Solve for VGs of an EMOSFET if VG = 6.44 V,

Q: Which of the following are possible input of the system? (choose three) reference setpoint physical…

A:

Q: Q2: For a (3-0) medium transmission line model (T cct) as shown in next figure, find the, current…

A:

Q: 3. If I,- 14 A, R₁ = 22, R₂ = 4 52, and R3-82, find the current 13 (in amperes). R₁ P2 P3

A: Given circuit: Here, Is=14 A,R1=2 Ω,R2=4 Ω,R3=8 Ω.

Q: 9V 1 ΚΩ Μ + www 3 ΚΩ ww • 2 ΚΩ + 1 Ανα

A: Given data, Circuit diagram is given as,

Q: Q3) Using the superposition theorem, find the current, voltage and the power dissipated through R₁…

A:

Q: In Figure shown below, use Thevenin's Theorem to Determine RTH. VTH IN & Maximum power transfer at…

A:

Q: Q4) Find the Norton equivalent circuit for the portions of the networks of Fig. 4 external to branch…

A: The given circuit is shown below Find Northern equivalent circuit and power dissipated through 100…

Q: Question In an instrument transformer of 500 turn burden on secondary side Zs = 10, on the secondary…

A: Given- No. of turns N=500, Burden- Zs=1 Ω, Frequency f=50 Hz, To Find- The core flux in the CT.

Q: 1. Use Wye to Delta Transformation to solve for I. 50Ω Μ 5Ω 55V www 30Ω I Μ Μ 4Ω 20Ω Μ 200

A:

Q: The figure shows a capacitor arrangement with a voltage source of 20 Volt. The area of capacitor…

A: Given,

Q: 18. An antenna has a gain of 1000. The corresponding gain in decibels is: (a) 0.03 dB (b) 1 dB (c) 3…

A: Given, The antenna gain, G=1000.

Q: ns In the following circuit, Vdd is power, Vss is ground. What function is Vout? C Vout O Vout OR…

A:

Q: 2. Consider the closed loop system given below. r(t) e(t) G(s) = G(S) G(S) k (s+2)(s+3) K(S+1) S(S+…

A:

Q: An 8085 assembly language program is given below. Line 1: MVI A, B5H 2: MVI B, OEH 3: XRI 69H 4: ADD…

A: Given Assembly language program. We have to find the content of accumulator after the execution of…

Q: 1. Determine all the mesh currents using mesh analysis. Show complete solution using either…

A: In this question we need to find a mesh current of the given circuit.

Q: Q3) Using the superposition theorem, find the current, voltage and the power dissipated through R,…

A: Given: A circuit with two voltage sources and one current source To find: Current, voltage and power…

Q: A wire measuring 1.5 m3 has a resistance of 0.955 mW at 20°C; its length is 1.5 m and an area of 1.5…

A:

Q: 3. Sketch the graph of the frequency domain for the following equations: a) y 3sin(2p 100 t) + 10sin…

A:

Q: Fig. 1. Then, find the current through R. for values of 102 and 302, and find the value of R, for…

A: Given,

Q: Q5) Find the Thevenin equivalent circuit for the network in Fig. 5. Then, under the maximum power…

A:

Q: Q3) Using the superposition theorem, find the current, voltage and the power dissipated through R,…

A:

Q: In the circuit below find: a) The current i, in ampere [Select] [Select] 4 b). The current it in…

A:

Q: 1. For the circuit shown in Fig. P2.1, the power P delivered by the voltage source Vs is given by…

A:

Q: For given BJT, B=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: Given: Cut off frequency (β) = 200input Frequency = 20Mhznet Internal capacitance = 100 pf   Find:…

Q: A: A single core cable covered by the lead, if the radius of the conductor is r and the insulator…

A: Cross Section of Underground Cable:  Given: Single Core Cable covered by Lead  Radius of conductor…

Q: 3. Determine the Power supplied by the source and the power dissipated on each of the elements in…

A: Resistance opposes the flow of current. The dependent voltage or current source value depend on…

Q: A cable has the following primary con- stants: resistance R=802/loop km, conductance, G=2 µS/km, and…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 5. A MOFET amplifier has gm = 10 mS, ro = 15 k2, RD= 10 k2, and Rs = 1.9 k2. What is the voltage…

A:

Q: 2. For the voltage feedback network of Fig., determine: a) Ic b) Vc c) VE d) VCE VI 10µF H 470K Ic'…

A:

Q: A delta connected balanced 3-phase supply has a line to line voltage of 181 V and supply a line…

A:

Q: The continuous, sinusoidal varying voltage v(t) or alternating current i(t) available from an…

A:

Q: 1. The following circuit has three loads connected in parallel to a 1.0 kV RMS voltage source at a…

A: In this question we need to find total active power , reactive power and complex power and over all…

Q: 1. Use Wye to Delta Transformation to solve for I. 50Ω 5Ω 55V wil V₁ = 21 V - + 30Ω · 4Ω 2. Use…

A:

Q: Reduce the block diagram shown in the figure below to a single transfer function T(s) = C(s)/R(s). J…

A: Given: Block diagram of a control system To find: Transfer function by reducing block diagram

Q: Determine the modulation index mf, of an FM signal which is being broadcast in the 88-108 MHz band.…

A:

Q: the total charge On line 0<x< 4m if p₁ = 8x²mC/m On the cylinder p=6, 0<z<3m if p,= pz'nC/m² 6 on…

A: Charge density can be charge per unit length, charge per unit area or charge per unit volume. Line…

Q: A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if…

A: Solution !!

Q: 2. The field coils of a six-poles D. C. generator each having 600 turns, are connected in series. On…

A:

Q: Q1) Find the Thévenin equivalent circuit for the network in the shaded area of Fig.1. Then, find the…

A:

Q: Q6) Determine the current drawn from the source in the given circuit in Fig. 6. R₁ V₂+ 14V 292 R₁…

A: We need to find out current for given circuit. We will simplify the given circuit then we will find…

Q: 1. A point charge Q₁ =3μC and Q₂ = -2μC are placed at (5,4,1) and (-1,7,0), respectively. Determine…

A:

Q: Given the circuit below determine: a). The power delivered to the 120 V source in watts b). The…

A: Given:

Q: Q2:A) For the circuit shown in the figure 1- Complete the table below? 2- Draw the equivalent AC…

A:

Q: Q5) An LTI system is characterized by the differential equation below: d d d² dt2 = y(t)+ =…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Find Vo and the power dissipated in all the resistors in the circuit. 60 V 1292 V₂ Show complete…

A:

Q: For the circuit shown in the figure, the Thevenin voltage (Vth) at terminals a-b i= 492 www 502…

A: Given data, Circuit diagram is given as,

Q: These are laminated steel core containing current-carrying copper wires; and in general if it is the…

A: We need to select correct option for given statement regarding Motor parts .

Q: Go, (s) = K ts+1 parameters

A:

Q: 13). A motor with power factor of 0.85 is served by a single- phase 120 V source; the motor requires…

A: In this question we need to find a efficiency of motor and line current drawn by the motor.

Q: A 3-phase, 50 Hz transmission line with a total series impedance of 34 + j140 and shunt admittance…

A: Given:  f=50 Hz, Total series impedance=34+j140 Ω, shunt admittance=j900×10-6 Ω-1, l=210 km,…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.