Show that Reynold number, pud/µ, is non-dimensional. If the discharge Q through an orifice is a function of the diameter d, the pressure difference p, the density p, and the viscosity µ show that Q = C p²d²/p² where C is some function of the nondimensional group (dpp/µ). 1/22 1/2 %3D 1/21/2

Q: 19. The diffusivity of Methanol at 288 K and 1 atm is 1.28*10° m²/s ,find the diffusivity value at 2...

A: Diffusivity at given conditions is asked.

Q: What is the motivation of using Methanol fuel for electricity generation in rural areas replacing di...

A:

Q: Write a single program to perform the following tasks:                                              ...

A: Actually, program is a executable software that runs on a computer.

Q: An alcogas mixture made up of 85% gasoline (ocatane no. = 95) and 15% ethanol is used as a fuel for ...

A:

Q: The pka of propanoic acid is 4.88. Describe what the relative concentrations of propanoic acid (the ...

A: Write the Henderson-Hassel Balch equation as follows: pH = pKa+logconjugate baseacid     ......1   G...

Q: 26

A: Answer: a) Slip plastic deformation

Q: For the absorption of solute A through a falling film, its Peclet number, Npẹ is in proportion to Se...

A:

Q: Q1) A shaft 6.00 cm in diameter and 40 cm long is pulled steadily at velocity V = 0.4 m/s through a ...

A: Given data: Diameter of shaft = 6 cm Length of shaft = 40 cm Velocity = 0.44 m/s Diameter of sleeve ...

Q: which layer (organic or aqueous) would quinine partition into during extraction? 3M HCL or dichlorom...

A: Extraction is the process in which one or more components are separated based on their solubility in...

Q: What are [Na+][Na+], [Cl−][Cl−], [Ca2+][Ca2+], and [H+][H+] in a solution containing 0.10 M each of ...

A: Chemical reaction equilibrium is defined as the state where the concentrations of the reactants and ...

Q: If –rA = - (dCA/dt) = 0.2 M/sec, when CA = 1 M, What is the rate of reaction when CA =10 M

A: For a chemical reaction rate of reaction is the speed of the reaction i.e. how fast the reactant is ...

Q: Can you give the full solution for this problems.   5. A rigid vessel contains 5 kg of wet steam at ...

A: Note: Since we are entitled to answer only 1 question, we’ll answer the first one. Please resubmit o...

Q: How many grams of water should be added to 50.0g of NaBr to make 4.50% by mass solution

A: Weight of NaBr= 50 g final concentrated solution =4.50%

Q: The volume rate of flow, Q, through a pipe containing a slowly moving liquid is given by the equatio...

A: Physical quantities are expressed as two types, Quantities regarding the basic quantities such as le...

Q: A zero-order reaction (A --> 4B) is to occur at a temperature of (127 C) in a variable volume batch ...

A: Order of the reaction A→4B is zero Temperature T1 = 127 °C Initial concentration of A is CA0 = 4 gmo...

Q: 6.1 A manufacturer blends lubricating oil by mixing 300 kg/rmin of No. 10 oil with 100 kg/min of No....

A: Note: As per the guidelines, we’ll answer the first question since the exact one wasn’t specified. P...

Q: Given RH 27.5%, wet bulb temperature 100 degrees F. Calculate what is the dry bulb temperature, dew ...

A: The dry bulb temperature, dew point, absolute humidity, specific volume and enthalpy has to be calcu...

Q: QUESTION 5 When 100g of water at 50 °C is mixed with 100g of water at 20 °C. which way does the heat...

A: Note: We will answer the first question since the exact one was not specified. Please submit a new q...

Q: There are two major filtration methods taught in this course: gravity filtration, and vacuum filtrat...

A: Filtration is a mechanical operation that is used to separate the solids that are suspended in a liq...

Q: c) Calculate the values of vmp, vavg, and vrms for xenon gas at 298 K.d) From the values calculated ...

A: Hello, you have posted multiple questions, e are solving the first one here. Please repost the other...

Q: Calculate the acidity and basicity degrees for the slag composed of 56 % SiO2; 18 % FeO; 5 % Cao, 21...

A: In metallurgical processes like ferrous melts in various furnaces, the remaining residues are called...

Q: 21

A:

Q: A 60mm diameter pipe of circular cross section and with walls 2 mm thick is covered with two concent...

A: Given: The inner diameter of the pipe is, Ri = 60 mm = 0.060 m Thickness of the pipe, tP = 2 mm = 0....

Q: 1. An ethanol –water solution in the form of a stagnant film 2 mm thick at 293 K is in contact atone...

A:

Q: Wet bulb temperature 95 degrees Fahrenheit, RH 35%. Calculate dry bulb temperature, dew point, entha...

A: Wet bulb temperature = 95°F =35°C Hence, C5=95-329 or, C=35°C Therefore, diabetic saturation tempera...

Q: In the process of drying carrots using a parallel flow drying system, the material with a moisture c...

A:

Q: I only wish you to drawn approximate, hand-drawn qualitative curves. However, you should demonstrate...

A: Competitive inhibitor reaction: Competitive inhibitor binds to the active site thereby preventing su...

Q: What is the role of paired electrode f the abo

A: Hello Subscriber! There are two questions posted here, and the second one involves calculations inde...

Q: A student has prepared a solution containing two acids : H2A ( PK , = 2.1 , 7.2 ) and H2B ( pKg = 6....

A: When a weak acid releases a proton or H+ ion, it forms a conjugate base. A solution containing weak ...

Q: The molar heat capacity of a certain substance at different phases and temperatures is given below. ...

A: Given, Enthalpy change at 150 K, ∆H = 1254 J/mol melting point, Tm =150 K   Calculate the entropy ch...

Q: A. Graph anaylsis: cooling curve

A:

Q: Q.4 Fig. below shows a steam heater where the process fluid is heated with the help of steam. Find o...

A: Degree of freedom: Degree of freedom are the values that can be independently varied in the equation...

Q: I need to determine whether the source of uncertainty issystematic or random and explain why. If it ...

A: The air vent blowing onto weighing pan will induce error in the measurement value as the weight of a...

Q: Can a small sample of one substance have the same mass as a large sample of a different substance?  ...

A: Physical Properties: physical properties are the properties that can be easily identified by our nak...

Q: e. a liquid drain cleaner contains 8 kg of H2O and 12 kg of NaOH. 1. Determine the mass fractions of...

A: Mass of water=8 kg Mass of NaOH=12 Kg Molecular weight of water=18 Molecular weight of NaOH= 40

Q: a and b please

A: Absorption is a simple mass transfer process in which gas or liquid penetrates into the body of the ...

Q: Determine the specific weight, specific gravity, and mass of the natural gas (80% methane, 15% ethan...

A:

Q: How resolution of TOF can be improved?

A: Mass resolution is the term used in optical spectroscopy. It refers to the ability to separate the t...

Q: You are asked to explore the operating principles and efficiencies of hydraulic machines. You have a...

A:

Q: Q.27. Find number of aluminum (Al) atoms in a peace of pure (Al) block with dimensions equal to 2.0 ...

A:

Q: 2. Dimension of molar diffusivity is the same as that of: a) Pressure. b) Dynamic viscosity. c) Kine...

A: As per Bartleby guidelines we are supposed to answer only the first question. Kindly repost other pa...

Q: help...

A: Given: T = 100 oC P = 100 atm = 100×1.01325×105 Pa The gas is assumed to be Van der waals gas. Requi...

Q: Absorption Question from Separation Process

A: Dear subscriber as the question is bit lengthy and contains multiple sub parts . With respect to our...

Q: A first order reaction A-B is being carried out in a CSTR. The feed stream containing reactant "A" a...

A: Given that, A→B Feed stream concentration of A = Ci Product stream concentration of A = C0 Rate of t...

Q: packed bed towe methanol by using sectional area of 4000 cm? and system operates at 313.1 K and 101....

A: Giventhe process in a packed bed tower to purify air from methanol with its parametersequilibrium da...

Q: Q.4 The various parameters of a certain process for controlling temperature are plotted as shown in ...

A: Set point  variable with value: S is the set point variable with value. The value of set point is 12...

Q: Q3 When a thermometer at 30 °C is placed in water bath at 90 °C, the initial rate of rise in thermom...

A: In-process control, A first-order system is defined as a type of control system whose input-output r...

Q: A piece of meat, 3 cm thick, which can be considered as an endless plate, has a homogeneous initial ...

A: Heat flow from outside to the surface of body= Increase in internal energy of body

Q: Please answer completely

A: (d) Initially the water was at a room temperature of 29oC, as it started to boil, the temperature of...

Q: Express in Molarity, Normality and molality 99.5 % acetic acid by weight, having a density of 1.06 g...

A:

Units and Dimensions

Dimensions are the basic concepts of the measurement of quantities. Units are the means of expressing the dimensions. For instance, an area has a dimension of L2 and a unit of m2.