-1212xk+1-1ukyk=51xk

Q: Determine the pitch factor for winding: 36 stator slots, 4-poles, coil spans 1 to 8. 1. cos 20⁰ 2.…

A: Given, Number of slots = 36 Number of poles = 4 Total coil span = 1 to 8…

Q: 1. You are given an equation: 100 cos[(2 x 105 t) + 35 cos(100nt)]. From this expression, Determine…

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you…

Q: Find I(t) t = 0 12 Ω 24 Ω 6A i(t) 5Ω 2Η Answer: 2e-2t A, t > 0. Μ 8 Ω

A: We need to find out the current for given circuit

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω m j6 Ω -j9 Ω bo j6 Ω 20 Ω 20 Ω j9 Ω 10 Ω

A: In this question,  We need to determine the impedance Zab  in this given network?  We are solving…

Q: 1 12 kVA at power factor of @ the average calculate 0.86 agging from a sinusui dal source. and…

A:

Q: 1. A 50 kVA, 6360/240 V transformer gave the following test results : S.C. test: Voltage across…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.