Sodium hypochlorite is formed according to the reaction: 2NaOH + Cl2 → NaOCl + NaCl + H2O in a continuous reactor. For this, Cl2 is bubbled through a concentrated solution (40% by mass) of NaOH. Suppose that the solution of NaOH in H2O is fed at a rate of 1000 kg / h and the gas Cl2 at a rate of 10 kgmol / h. Carry out the following operations: a. Calculate the degrees of freedom, assuming the conversion is specified. b. Determine what the limiting reactant is. c. Calculate the reactor outlet composition, assuming 100% conversion of the limiting reagent. d. Calculate the reactor outlet composition, assuming a 60% conversion of the limiting reagent

Q: For the reaction at 500 K: CO(g) + 2 H2(g) ↔ CH3OH (g) the Kp is 6.3 x 10-3. Calculate the ∆G for th...

A: To do-calculate Gibb's free energy change for reaction involving hydrogenation of carbon monoxide to...

Q: A rigid container of 10 L initially contains a mixture of liquid water and steam at 100 ° C with a q...

A:

Q: 8.0 kg of water at 32 C is mixed with 1.3 kg of water at 98 C. Assuming steady-state conditions and ...

A:

Q: A sphere of diameter 10 mm and density 7700 kg/m falls under gravity at terminal conditions through ...

A: Given:- Diameter of sphere DP=10 mmDiameter of sphere DT=15 mmDensity of sphere ρp=7700 Kg/m3Density...

Q: The rate constant of a drug molecule has been given as 4.0 x 10-5 s-1.  Calculate the half-life of t...

A:

Q: The vapour pressure and molar volume of water as function of temperature are given below: T, K 49...

A: (a) Write the Clapeyron equation as follows: P2-P1 = ∆Hvap∆VlnT2T1             ......(1) Since we ha...

Q: The molarity of a solution is o.85 and the normality of the same solution is 5.10. What is the norma...

A: ( According to guidelines of Bartleby we can only solve first question, remaining question you have ...

Q: Water at 60 ° C is converted into superheated steam at 250 ° C with a pressure of 210 kPa. Specify: ...

A: Given:- Inlet temperature=60 ° C  Superheated steam Temperature=250 ° C Pressure of 210 kPa.    (A) ...

Q: What is a flexible wedge gate used for

A:

Q: Copper spheres 20 mm in diameter are quenched by being dropped into a tank of water that is maintain...

A: Given, Diameter of sphere, D = 20 mm temperature of want in the tank ,T∞ = 280 K terminal velocity, ...

Q: At 600 K and 5.0 bar, the degree of dissociation of PCl5(g) is 0.920. Phosphorus pentachloride therm...

A: (a)   Let α be the degree of dissociation for the given reaction. Now, PCl5g⇌PCl3g+Cl2g1−α         α...

Q: Determine the quality of 170 kPa of steam when 470 kJ / kg of energy is lost from the saturated vapo...

A: Given, Pressure of the steam, P = 270 kPa From steam tables, the thermodynamics properties  at 270 k...

Q: You desire to flash separate 10 mol/s of an equimolar liquid mixture of 1-butene (1) + n-heptane (2)...

A: Initial moles of the mixture, n = 10 mol/s The mixture contains equal moles of 1-butene (1) and n-he...

Q: Based on your field chemical engineering, what are the commonly used polymers and what are their use...

A: The polymers used commonly in chemical engineering are to be mentioned along with uses.

Q: 11.) A swimming pool is 50 m long, 10 m wide and 3 m deep. Express the volume of the water in the sw...

A: Given:  Length = 50m  Width = 10m   Depth = 3m  The formula for the volume of a swimming pool is = L...

Q: A gas mixture of 0.270 mol acetic acid/mol, 0.300 mol water/mol, and 0.430 mol inerts/mol at 88.0 C ...

A: Mole fraction of acetic acid (A), water (W), and inert (I) in a gas phase mixture is given as: yA=0....

Q: How many intensive variables are necessary to completely specify the state of pure water and pure gl...

A: Given: P = 1atm             Temperature of glycerol (T) = above 18°C             Intensive variable ...

Q: Steam enters an adiabatic turbine at 7 MPa, 600°C, and 80 m/s and leaves at 50 kPa, 150°C, and 140 m...

A:

Q: Give four design features of flue gas analysis stack

A: The design features of the flue gas analysis stack are to be mentioned.

Q: Heat Transfer Question

A: Given data: Number of revolution, n=180 rpm = 180/60 = 3rps Impeller diameter, Da = 0.61m W=0.122m D...

Q: (а) Build the four II groups for this problem (let p, µ, and D be the wilds). (b) What is the ratio ...

A: (A) Vc = f ( D, dP, g, ρf, μ, ρP) There are 7 variables Vc, D, dP, g, ρf, μ, ρP There are 3 referenc...

Q: 4.20 moles of solute was mixed with 9.10 moles of solvent. What is the mole fraction of the solvent ...

A: ( Post single question at a time, we can't all the questions )

Q: 4.20 Using the data in the following table, predict the relative degree of atomic solid solubility o...

A: The factors on which the atomic solid solubility of an element in another element are: Atomic size:...

Q: Sulfuric acid with a density of 1980 kg / m3 and a viscosity of 26.7 cP flows in a pipe with a diame...

A: Given that, The density of Sulfuric acid ρ = 1980 Kgm3 Viscosity μ = 26.7 cP = 0.0267 Pa.s Diameter ...

Q: Maxwell’s equation can be used to evaluate the latent heat of vaporisation of a pure substance. Choo...

A: One Maxwell’s relation among 4 of them is ∂S∂VT=∂P∂TV        ........(1) If we multiply both sides b...

Q: A new process has been proposed to produce gaseous ethylene (C2H4) from gaseous propane (C3H8) at at...

A: The reaction given at the atmosphere pressure to produce ethylene gas from propane is: C3H8g+2O2→C2H...

Q: Certain solid substances, known as hydrated compounds, have well-defined molecular ratios of water t...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Calculate the value of ∆H°rxn for the reaction: N2H4(l) + O2(g) → N2(g) + 2 H2O (l) Using the follow...

A: Write the reactions as follows: N2O (g) + 3 H2 (g) → N2H4(l) + H2O (l); ∆Hrxno= -317.0 kJ Multiply w...

Q: Consider a hemispherical droplet of liquid water residing on a flat surface, as shown in the figure....

A: Given data: The vapor pressure of water at 40 0C (pA1) = 0.073 atm Diffusion coefficient of water va...

Q: Discussion and explanation of the difference between the stock solution concentration of chymotrypsi...

A:

Q: : If the temperature rise per meter length along a pipe carrying air at 12.2 m/s is 66 deg K, what w...

A: Given data: Velocity of air = 12.2 m/s Temperature rise per unit length along a pipe= 66 K Temperatu...

Q: A real gas mixture consists of 35% N2 and 65% C2H4 (on molar basis), hasa pressure of 18 MPa and a t...

A: The value of the molar-specific volume of the mixture is to be determined and a comparison of this v...

Q: A counterflow, thin-walled concentric tube heat exchanger isused to cool oil (cp: 2.20 kJ / kg ° C) ...

A: Given: heat capacity of oil (Cpo )=2.2 kJ/kg°C heat capacity of water (Cpw )=4.18 kJ/kg°C mass flowr...

Q: Q1: When O.1 g of urea (M.W = 60) is diluted to 100 mL, what is the osmotic %3D pressure of the solu...

A: Hello !! Thanks for asking the question. Your question contains 2 full separate questions. The first...

Q: Sulfuric acid with a density of 1980 kg / m3 and a viscosity of 26.7 cP flows in a pipe with a diame...

A: Given that, The density of Sulfuric acid ρ = 1980 Kgm3  Viscosity μ = 26.7 cP = 0.0267 Pa.s The diam...

Q: Draw Newman projections to show all the major conformers of bromoethane. Predict which one is lowest...

A: To do draw Newman projections to show all the major conformers of bromoethane predict the one lowest...

Q: 5. The following temperature/composition data were obtained for a mixture of octahe (0) and methylbe...

A:

Q: A researcher has added 2.06 g of the salt sodium nitrate, NaNO, to a cylinder con- taining water. Th...

A:

Q: In a pharmaceutical plant, a copper pipe (kc=400 W/mK) withinner diameter of 20 mm and wall thicknes...

A: Given:-

Q: In the figure, are the two processes described by G1 and G2 interacting processes? Why or why not?

A: Interacting processes- It is the system in which input of one system is changed then it has an impac...

Q: The flow rate through the pipe is 14999 L/hr. The pipe is new commercial steel pipe with an internal...

A:

Q: Calculate the fugacity of nitrogen at 800 bar from the following data at 273 K. P, bar 50 100 200...

A: Given data: P, bar 50 100 200 400 800 1000 PV/RT 0.9846 0.9846 1.0365 1.2557 1.7959 2.0641  ...

Q: The normal boiling point of ethanol is 78 degrees Celsius, and the standard enthalpy of vaporization...

A: Given that, Normal Boiling Temperature of Ethanol T1 = 78oC = 351.15 K The pressure at Normal Boilin...

Q: Make a line graph showing the relationship between molar mass (# of carbon) and heat of combustion (...

A: The line graph is as follows:

Q: In a pharmaceutical plant, a copper pipe (kc=400 W/mK) withinner diameter of 20 mm and wall thicknes...

A: Draw the diagram as follows:

Q: (3.a) Develop a set of pi groups using W and Q as the 'king' variables.

A: 3.a Given: W is a function of D,ρ,ω and Q. W = f ( D,ρ,ω,Q) Hence the total number of variables n = ...

Reactive Processes

Reactive processes are the processes in which any reaction occurs. The reactions can be any combination reaction, decomposition reaction, combustion reaction, oxidation reaction, reduction reaction, neutralization reaction, displacement reaction, or double displacement reaction.