Sketch the output waveform. Show your complete analysis

Q: the given signal x(t)=e^at if a>0 then the signal is ______________ a. growing b. decaying c. dc…

A: Here the given signal x (t) is a  continuous time signal . They mentioned value of is greater than…

Q: Which of the following waveforms can be generated by the output QB of the synchronous counter shown?…

A:

Q: HW. 1 Ql: A discrete-time signal is shown in the Figure below. Sketch and label each of the…

A: Given signal is -

Q: Q9) Compute and plot time derivative of the following signal.

A:

Q: The spectrum of the sampled signal may be obtained without overlapping only if a. fs ≥ 2fm b. fs fm…

A: Non - overlapping spectrum of the sampled signal

Q: Determine the Nyquist frequency for the signal a. 1000 Hz b. 500 Hz c. 250 Hz d. 125 Hz

A: In this answer we will find the Nyquist frequency of the given signal as shown below. The bandwidth…

Q: Sketch the output waveform. Show your complete analysis. 1. at E IN RSI"

A:

Q: b) Find the bandwidth of a signal that can be decomposed into four sine waves with frequencies at 0…

A: For the above given signals we need to calculate its bandwidth by plotting frequency spectrum. By…

Q: Q2: Assume a sinusoidal signal with a frequency of 3.5 kHz and maximum amplitude of 1v. Then this…

A: Given data, fm=3.5 kHz, Am=1 VRb=15 kbps

Q: QI: A discrete time signal x(n) is shown in figure, sketch the following signal a) x(-n-2) b)…

A:

Q: drive a formula for (SNR) of sinusoidal signal has been sampled and quantized

A: First we will find out signal power and then quantization noise power ,  Ratio of signal to noise…

Q: Find out the energy of the following signal: u(n)

A:

Q: Show that an SSB signal can be demodulated by the synchronous detector by Synchronous Detector b)…

A: Please refer the attached images for the complete answer..

Q: 1. If the input voltage 32VP.P and f-50HZ, sketch the output of the circuit shown below. 10k 10k 3 V…

A: This circuit have 2 diode, 2 battery and resistance.  Let's input voltage is sinusodial waveform.…

Q: Sketch the output waveform. Show your complete analysis

A: The given circuit is a negative biased negative clamper circuit. It will shift the DC line towards…

Q: Find the Noise Power with Temperature of 45°C and Frequency of 10 GHz.     Step by step solution.…

A: Noise power given by  Pn = KTB K is Boltzmann constant T is temperature in Kelvin

Q: b) Consider a sinusoidal type of signal to be sampled, for which the highest frequency is given as…

A: Given, Maximum frequency of message signal is fm = 45 kHz Therefore, Let us consider the message…

Q: Choose the correct statement that describe the diagram below. m, (t) am, (t) 1+ am, (t). Σ X(t) a 1…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: The equation for finding the period, when frequency is kniwn is

A: Period :- It is the total time taken for one complete cycle .

Q: C.) 20 V -20 V " C Ideal

A: The given clamper circuit is shown below:  For the negative half cycle, the diode is in…

Q: The spectrum of the sampled signal may be obtained without overlapping only if a. fs > 2fm b. fs fm…

A:

Q: What is the total energy of the discrete-time signal

A:

Q: What is the frequency of the signal, x[n] = Acos(100xn+ 30° }. Specify its un. Solve the problem…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: a) The highest frequency of a signal is 25kHz(Sinusoidal). If it is sampled at the following…

A: According to the guideline, we need to solve only the first question. According to question, a) The…

Q: (a) State the difference between the signal in time domain and frequency domain. Explain your answer…

A: According to the Bartleby guidelines this is multipart question so we have to do only first part of…

Q: R ww

A:

Q: Find the Igms value of the square waveform of Figure Q1) of

A: R.M.S (Root mean square value):-Root Mean Square (RMS) value of AC current is defined as the…

Q: 1. If the input voltage 32VP.P and f-50HZ, sketch the output of the circuit shown below. 10k 10k 4 V…

A:

Q: Q3. Consider the following discrete-time signals with fundamental period N = 4: x[n] = sin 4 (+).…

A: Given, xn =sin2π4nw = 2πN =2π4 Compare from the given equation,  N = 4 a) Discreate fourier series…

Q: CRO can be used for measuring the AC and DC voltage magnitude, also for the observation of…

A: CRO used to measure the both the signals AC and DC voltages.     Whenever we will apply a signal to…

Q: Give a detailed explanation about the time domain and frequency domain of phase modulation (PM)

A:

Q: An analog signal x(t) has frequency components ranging from 300 Hz to 4 kHz. If the signal is to be…

A: Sampling is the process of converting a continuous time signal into a discrete time signal.According…

Q: 3 = X (n) = <XP (o.2m) 4- x(1) = ex? (=)cos (n)u(n} %3D () cos (n) (n)

A:

Q: Statement I: Ck = CN+k+1 Statement II: ||Ck+2|| = ||CN-k-2|| Statement III: Zck+1 ZCN-k-1

A:

Q: Find the THD for the given function (total harmonic distortion)

A: In this question we need to find THD of the given signal

Q: Sketch the output wave of the circuit below, with the input wave is given! 120 V C Ideal R Vị E 20 V…

A:

Q: 12: Assume a sinusoidal signal with a frequency of 3.5 kHz and maximum amplitude of 1v. Then this…

A: Given data, fm=3.5 kHz Vm= 1V Rb= 25kbps step size ∆=?

Q: Find out power of the following signal: u(n)

A: In this case, the power of the discrete-time unit step function u(n) is to be determined.

Q: 3. Discuss the results obtained for full-wave circuit with capacitors filter.

A: A filter is used to perform signal processing. The schematic diagram of the capacitor filter is as…

Q: Sketch the waveform of the following signal: u[-n + 2] – u[-n- 2]

A:

Q: Analyze the signal to its even and odd components and then sketch the three signals sin (wnt + )…

A: From the even and odd components of signals..

Q: Given the continuous-time, continuous-amplitude signal waveform x(1) -3 sample at discrete values of…

A: The time domain signals can be continuous or discrete. The time domain signals can be periodic as…

Q: A signal is represented in the frequency domain by the figure below. If it is sampled at 100Hz, F(w)…

A: It is given that: f=50Hz

Q: (3) For the shown input signal to the following system, draw the spectrum of the output signal. S(f)…

A:

Q: What is the bandwidth of a PCM signal encoded using 8 bits if the bandwidth of the analog signal =8K…

A: Given, Bandwidth of analog signal is 8 KHz Number of bits, n =8

Q: 6.) Show that the response to an linear time invariant (LTI) system to a complex exponential input…

A: The output response of an LTI system is obtained from the input signal by applying convolution. The…

Q: Sketch the output waveform. Show your complete analysis.

A: In this question we need to draw a output waveform.

Q: Ques. 8: Find and sketch the odd and the even components of the following signals: (а) и(t)

A: Given signal is, a)u(t)

Q: A discrete time signal is represented as in the figure below. What is the fundamental frequency? a.…

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.