Answered: Shield wires located above the phase…

Engineering

Electrical Engineering

Shield wires located above the phase conductors protect the phase conductors against lightning. a. True b. False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.5MCQ: Shield wires located above the phase conductors protect the phase conductors against lightning. True...

See similar textbooks

Related questions

Q: 9 what is the relationship of voltage and current (concerning phase angle) in a pure inductive…

Q: Transfer function (8)= 25+5 2²765+25 H Vo (S) Vin(3) Determine the impulse response.

Q: Consider an LTI system depicted in figure below with the input sequence x[n] = (-0.5)" µ[n]. find…

Q: 2. The textbook describes a circuit for comparing two 4-bit numbers, A = a3ª2ª1ª0 and B = b3b2b₁b0.…

Q: List the visual checks that should be made on a piece of portable electrical equipment before using…

A: We need to write list of visual checks that should be made on a piece of portable electrical…

Q: Vin(t) + Ps D R₂ 8 ΚΩ R4=AkQ ww w R3=3 kQ + Vout(t) C E 2 65°F S

Q: 4. 2z For H(z) answer the following questions. [(z-2)] a) For x(n) = u(n), find X(z). b) If the unit…

A: In this question we need to find the following Find X(Z) Find Y(Z) if unit step input in applied to…

Q: What will be the value of the Unknown inductance Lx (in mH) and the effective resistance Rx (in 2)…

Q: We want to investigate how the field strength will be with air as dielectric and with steatite. A…

A: Parallel plate capacitor, Line voltage, VL=24 kV. Area of parallel plate A=1 m2. Distance between…

Q: The convolution between the two sequences x₁ (n) = [1, 2, 3] and x₂ (n) = [3, 2, 1] is y(n) = [1, 2,…

A: Given- Two sequences, x1n=1,2,3x2n=3,2,1 To find- The convolution between two sequences.

Q: 1. a) Sketch the block diagrams of the natural and flat-top sampling (PAM) circuits. What is the…

Q: How much is Vab in the circuit. 9 Ω 12 V 4Ω a -Ö + Vab- 8 Ω Μ 3Ω Μ 1Ω

Q: The waveform given below is observed on the screen of a CRO. If the time/div switch is set at 10…

A: Given waveform- Time/div. = 10 μsec/div. Volt/div. = 200 mV. To find- Frequency and peak voltage.

Q: 300 KVA, 6600/440 V, 50 Hz 3-phase, delta/star core type transformer A suitable 3-step core with a…

A: We have to Estimate the main measurements, including the winding conductor area, accordingly.

Q: What is the voltage gain for the medium frequencies of the circuit in the figure?

A: In the given questions we need to calculate the voltage gain of the amplifier.

Q: The sacrifice factor of the op-amp is equal to Select one: O a. Aol + Ad O b. 1+ Aol B O c. Aol -…

A: Sacrifice factor : Sacrifice factor is defined as the ratio of open loop gain and the closed loop…

Q: A resistance of 16 Ω is connected in series with a pure inductance of 39.9 mH and the circuit is…

A: R = 16 ohm, L = 39.9 mH, V = 100 V, F = 50 Hz

Q: 3. Consider the functions (t)= exp(-|t) and Determine the constant A, such that ₁ (t) and 2(t) = 1 -…

A: Given Data: The continuous-time signals of, ψ1t=e-t ψ2t=1-Ae-2t To Find: Value of A when the…

Q: 21 when a capacitor and resistor are connected in parallel how many degrees out of phase are the…

Q: The sacrifice factor of the op-amp is equal to Select one: O a. Aol + Acl O b. 1 + Aol B O c. Aol -…

A: Choose the correct option: The sacrifice factor of op-amp is equal to ...... options: Aol+Acl…

Q: In the core conductor given below, the radius of each core is r. the GMR of this conductor as r.

Q: Find the Thevenin equivalent at terminals a-b of the circuit 4Ω 2/0° A -j3 Q o a 1.51x b

Q: 4. Consider the timing diagram below. Assuming that the D and Clock inputs shown are applied to the…

A: For the given input signal the output of the circuits needs to be drawn. The first one is the D…

Q: 4.5 Write the differential equation for t> 0 for vc in Figure P4.32. t=0 DIO R₁ am R₂ Figure P4.32 +…

Q: determine the fifth roots of -32 . Leave answers in polar form

A: Let x be the fifth root of -32 So x = (-32)1÷5

Q: 4. For what value of Rp is the voltage across Vps zero? V 5 μF 카 2.1 ΜΩ 270 kn +16 V RD 2.4 kn 10 uF…

Q: You have a voltage source of 10 V and require a voltage of 8 V for the (very large resistance) load…

Q: Consider the given network where h21 = a = 150. Obtain Vo/ Vs. Vs 1 ks2 h₁= 500 52 h12= 10-4 h₂1 =a…

Q: Q4. Find a) The Thevenin equivalent circuit between the terminals a and b. b) The maximum power…

Q: Ingivenzenercircuit, Vz 5V, Pz=30Mw. Calculate R1 resistancevaluerangethatcircuit can workproperty

Q: 9V 1k 3k 2k 4k 2k + I 8k Vout

Q: HOITOT compone B. Discuss briefly the operation of Staircase Ramp-Type DVM

A: We need to discuss briefly the operation of Staircase Ramp-Type DVM.

Q: a. Find the current through resistor R2 b. Find the power dissipated by resistor R2. Resistor R3 is…

A: For the given circuit the current through the resistor R2 and power dissipated across the resistor…

Q: The input to the circuit shown in the following figure is the voltage of the voltage source vs (t) =…

Q: A CRT terminal is used to enter alphanumeric data into a computer. The CRT is connected to the…

A: Bandwidth, BW=3000 Hz.S/N=10dB.Characters, n=128.

Q: For the op-amp filter circuit shown above, assume C₁ = 10nF, R₁ = 1k, and Rf = 5kN. Find the…

Q: 14. An air – filled rectangular waveguide of internal dimension a cm x b cm (a > b) has a cut off…

A: Dimensions of waveguide Wide dimension a cm, Narrow dimension b cm Cut off frequency fc=6 GHz for…

Q: Assume piecewise linear function with one segment one is used, and the cost function of each of…

A: According to the question, we need to find the slope of piecewise linear function as shown below,…

Q: 1. Label 3 currents and all resistor voltages. 2. Write 2 KVL equations and 1 KCL equation. 3. Write…

A: It is given that:

Q: The circuit shown below is at steady state before the switch opens. Determine the v(t) for t> 0.…

Q: a) As depicted in the figure, input voltage is 120 Volts (RMS) and diode drops are 0.7 Volts. Design…

A: Need to design the circuit and find the value of the transformer ratio based on the given output…

Q: A resistor and an inductor are connected in parallel. The resistor has a resistance of 24 ohms, and…

A: Given R = 24 ohms, XL = 20 ohms To find impedance Z

Q: Exercise-1 Vs = 240V 60Hz Is=10A/....... Power system Is ww R ΙΚΩ Xc=-j/(2pi60x0.00016)=-1994…

A: In this question we need to find the current Is shown in the given circuit.

Q: 3.- Find the h parameters for two port network. The Dark -) gm v¹ the given

Q: How is concept of voltage in electrical circuits is related to the concept of energy

A: relation between voltage and energy in electrical circuits.

Q: 2002 1₁ 10Ω 1002 100V 2002 10Ω 50V 11 = 7A Apply Mesh Current Method to calculate the current, in…

Q: Find the Thevenin equivalent at terminals a-b of the circuit

A: It is given that:

Q: You are working on a residential heat pump. The heat pump is connected to a 240-V, 60-Hz power line.…

A: Voltage =240VFrequency =60HzPower factor =0.7Current =34AΩWattage of heat strip =10kW

Q: Describe the working principle of loop/sense antenna in ADF. Then, draw the resulting radiation…

A: It is asked to describe the working principle of loop/sense antenna in ADF. Also we need to draw the…

Q: Q4) Consider the circuit given below. 40 V + 492 ww 4Ω 2Ω www + Vx 0.5vx ww 10 Ω a) Obtain the…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Shield wires located above the phase conductors protect the phase conductors against lightning.
a. True
b. False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Overview:

VIEW

Step 2: Explanation:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The units of admittance, conductance, and susceptance are siemens. (a) True (b) False
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
A three-phase 60-Hz transmission line has its conductors arranged in a triangular formationso that two of the distances between conductors are 25 ft. and the third distance is 42 ft.The conductors are ACSR Osprey. Determine the inductance and inductive reactance perphase per mile.
In a 10 km long three phase line the diameter of the conductor is 25 mm hence the conductors are symmetrically arranged with a space of 2 m.So find the capacitance per phase.
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diameter of each conductor is 1·24 cm. Find the capacitance of each conductor to neutral per 100 km of the line.
A 3-phase 80 km long single circuit 66 kV transposed overhead line has horizontal spacing with 5 m between adjacent conductors and 6 m between outer conductors. The conductor diameter is 2.5 cm. Find the Inductance per phase
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
the three conductors of a three-phase line are arranged at the corners of a triangle of sides 1.5 m, 2 m, and 2 m. calculate the inductance perm of the line when the conductors are regularly transposed. the radius of each conductor is 0.4 cm.
In a single-phase transmission line circuit, three 0.25 It consists of a conductor with a radius of cm (a, b, c). The return circuit likewise consists of three parts of the same radius. consists of two conductors (d, e, f). of conductors placement is given. of each conductor Calculate the inductance and the total inductance.
Discuss why a. Complex power in an AC circuit is more than the DC resistance. b. Receiving end voltage of an unloaded long line may be more than sending end voltage. c. Inductance of the three phase of a transmission line are generally not equal. d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
a single-phase transmission line has two parallel conductors, 1.5 meters apart. the radius of each conductor is 0.3 cm. calculate the inductance per meter of the line.