See the circuit attached where C = 1μF, L = 5mH and R = 100Ω.  Suppose that the voltage source Vs​ = 0 for a long time prior to t=0, then changes abruptly to Vs​ = 15v for t > 0. What would be the resulting Vc​ for t > 0

Q: R1 R2 i Us v| X %3D s] In the circuit above, use R, = 42, R, = 52, and v,(t) = 80u(t) V. a. Assume…

A: Given that;R1=4ΩR2=5ΩVst=80u(t)V and circuit is given below;

Q: In the RL circuit shown below, the switch is open for a long time and closes at t = 0. If Is =…

A:

Q: 7.11.1 For the RL circuit shown in the image below, the switch has been closed for a long time, and…

A:

Q: (S/3x) mF i(1) 42. + R2 R: 3v. (1) (1/10n) H3.

A: Note: Since you have posted a question with multiple subparts, we will solve the first three…

Q: th inductance L = 0.2 H and negligible resistance is com ritch S, and two resistors, R, = 15 N and…

A:

Q: 2. 7.36 PSPICEMULTISIM The switch in the circuit shown has been in position a for a long time. At…

A: STEP 1 Circuit at t = 0-. Apply KVL at middle node of above figure, The expression for iL(0-) is…

Q: The switch is closed for a very long time. At time 0s, the switch is opened. a.) Solve for vo(t)…

A:

Q: For the figure shown below, 1-Find the voltage labeled v at t = 0.2 ms . 2 -Draw the circuits at t≤0…

A:

Q: In the figure below, the switch will close at t-0. Using step-by-step method, find i,(t) for t>0.…

A:

Q: 3. The circuit given in Figure 4 is at steady state before the switch is opened at t=0. After the…

A:

Q: The circuit given in Figure 4 is at steady state before the switch is opened at t=0. After the…

A:

Q: Q.3) As shown in Figure Q.3, find an expression for i(t) which is valid for t> 0.

A:

Q: The voltage v(t) describe by the equation below is a cross a 0.5 uF capacitor . C 0, t <0s; Os…

A: Given data: C=0.5 μF

Q: In the circuit below, when the switch is open for a long time, it is done at t=0. Accordingly, for t…

A:

Q: 1. 7.1 The switch in the circuit shown has been closed for a long time andis opened at t=0.5. e)…

A: For t &lt; 0 the circuit was closed for long time.  So, the inductor will be short circuited. The…

Q: Consider the following circuit. In the circuit, V1=8V, V2= 10V, Rq=5N, R2=5N, R3=42, R4=42,L=2H,…

A: The switch was closed for a long time . So the inductor was behaving as a short circuit t=0-. So,the…

Q: (b) The switch in the circuit shown in Figure Q.3(b) has been in position 1' for a long time. At t =…

A: Voltage across the capacitor doesn't change instantaneously i.e. Vc (0+) = Vc(0-) current through…

Q: B) For the circuit shown below, the switch is opened for a long time, at t=0 it is closed. i) Find…

A:

Q: For the circuit shown below, E = 66 V, R, = 15 N, R, = 30 N, R, = 45 0, and L = 4.0 mH. Find the…

A:

Q: The voltage pulse applied to the 100 mH inductor shown is 0 for t&lt;0. and is given by the…

A: Given: Voltage and time relation across an inductor.

Q: Part B For the given circuit, i, = 5.71 A, iz = 4.08 A at t = 0.5 s. Determine the energy stored in…

A: It is given that: b)i1=5.71 A,i2=4.08 A at t=0.5 s,k=0.7,L1=7H,L2=6H,R1=6Ω,R2=2Ωc)i1=4.54 A,i2=2.62…

Q: Calculate the ratio vC/vT. Enter your answer rounded to 2 decimal places. All capacitors were…

A: Calculate the ratio vC/vT. Enter your answer rounded to 2 decimal places.   All capacitors were…

Q: In the circuit below, the switch opens at t = 0 after being closed for a long time. It opens at T>…

A:

Q: B) For the circuit shown below, the switch is opened for a long time, at t=0 it is closed. i) Find…

A:

Q: Find i and v, in the circuit of Fig. 7.15. Let i(0) = 5 A. Practice Problem 7.3 42 Answer: 5e4 V,…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: The switch in figure.1 has been open for a long time and is closed at t = 0. If L = 1H, C = 0.5µF, R…

A: For the given series R-L-C circuit, the switch is closed at time t=0 second. Before closing of…

Q: For the circuit of Figure 3, the parameters are: I; = 2A, L = 5mH, C = 5 mF, R, = 102, R1 = 1.81 2,…

A:

Q: Question 3 The switch in the circuit has been closed for a long time, and it is opened at t-0. Find…

A:

Q: t=0 s 31- ()3A 3102 Ž1o2 v.(t)=0.1F O A) 10.75 V B) 9.27V O 9 11.29 V D) 8.13V E) 9.74 V

A: RESISTOR (R): A resistor is a passive electrical component with the primary function to limit the…

Q: An RCL circuit connected in series has R = 180 ohms, C = 1/280 farad, L = 20 henries, and an applied…

A:

Q: In the following circuit, the voltage source is supplying 47.42 V. The switch remains close for a…

A:

Q: Problem 6: Consider the following circuit, where • the voltage source v, (t) = u(t) implements a…

A:

Q: 7. 7.27 In the circuit  the voltage and current expressions are v=48e−25t V, t≥0;i=12e−25t mA,…

A: Given data, The value of voltage is v = 48e-25t V. The value of current is i = 12e-25t V. a) The…

Q: 7. 7.7 PSPICEMULTISIM The switch in the circuit  has beenclosed for a long time. At t=0 it is…

A: At t = 0-, switch closed inductor behave as short circuit  Suppose node voltage at 75 ohm is voltage…

Q: 6 - In the circuit given below let R=2 Q,&=10 V, and C=1µF. The capacitor is uncharged before…

A: For the given transient circuit we need to find a current in the circuit at 2 microseconds

Q: Q.4) In the circuit shown in Figure Q.4, find an expression for v, (t) which is valid for t> 0. 1 =…

A: In this question , we will find expression for voltage across 4 kohm...

Q: The characteristic equation of a given system is: s* +6s³ +1 1s² +6s +K = 0 3 What restrictions must…

A:

Q: Q.3 (a) Figure Q.3a illustrates a circuit for representing an electrical system consisting of…

A: Brief description:  From the  given question it is very clear that here we have an electrical…

Q: 1. The switch in the following circuit closes at t = 0 (assume no initial charge on the capacitor).…

A:

Q: * Question Completion Status: QUESTION 5 t= 0 R1 Vc(t) R3 V1 R2 V2 For the above circuit, the switch…

A: given data:

Q: Q.1 The switch in the circuit of Figure Q.1 has been at position "a" for a long time. At t = 0, the…

A:

Q: Q.1 The switch in the circuit of Figure Q.1 has been at position "a" for a long time. At t = 0, the…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: When the unit step function is applied to the system input whose block diagram is given below, the…

A:

Q: t=0 The circuit has been running for a long time prior to the switch 50 Q closing at t=0. The supply…

A:

Q: (c) The voltage, v, across an inductor L, in an electrical circuit drops Exponentially over time, t.…

A:

Q: (b) The switch in the circuit shown in Figure Q.3(b) has been in position '1’ for a long time. At t=…

A: For the capacitor voltage across it doesn't change instantaneously i.e. Vc (0+) = Vc(0-) For the…

Q: For the circuit shown in the following figure, if L= 20 H, Va-28 V, and Re 20 0, answer the…

A:

Q: Q2: Answer two of the following questions: a) For the circuit shown in fig.(2), v = 10e V and i=…

A: Note : Since all the above mentioned questions are not interlinked to each other hence we need to…

Q: نقطة واحدة the switch in the fig, below have been closed for along time, and then opened at time…

A: We will find inductor current and capacitor voltage for time time less than zero. As inductor does…