Solve the following electric circuit given in the following figure by using echlon or reduced echlon form You may use KVL & KCL to form linear equations involving i1, i2, is 20 2 10 2 80 v 10 2 90 V iz P 150

Solve the following electric circuit given in the following figure by using echlon or reduced echlon form You may use KVL & KCL to form linear equations involving i1, i2, is 20 2 10 2 80 v 10 2 90 V iz P 150

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.22P: The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is...

See similar textbooks

Related questions

Q: currents I1, I2 and I3, and the potential difference Vas using Kirchhoff's rules. E2 + E3 + R1 R2 R3

Q: The power through an element is given by p = 4e^-7t Find the amount of current passing through this…

Q: Determine the Branch Currents using Kirchhoff’s Laws: a.) Branch bd b.) Branch cd c.) Branch ca

A: Assigning current to the three different loops as shown in the figure- Applying KVL to each loop,…

Q: The load in the circuit shown atsorbs 50 kVA of complex pawer st power factar pf - 0.83 lngging when…

Q: 3. A coil consist area ot 0.8 mm? The mean 2.000 turns of copper wire hav ing length par sectional…

Q: 48. In a R-L parallel circuit, total current lags behind the applied voltage." True False In a…

A: In this question, Check the given Statment is true or false.

Q: 5. Fin the indicated steady-state currents and voltages for the following network. 20Ω 3Ω 100 µ F 50…

Q: ELECTRICAL CIRCUIT: Solve the problem and show your complete solution. The maximum values of the…

Q: 5. For the system shown in figure. State the given system type also find steady state position error…

A: A system is carrying a feedback when the output from it's own circuit is passed to the input of the…

Q: Two coils wound on a common core have L1=0.2 H, L2=0.5 H, and M=0.1 H. The currents are…

A: Given data, The value of inductor L1 = 0.2 H. The value of inductor L2 = 0.5 H. The value for…

Q: Find the currents in the circuit using Kirchhoff's Laws. 12V ww a b 13 ww 8V

A: Node: The meeting point of more than two branches in a circuit is referred as a node. At that node…

Q: V1 + V₁ = 33, 80/0° L₁ = 2je C₁ = -5jN L1 R1 10 www I Vx www R2 392 C1 ww R3 20 0,75 VX

Q: Find the power relations (real power, reactive power, apparent power, draw power triangle)

Q: Please answer these question complete solution and readable (I'll rate it if it is complete…

A: Given data, Expression of currents are given, i1=102sinωt, i2=202sinωt+600

Q: 5. For the system shown in figure. State the given system type also find steady state position error…

A: In this question, We need to determine the steady state position error for given system?

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,664 ohms %3D R2 =…

A: In the given series circuit R1= 1664 ohms R2= 1999 ohms Total R = R1+R2 R =3663 ohms…

Q: Faraday and Henry are the units for inductance and capacitance. Select one: True False

A: In this question , we will write units of inductance and capacitance .

Q: In the network in the figure below, V, is known to be 4245°. Find Z. ww 29 Q -j10 12/0° v (+ 103 V.…

A: In this question we need to find a impedance z.

Q: Q11 Assume that the eircult has reached steady state at i0. Find: in the circuit. v () in the…

A: Given circuit is Fig-1 At t=0- , switch becomes closed.…

Q: 7 In the circuit shown in Figure P7.27, the sources are Vsi = 362(-1/3) V and Vs2 = 2420.644 V. Find…

A: (a) Let V be the voltage at the junction. Write the expression for nodal analysis for the given…

Q: 1) For the circuit given in the figure (a) Draw the voltage and current reflection diagrams. (b)…

A: For the circuit given in the figure a)draw voltage and current reflection diagram b)plot voltage and…

Q: 4. (30) For a given AC network shown in the figure, do the followings. a). Find inductor current b)…

Q: A current i (t) = 10 cos(2000nt) flows through a 100-n resistance. %3D Sketch i (t) and P (t) to…

A: Given data, i(t)=10cos (2000π(t)) now, putting the value t=0, i(0)=10 cos(2000π(0)) =10.1=10A…

Q: Practice: If v =-10 sin(@t + 30°) and v2 = 20 cos(@t -45°), find V = v1 + v2. %3D %3D 14.6

A: In this question we need to find a voltage V

Q: R1 20 R2 100 R3 80 V 240Vpk 60HZ 0° C2 = 20μF L3

Q: Solve for the steady-state values of the labeled currents at 2 A Va t=0 2 (a) t = 0 iz

Q: How did he get the second derivative step by step and a clear line please 3 X- Fex) = 1+e siny x %3D…

A: given f(x)=1+e-xsin4x here we have to determine the second derivative of f(x)

Q: Two ac sources feed a common variable resistive load as shown in figure. Under the maximum power…

Q: Activity 1: You are testing an electrical device which can be modelled by the figure shown below: 18…

A: "As per our guidelines, we are supposed to answer only one question. Kindly repost the other…

Q: Determine the branch currents using Kirchhoff's Laws. R1 = 20 R2 20 R3 = 2 0 R5 = 20 20 100 V R6 =…

A: Current through branches solved by using KVL

Q: See the circuit shown below. Write the expression for the current i, and the voltage vi following…

Q: 3) Write the value of VO as a function of the components and the Mutual inductance M. Use phasors.…

A: In the given circuit, applying KVL in loop 1, Vs=jωL1+jωL2(i1-i2)-jωMi2Vs=jω(L1+L2)i1-jω(L2+M)i2…

Q: In the circuit shown in Figure, V1 = 5 1200 Find Z. 2 Ω V1 0.25 N j1 N -j0.25 N (1) 6/0°A Z

Q: The equation of two currents in parallel connected in electric devices are i = 12 sin ( 377t +T/4)…

A: Two equation of currents are given Both current in parallel connected in electric devices Find the…

Q: express Power in fonction of time, it is When we a AC Circuit as a Called Instantaneas power PE) =…

Q: Given an AC source having a voltage v(t)=14sin(158t + 16°) V, find the votage at t=130ms

Q: Q2) Assuming a sinusoidal source and uniform load flow. Analyze the following circuits and draw…

A: To analyse the given question

Q: 1. Use Kirchhoff's Laws to find the branch currents indicated in the following networks: 2420°v I1…

A: Given, The circuit is having ac values and energy storing elements. I have written the way to solve…

Q: 8. The circuit below is similar to Problem 7 and operates at a frequency of 10 kHz. Circuit element…

Q: A 30-ohm resistor and a 0.1 H inductor are in series with a voltage source that produces a voltage…

Q: 9.35: For the mutual electric circut shown in figure beside if Vg-10cos100t Volts, write the set of…

A: In this question, We need to determine the mesh current in this circuit. We know XL = wL Xc…

Q: 12/0° V (+ 12 www -j1Ω V 3 j1 Ω 4>2V, ZL

A: given here a AC circuit and asked to find ZL when maximum power transfer.

Q: An AC source with ΔVrms = 120 V is connected between points a and d as shown. At what frequency will…

A: The impedance of the given RLC series circuit is, Z=R+jXL+jXCZ=R2+ωL-1ωC2R=40 ΩL=185 mHc=65…

Q: For the circuit given in fiqure 6, find V_ rms and ms on R3. R, R3 10 20 R2 RA 5 Vp Figure 6 ww ww

A: The solution can be achieved as follows.

Q: z²+0.25 ) Is the causal system with z-transform H(z) is minimum phase? Explain your reason. z²-0.25

A: We need to tell about the given system is minimum phase or not , we check by pole and zero .

Q: 1. Use Kirchhoff's Laws to find the branch currents indicated in the following networks: 2420°v I1…

Q: The circuit in figure 2 is operating in the sinusoidal steady state, I1-0.520 A and V1-50£90° V Use…

A: Case1: Consider that the only current source is operating and the voltage source is shorted,…

Q: .For the circuit given in figure 6, find v_ms and I_rms on R3. R, Ro

A: The solution can be achieved as follows.

Question

Solve the following electric circuit given in the following figure by using echlon or reduced echlon form
You may use KVL & KCL to form linear equations involving i1, i2, is
20 2
10 2
Q
80 V,
102
90 V
P
152

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
Write the differential equations for this circuit then change this circuit so that The voltage at V2 is 9.00V (DC) With a ripple of 500mVpp
compute the voltage v0(t) at the steady state for E0=6v and e1(t)= 4cos(t-90)V. SOLVE IN GREAT DETAILS.
To attain maximum power delivered to a load, what value of load impedance is required if a. the load can have any complex value; b. the load must be pure resistance?
An AC circuit contains a 24-Ω resistor, a 15.9-mH inductor, and a 13.3-µF capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. P = I2 / R = VARsL = √VA squared - P squared = VARsC = VARsL(present) - VARsL(needed) =
solve for the dc quantities, VB(Q1), and VB(Q2)
(show solutions)
A. Refer to the equations in the picture, solve for the values values of the coefficients. B. Given these values, VA = 32V, VB = -12V, and VC = 7V, what is the power associated with the 8A current source? Include the sign for absorbing or supplying.
For the circuit shown in Figure,a. Find the Thévenin equivalent circuit for the source.b. Find the power dissipated by the load resistor. c. What value of load impedance would permitmaximum power transfer?The voltage source is sinusoidal with frequency60 Hz, and its polarity is such that the current fromthe voltage source flows into the 10-Ω resistor.
Show the derivation of the formula in transforming Delta (or Pi ) Network to Wye (or T) Network and vice-versa. In addition, solve four (4) circuit problems with applications of delta to wye transformation (or vice-versa) of your own choice and indicate your reference.
Show you solution
For the number 1 question, you have to find the thevenin equivalent resistance at the load terminals and also the maximum power transfer to the load. I have posted this question but both gave me different answers, what is the real answer for this? LINK FOR ANSWER 1: https://www.bartleby.com/questions-and-answers/1.-find-the-a-equivalent-thevenin-resistance-at-the-load-terminals-and-b-maximum-power-transfer-to-t/bb07ad30-0e58-4e87-a919-c3846bad184bLINK FOR ANSWER 2: https://www.bartleby.com/questions-and-answers/1.-determine-the-equivalent-thevenin-resistance-at-the-load-terminals-and-maximum-power-transfer-to-/eded9e03-db33-44c9-b6f7-c9616cbaab35 Also, kindly check if the answers to question number 2 on the links are correct.