Please answer all subpart please sir ASAP for like this.. A series AC circuit is composed of a 75 Ohms resistor, 25 mH inductor and a 0.02 μF capacitor. The circuit is suppliedby a 15 V source. Calculate:the resonant frequency: Numberthe bandwidth: NumberHzthe upper cut-off frequency: Numberthe Q factor: NumberHzHz, the lower cut-off frequency: Numberthe voltage across the inductor (in polar form): Number/_Numberdegrees VHz

Answered: Image /qna-images/answer/4e5bf13c-874c-4d7b-bef3-1bb202330189.jpg

ries AC circuit is composed of a 75 Ohms resistor, 25 mH inductor and a 0.02 μF capacitor. The circuit is supplied 15 V source. Calculate: esonant frequency: Number bandwidth: Number Hz upper cut-off frequency: Number factor: Number Hz Hz, the lower cut-off frequency: Number voltage across the inductor (in polar form): Number Number degrees V Hz

ries AC circuit is composed of a 75 Ohms resistor, 25 mH inductor and a 0.02 μF capacitor. The circuit is supplied 15 V source. Calculate: esonant frequency: Number bandwidth: Number Hz upper cut-off frequency: Number factor: Number Hz Hz, the lower cut-off frequency: Number voltage across the inductor (in polar form): Number Number degrees V Hz

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 1PA: You are an electrician working in a plant. A series resonant circuit is to be used to produce a high...

See similar textbooks

Similar questions

You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
An AC series circuit has a resistance of 10 ohms, and inductance of 0.2 H, and a capacitance of 60 micro Farad. Calculate: (a) the resonant frequency, (b) thecurrent, and (c) the power at resonance. Given that the applied voltage is 200 V. draw the circuit diagram
At what frequency of a series ac circuit consisting of a coil resistance of 10 ohms and inductance 50 mH and capacitance 0.05 μF will resonate. Find also the current flowing at resonance if the supply voltage is 100v.
A 0.796 mH inductor produces an inductive reactance of 50 ohms at 10kHz. What value of capacitance will be needed to produce a resonant circuit at this frequency?
An inductor, a capacitor, and a resistor are all connected inseries across an ac source. If the resistance, inductance, and capacitanceare all doubled, by what factor does each of the following quantitieschange? Indicate whether they increase or decrease: the resonance angular frequency
A capacitance 50microfarad and an inductance of 0.2025 Henry are connected in series. if the resistance of the circuit is negligible find the frequency at which resonance occurs
388 / 5000 Çeviri sonuçları In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6 kΩ, RE = 1.5 kΩ and RL = 3.3 kΩ and β = 150.Since the capacitances are C1 = 0.5 μF and C2 = 0.53 μF, what is the low cutoff frequency of the given circuit? NOTE-1: In the middle band frequency, β = 150 will be taken and the frequency dependence of β will not be taken into account. NOTE-2: The output impedance of the transistor r0 will be neglected in the calculations.
6. a sinusoidal current is in phase with the voltage. It has an active power of 50VARS and reactive power of 10VARS. what is its apparent power? A. 71 VARS B. 41 VARS C. 51 VARS D. 61 VARS 7. An RLC series circuit has a resistance of 250ohms, 25microFarad capacitance and 57mH inductance. determine its impedance considering the circuit is at resonance condition. A. 150 ohm B. 230ohm C. 250 ohm D. 300 ohm
A 20,000-cycle source is connected to a series circuit consisting of a 50-ohm resistor and a 0.266 microfarad capacitor. An impedance coil, whose resistance and inductance are 25 ohms and 0.191 mh, respectively, is then connected in series with a variable resistor, after which the combination is paralleled with R-C circuit. What value of the variable resistor will the entire circuit be in resonance?
A circuit consists of an inductor which has a resistance of 10 Ω and an inductance of 0.3 H, in serieswith a capacitor of 30 μF capacitance. Calculate(a) the impedance of the circuit to currents of 40 Hz (b) the resonant frequency (c) the peakvalue of stored energy in joules when the applied voltage is 200 V at the resonant frequency.Answer: [58.31 Ω; 53 Hz; 120 J]
A coil of resistance 20 Ω and inductance 0.2 mH is in parallel with a variable capacitor. If the supply is at a frequency of 1 kHz, what should be the value of capacitance that will make the circuit run at resonance?
A circuit, having a resistance of 4.0 Ω with an inductance of 0.5 H and a variable capacitance in series, is connected across a 100 V, 50 Hz supply. Calculate: (a) the capacitance required to attain resonance; (b) voltages across the inductance and the capacitance at resonance; (c) the Q factor of the circuit