Si IR Vo +12 Vo 1.8 V Ip 680 N

Q: Q) Shunt PMMC was designed by using indirect method to provide an ammeter with current range 5A,…

A: This question belongs to electrical measurements . It is based on the calculation of shunt…

Q: 3-    In a PWM, what should be the duty cycle to get a voltage output of 4.5 V?   4-    Given the…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

A: PART (a): For a Coil, Z=R+jXL Where,  R= Resistance of the coil, XL=Inductive reactance of the coil.…

Q: Nodal Analysis Calculation steps) Analyze the circuit in Figure 1. Find the nominal (expected from…

A:

Q: Question 13: P 4.7-2 Determine the values of the power supplied by the voltage source and by the…

A: Simple problem on network.

Q: EVA 2300/250V 86.6% lagging pf en Circuit Test: 250V, 1A, 80W ort Circuit Test: 20V, 12A, 100W…

A: In this we have given open circut test and short circuit test readings...We have to find out…

Q: 2. Assemble the following program, starting address 200OH. P • MVI A, 8FH • MVI B, 68H • SUB B • STA…

A: The program are defined as MVI A, 8FH: 2 Byte instruction MVI B, 68H : 2 Byte instruction SUB B: 1…

Q: the closed loop solar water collector, only water can be used as collector fluid O True O False

A: False .

Q: 5. Disconnect the DC power supply, and then measured the equivalent resistance by using the AVO…

A:

Q: Three coils each having resistance of 30 Q are connected in star across 427 V, 50 Hz supply. Then…

A: total power consumed = 3×Phase voltage2Resistance for star connection, phase voltage = line voltage3

Q: Q13. In case of D.C. machines, mechanical losses are primary function of (a) Current (b) Voltage (c)…

A: Mechanical losses mainly consists of friction and windange losses.

Q: Question 3) A figure below shows a power electronics converter system that are used to obtain a DC…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: A d.c. shunt motor runs at a speed of 1000 r.p.m. on no load taking a current of 6 A from the…

A:

Q: A certain solar array consists of four 12 v250 modules connected in parallel. The short cireuit…

A: Given Data: Power = 250 W Voltage = 12 V

Q: control systems) How many RHP poles are there in the system s^5+7s^4+7s^3+7s^2+7s+1?

A:

Q: 2. The SONEL thermal plant in Limbe supplies SONARA with 1.0 The total resistance between the power…

A: (a) The output power of the thermal plant is given as: Pout=V2Rand here V=1 MV=1×106 VR=0.5…

Q: An electric range takes 8 kw and a air conditioning unit draws 10A . The lighting load is 500W and a…

A:

Q: The current passing a 1 kW electric hair dryer is 2.5 A; what is the voltage across the hair dryer…

A: Given: Power rating of dryer, P=1 kW Current, I=2.5 A

Q: Consider a wind turbine which gives maximum output power of 1MW at a wind speed of 15m/s. Choose the…

A:

Q: 13. A battery having an e.m.f. of 105 V and an internal resistance of 1 N is connected in parallel…

A:

Q: 1.3 The parameters of a PV module are Vmp=24.6V, Voc=27V, Isc=18.5A, and Imp=15.5A. The array is…

A:

Q: Commercially available PV panels today have efficiencies closest to about : A_20% B_50% C_1% D90%

A: In this answer we will try to understand what is a PV panel and how its efficiency is affected and…

Q: D Question 13 (b) What is the voltage gain, Ay of this configuration? 0.55 D Question 14

A:

Q: if A = 5000 Vp = 25 Vn = 20 then what is Vout please show detailed steps

A: Gain of the amplifier A = 5000 Positive terminal votlage = Vp = 25 V Negative terminal voltage = Vn…

Q: In the circuit shown in figure, when the firing angle of thyristor T is 90 degree, what is the value…

A:

Q: Calculate the Thevenin's voltage if the maximum power supplied to the load resistor (Pmax)= 475…

A: Given data: Pmax=475 WRTH=10 Ω

Q: A wind turbine is producingamw with O.u power Coefficient the wind Speed is 10MIS and the air…

A: Given, Turbine wind power, Pt=2 MW Power coefficient, Cp = 0.4 Wind speed, v = 10 m/s Air density,…

Q: Three coils each having resistance of 14 N are connected in star across 407 V, 50 Hz supply. Then…

A: Given, Line voltage, VL= 407 V so, phase voltage, Vph= 234.98 V Resistance, R= 14 ohm

Q: The circuit diagram below shows a generator source supplying three loads through a resistance…

A:

Q: 5. Determine Vo using loop analysis. 21, 1 kn S 9 mA I 1k) 1 kN 1kN 13 V 1kn Ve

A:

Q: 5. A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

A:

Q: Q) calculate the measured resistance for a Kelvin bridge P=p= 1) KZ g' R=r=3.673 K2, and…

A:

Q: What is the magnitude of the impedance of a 35 Ohm resistor? Assume the frequency is 180 Hz .Write…

A: Given, Resistance, R = 35 ohm  Frequency, f = 180 Hz

Q: 100 kn 5 V 10 kn V1 20 kn °5 V 20 kn Calculate the output voltage if V1 = -V2 = 1 V. Vo = V. %3D

A: To get the output voltage we will apply virtual ground principle in which the voltage across…

Q: G A=0 A B=0 B G= C=0 F= D=0 E=1 E

A:

Q: er (a) Suppose the diagram of an electrical system is given in the Figure below. What is the…

A: Diagram of electrical system is given.  Probability of the system to competition the work.?

Q: The total copper loss in an induction machine is found to be 2.5KW if the stator resistance is 0.5…

A: Total copper losses =2.5kW Stator resistance R= 0.5 ohm Find the stator current

Q: A 100 kW, 250 V machine-A is in parallel with a 300 kW, 250 V machine-B. The voltage regulation of…

A: Voltage regulation of both machines= 4%

Q: A speedometer is connected in an automobile system to measure the speed. The meter reads 120.8 rpm…

A: In the question a speedometer has  The accuracy  = 98.7% Meter reads = 120.8 rpm Calculate the true…

Q: +Vcc R. R1 B = 90 R2 R. R1 = 90KQ R2 = 100KQ EE RE = 2.7kO RC = 5.7kN Vcc = 10V V = -3V EE ww ww

A:

Q: Rotor currint at standstill (stant ) €2 Ie = Note : Here, value of R (rheostat) is not given in the…

A: You posted the question, in which you asked to calculate rotor current and power factor at start.…

Q: 5.) The exact full load current of 208 V, 3Ø, 50 hp SCIM motor with an 80 % power factor is A.…

A:

Q: Three coils each having resistance of 14 2 are connected in star across 407 V, 50 Hz supply. Then…

A:

Q: a. What is the resolution of the measuring instrument? b. Is there hysteresis? c. What kind of…

A: In the measurement of any quantity, it is obvious to have some dissimilarities between the real…

Q: the circuit given below, thyristors are triggered at 30º. Calculate the current flowing through the…

A:

Q: Allswei all Question 1 The ignition coil and the starting motor of a car are connected in parallel…

A:

Q: Q1. Referring to the Figure Q1, answer the following questions: VI V1(@t) 40 V

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: Three coils each having resistance of 29 N are connected in star across 400 V, 50 Hz supply. Then…

A: In this question we need to find a total power loss of a coil when it is connected in star .

Q: 1. The following questions refer to the circuit shown below. a) What do the areas of the circuit…

A: Here in the given circuit which is  labeled as  'A' is an optocoupler circuit consisting of a light…

Q: It is possible to obtain two levels of voltages from two wire DC system. Select one: O True O False

A: This is a good question kn basic power system analysis. Have a look at the below explanation:-