Short Problem: Given a series circuit comprised of the following element: 74.45-ohm resistor, practical inductor with internal resistance of 0.9
Q: Across a 230V, 60HZ power supply is a pure inductor with inductive reactance of 15 ohms Write the…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 51.31-ohm resistor,…
A:
Q: Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages…
A:
Q: Using the given circuit, calculate: 1) Equivalent capacitance 2) Charge across each capacitor 3)…
A: Solve the problem
Q: 2.) An uncharged capacitor in series with a 120-volt voltmeter of 12,000 ohms resistance is suddenly…
A: The solution is given below.
Q: 6. An inductor rated at 8 H is subjected to a sinusoidal AC voltage of 6 volts, at a frequency of…
A: When inductor is connected to an AC supply,then it Inductance will be same but it's reactance will…
Q: Two coupled coils have inductance of L1 = 0.8 H and L2 = 0.2 H, respectively. If the coefficient of…
A:
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A:
Q: The circuit shown below has the following parameters: C1 = 11 µF, C2 = 8 µF, C3 = 17 µF and V = 160…
A: Capacitance: Capacitance of a capacitor is defined as the ratio of amount of charge stored in the…
Q: A resistance of 50 N is connected in series with a capacitance of 20 µF. If a supply of 200 V, 100…
A: Given data Resistance is R = 50 ohm Capacitance is C = 20 micro farad Supply voltage is V = 200 V…
Q: Example: A 500 mH inductor is supplied from a 115 V source with a frequency of the 60 Hz. Calculate…
A: L=500 mHV supply Vs=115 v∠0∘frequency =60 HzInductive reactance =XL=(jwL)XL=j×(2π×60)×500×10-3…
Q: The capacitors are connected in a network as shown below. Compute the equivalent capacitance of the…
A:
Q: b). For the circuit shown below, calculate the equivalent capacitance of the circuit if the…
A: In this question we will find equivalent capacitance of circuit..
Q: 1. A pure 20 mH inductor is connected to a 30 V, 50 Hz supply. Calculate (a) the reactance at this…
A: Given, L=20 mHf=50 Hz Reactance (X) =j 2×π×f×L X=j 2×π×f×L =j 2×π×50×20×10-3 Ω=j 6.28 Ω
Q: a coil of 10 ohms resistance and 0.1 H inductance is connected in parallel with a capacitor of…
A:
Q: inductance
A:
Q: Q3: For each of the following, indicate True or False: 4- The frequency (f) is measured in Hz where…
A: we need to find the above statements are true or false. As per our guidelines we are supposed to…
Q: Calculate the voltage at the terminals of a coil of resistance 10 ohms and inductance 15H at the…
A: In this solution the concept related to the practical inductor is discussed
Q: . For the circuit shown, what is the reactance of the capacitor? (Ohms) 2. What is the real power…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 57.81-ohm resistor,…
A:
Q: 4. Find a. The equivalent capacitance of the network b. If point A and B are connected to a 12v…
A: a. Find the equivalent capacitance of the work;…
Q: Short Problem: Given a parallel RLC circuit comprised of the following element 69.73-ohm resistor,…
A:
Q: Given a parallel RLC circuit comprised of the following element: 99.3-ohm resistor, ideal inductor…
A: In this question we need calculate true power .
Q: Short Problem: Given a parallel RLc circuit comprised of the following element 62.96-ohm resistor,…
A:
Q: Simplify the circuit below to determine the equivalent capacitance. Fill up the table of properties…
A: C3 and C4 are in series. Hence their equivalent-C'=C3C4C3+C4=6×126+12=4μFNow, C2 and C' are in…
Q: Find the equivalent capacitance with respect to the terminals a, b for the circuit shown below 20 nF…
A: When two capacitors are in series, then the equivalent capacitance is 1cS=1C1+1C2 When two…
Q: 4. A capacitor of 3.18 microfarads is connected in parallel with a resistance of 2000 ohms. The…
A: capacitance connected in parallel with resistance gives,…
Q: Compute the equivalent capacitance of the network
A:
Q: A 1kQ resistor, a 5mH ideal inductor, and a 1nF capacitor are connected in parallel. Find the total…
A:
Q: Ina transmission line, to reduce the inductive coupling, one should Reduce the inductance None of…
A: In a transmission line inductive coupling depends on distance between the transmission line ,…
Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.
A:
Q: A coil absorbs 20 W when connected to a 240 V, 400Hz. if the current is 0.2 A, find the resistance…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 62.52-ohm resistor,…
A: True power will be power dissipated in resistor . So we will find out current for resistor then we…
Q: Course: Electrical Engineering Subject: Electrical Apparatus Instructions: • Write the GIVEN with…
A:
Q: Example: Three inductors have values L₁ = 10 mH, L₂ = 100 MH, and L3 = 500 MH. Determine the total…
A:
Q: A coil of 50 W resistance and 0.15 H inductance is connected in parallel with a capacitor of unknown…
A:
Q: An inductor has a wire resistance of 6 ohms, The Q of the inductor is 9. Using the formula: XL = Qx…
A: Given data Q = 9 R = 3 ohm
Q: Determine, in polar and rectangular forms, the current flowing in an inductor of negligible…
A:
Q: A 1kQ resistor, a 5mH ideal inductor, and a 1nF capacitor are connected in parallel. Find the total…
A:
Q: A capacitor is charged at a constant current of 2.5ma. If its emf is 500-volts at the end of 15 sec,…
A: Given: Current, I = 2.5 mA EMF, V = 500 volts Time, t = 15 sec
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A:
Q: An uncharge capacitor in series with a 120-volt voltmeter os 10,000 ohms resistance is suddenly…
A:
Q: 1) Determine the equivalent inductance of the network in Figure below if all inductors are 6 mH.
A: Note: As per our policy, I have attempted the first question. Given data: L=6 mH
Q: Given a parallel RLC circuit comprised of the following element: 92.68-ohm resistor, ideal inductor…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 63.27-ohm resistor,…
A: In this question, RLC Are connected in the parallel, find the reactive power in the VAr. We know…
Q: 8/An Electrical Fan is considered an Inductive Load. Select one: True False
A: Electrical fan is an single phase induction motor , in which coils are wound by some copper wire. So…
Q: Question 1 C= 2nF C= 3nF C,= 6nF C,= 4nF C- SnF V= 24V C= 2nF C= 2nF Using the given circuit,…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 53.37-ohm resistor,…
A:
Q: A coil of resistance of 8 ohms and inductance of 150mH in series with a 110 microFarad capacitor, is…
A:
Please answer quickly.
Step by step
Solved in 2 steps with 2 images
- The feeder is to be used with an antenna for which an inductive reactance is measured as j60 Ohms at 1.7 MHz. The resistive part of the antenna’s impedance is measured as 80 Ohms. Using the online impedance matching calculator, design a suitable impedance-matching network for each of the two cables if the coaxial cable has a characteristic impedance of 75 Ohms and the twin lead cable has a characteristic impedance of 300 Ohms, so that the inductance is in the longitudinal branch, while the capacitor is in the transversal branch of the impedance matching network. Do not round the resulting values.A choke coil of resistance 8 ohm and inductance 0.15 H is connected in series with a capacitor of capacitance 125 ?? across a 230-V, 50- Hz supply. Calculate: (a) the inductive reactance, (b) capacitive reactance, (c) impedance, (d) current, (e) voltage across the coil and the capacitor, respectively. (f) phase difference between the current and the supply voltage.TOPIC: Transmission Lines, Power Systems, and Powerplants:INSTRUCTIONS:- Answer in this format: Given, Illustration, Required Conversion, Solution, Final Answer.- Step-by-step solution, do not skip even simple calculations to avoid confusion.- If answered in written form, make sure it is readable.PROBLEM:A three-phase, three-wire, 500-V, 60-Hz source supplies a three-phase induction motor, a wye-connected capacitor bank that draws 2 KVAr per phase, and a balanced three-phase heater that draws a total of 10 kW. The induction motor is operating at its rated 75 Hp and has an efficiency and power factor of 90.5 and 89.5 percent, respectively. Determine the system KVA. 78.12 75.98 24.81 83.17
- Given a series circuit comprised of the following element: 68.13-ohm resistor, practical inductor with internal resistance of 0.34 ohm and reactance of 47.15 ohms; and a capacitor with reactance of 7.53 ohms. Compute for the magnitude of its equivalent impedance in ohms. Do not round off during computation. final ans 4 decimal placesGiven a series circuit comprised of the following element: 53.06-ohm resistor, practical inductor with internal resistance of 0.52 ohm and reactance of 39.04 ohms; and a capacitor with reactance of 19.17 ohms. Compute for equivalent impedance angle in degrees. Note: No Scientific notation. Do not round off in the middle of calculation. Use stored values. Please round off to the nearest 4 decimal places for the final answer.When this resultant voltage is applied to a circuit consisting of a 10-Ω resistor and a capacitance of 17.3 Ω reactance connected in series, find an expression for the instantaneous value of the current flowing, expressed in the same form
- please explain steps-by-steps solution tqA three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mi. can you tell me what the 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)The sending-end voltage in the circuit seen is adjusted so that the load voltage is always 13,800 V(rms). The variable capacitor is adjusted until the average power dissipated in the line resistance is minimum. 1. a) If the frequency of the sinusoidal source is 60 Hz, what is thevalue of the capacitance in microfarads?2. b) If the capacitor is removed from the circuit, what percentageincrease in the magnitude of Vs is necessary to maintain 13,800V(rms) at the load?3. c) If the capacitor is removed from the circuit, what is thepercentage increase in line loss?
- An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henryis connected in series with a variable capacitor. If a 117 volt 60 cps source isconnected to the circuit, what will be the capacitance of the capacitor and the current(a) when the circuit has a power factor of 0.866 leading and (b) when the voltagedrop across the coil is equal to the voltage drop across the capacitor?Capacitor Banks that can be used to simulate the Load is provided in the Distribution Line Simulator. Select one: True FalseTwo equal voltages are out of phase with respect to each other by 90 electrical degrees. If the resultant is 311 Volts, what is RMS value of each one?-write legibly-show the complete solution