Answered: Solve the following Numerical problems…

Solve the following Numerical problems a. What is the Output Voltage of a battery that expends 7.2J of energy in moving 1C of charge?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Related questions

Q: 3. (a) Define the unit of electrical current. (b) A battery has a terminal voltage of 24V when not…

A: Note :- As per guidelines we are supposed to answer only one question. So I request you to please…

Q: A certain factory machine uses 600 cal/s to operate. If there are 2 identical machines running at…

Q: Q4: Identify the time scales considered to analyze Power system. Describe the general…

A: to identify the time scales considered to analyze power system to describe the general…

Q: For the network shown below, composed of standard values: a) Find the mathematical expressions for…

A: For time t=0 second, the switch is connected into position 1. Since the circuit was in this…

Q: In household wiring, usually 12-gauge copper wire (diameter 12 mm) is used. A light bulb is…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A specification sheet of a smart meter states that its rated current is 100 A and power dissipation…

Q: Consider a gravity-driven LED bulb that provides 16 lumens of lighting. The device uses a 10-kg…

A: The rating of the gravity-driven LED is 16 lumens. (a) The velocity of the sandbag is calculated…

Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per…

A: In this question AWG wire is given...We have to find out power loss due to current and due to this…

Q: Determine the cost per kilowatt hour for the energy delivered by a typical alkaline 9-V “transistor”…

Q: The heater element of an electric kettle has a constant resistance of 100 Q ZZand the applied…

A: a) Given: Resistance, R=100 ohm Applied voltage, V=250 V Initial temperature of water, is 20 degree…

Q: Q1 Figure Q1 shows the charge, as an input to the electronic system that operates with the voltage…

Q: 3.0 V across the cable, and a current of 50 A in the circuit. Draw the circuit diagram, representing…

A: Given: Battery emf, E=12 V Terminal voltage of battery, V=11.4 V Circuit current, I=50 A Voltage…

Q: The resistance of the wire used for telephone is 35 Q per kilometre when the weight of the wire is 5…

Q: A thermal power station spends RO 3 million per annum for coal used in the station. The coal has a…

A: In this question we need to find a average load on the station.

Q: 12. What is the use of Wheatstone bridge in a force measurement device? Please also give the name of…

A: To analyse the given statement

Q: A 2. 5 6 7ms 8 9ms This is a graph of charge in picocoulombs (pC) over time in milliseconds (ms).…

A: Given A = 28 B= 34

Q: light bulb has a 25 W rating, and it is plugged into a socket with terminals at a 220 V potential…

A: Power is given as the product of voltage and current P =i×v i = v/r Rearrange the equation and…

Q: 6. BJT is more linear than FET. Why? Explain 7. what is vas (off)? How could it effects the…

A: In this question we will write how BJT is more linear than FET... Note :- as per our guideline , I…

Q: What is the relationship between the voltage across the power and the current? (P = I V )

A: Voltage :- voltage is potential difference between two point in circuit. It is denoted by V.…

Q: The components of a cell phone are shown in the diagram below. Assume that the charge carriers are…

A: The block diagram of a cell phone with its components is shown below, Here, the charge carriers are…

Q: c) Two of you have been given two instruments with the units in ohms, your colleague measures the…

Q: Which of the following statements about battery ratings is true? A. The ampere-hour rating is…

A: The cranking amp rating expresses the number of amperes a battery can deliver at 320F (00C) for 30…

Q: Figure P1.28 shows an ammeter (AM) and voltmeter (VM) connected to measure the current and voltage,…

A: An ammeter is a device that measures the flow of electricity through a circuit in the form of a…

Q: Q4.Evaluate the Maximum power point and the efficiency of the module if the area of the Solar module…

A: Given: Voltage Vm=26.68 V Current Im=7.46 A Area A = 0.942m×2.0m=0.887 m2

Q: Should You Buy an Electric Car? Do the math. This article says that the EPA rating for the…

A: Nissan LEAF electric vehicle Vs Current vehicle (operate on gas)

Q: A shell and tube heat exchanger, with two tube passes and one shell pass, is used to cool the…

A: According to the question we have to calculate the value of output temperature Tc with the help of…

Q: A wire of resistance 5.0 ohm is connected to a battery whose emf is 2.0 V and whose internal…

A: Please refer the attached images for the complete answer..

Q: It is suggested, as an ECM, to replace a 7 kW motor with an efficiency of 87 % with a…

A: Given Power P = 7 Kw Efficiency of the motor = 87% Efficiency of premium motor =92% Cost of…

Q: Solve the following problems If a 100-V resistor is connected across the terminals of a 12-V…

A: Use ohms law V=I*R Since it is pure resistance network...

Q: Which of the following is NOT a variable in voltametric methods? A. How the current is applied B.…

A: In this question we need to choose a option which is NOT a variable in voltametric methods.

Q: Q. For the circuit shown below, find the following 1. The name of this eircuit is

A: Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Consider a portable electric blanket that runs on a 3 V battery. If you use copper wire with a 0.25…

Q: Determine the nodes/junctions, Current (I), Loops, Voltage drop on each Resistor (R), and Power (P)…

Q: Design an ohm-volt-ampere scale with the following characteristics Voltage 25 100 Volt ranges…

A: Measurement devices are used to measure electrical quantities. The true value and the measured value…

Q: You want to buy electric energy. You can buy from company A, B, C, or D, but you must choose only…

A: For the given past data on these four suppliers, expected costs for all energy suppliers are…

Q: The resistance of the wire used for telephone is 35 0 per kilometre when the weight of the wire is 5…

Q: Estimate the total land (foot-print) that is required for a wind farm for generating an 10 amount of…

A: The total energy to be generated in the wind form is, Total energy=20%…

Q: Four cubic meters of water is to be heated by means of four 1.5 kW, 230-V immersion heating…

Q: In the figure the resistances are R1 = 1.1 N and R2 = 2.2 N, and the ideal batteries have emfs ɛ =…

Q: .) An incandescent lamp, rated at 100 watts, gives a certain amount of light when placed across the…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: SITUATIONAL ANALYSIS: Light bulb A is rated at 120V and 25W for household applications. Light bulb B…

Q: 12. You plot the current-voltage characteristics of a new non-ohmic device, perform a curve fit, and…

A: Given, Current as a function of voltage I=9 Ampere/Volt2V2-7 Ampere/VoltV

Q: For an electrical component, the formulas for charge and voltage are given below. A is 9 coulombs,…

A: In this question we need to find a power at t=7 sec

Q: Q1: Which Battery is discharging and which one is charging ? and why ? Q2 : If the resistance of…

A: The explanation is as follows.

Q: Solve the following problems with complete solutions and units using 2 decimal digits: The…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

Solve the following Numerical problems a. What is the Output Voltage of a battery that expends 7.2J of energy in moving 1C of charge? b. A 50-ohm load dissipates 200W of power. How much is the voltage and current across the load? c. If one branch of a 120-V power line is protected by a fuse of 20-A. Will the fuse carry 10-Ohm load? d. If total resistance of a series circuit is 280-Ohm. If one of the resistance is 160-Ohm. What is the sum of other two resistances?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A resistor of resistance ? is supplied by a battery which consists of voltage source ? in series with an internal resistance ?. Plot the power ? as a function of the resistance ? for 1 Ω < ? < 10 Ω given that ? = 12 V and ? = 4 Ω. From the resulting plot, when does the maximum power transfer occur and what is this maximum power being dissipated by the load?
Give four farming operations requiring electrical power. Discuss the advantages anddisadvantages of using electricity in each farm operation.
How does the power, P, dissipated by a resistor depend on the indicated parameter (resistance, R,of the resistor, or the voltage or current of the supply) for each of the following scenarios? I amlooking for a mathematical equation for power as a function of the indicated parameter followed bya description of the dependence - does the power increase, decrease, remain the same or some otherdependence, as the parameter is increased? (and if other, describe.) If it is increasing or decreasing,by what factor does the power change if the parameter is increased by a factor of 3?(a) Constant R, powered by ideal voltage supply (We will examine real batteries that have internalresistance in class and the next homework.) How does P depend on the voltage, V, of thesupply?(b) Constant R, powered by ideal current supply. How does power depend on the current I?(c) Ideal battery operating at a fixed voltage, powering a variable resistor R. How does P dependon the resistance, R, of the resistor?(d)…
h. What is the dc power dissipated by the device at the operating point?i. What is the power supplied by VCC ?j. Determine the power dissipated by the resistive elements by taking the difference betweenthe results of parts (h) and (i).
Solve the following problems with complete solutions and units using 2 decimal digits: The resistance of a given e electric device is 46 Ω at 25°C. If the temperature coefficient of resistance of the material is 0.00454 at 20°C, determine the temperature of the device when its resistance is 92 Ω
SHOW COMPLETE SOLUTION An elevator is designed to transport 120 passengers per hour from the 1st floor to the 10th floor. The average mass of a passenger is 75kg and the average speed of the elevator is 130kph. Determine: A. The required capacity of the motor if the mechanical efficiency is 90% and if a 250 percent overload is allowed. B. The average power required
Consider a gravity-driven LED bulb that provides 16 lumens of lighting. The device uses a 10-kg sandbag that is raised by human power to a 2-m height. For continuous lighting, the bag needs to be raised every 20 minutes. Using an efficacy of 150 lumens per watt for the LED bulb, determine (a) the velocity of the sandbag as it descends and (b) the overall efficiency of the device.
Determine the nodes/junctions, Current (I), Loops, Voltage drop on each Resistor (R), and Power (P) on each Resistor (R) with the following given and illustration: Use the following given for batteries and resistors (color bands for your value of resistors, use the lower limit). R1 = red red black goldR2 = orange green black silverR3 = white orange black goldR4 = green violet brown goldR5 = violet red black silverR6 = yellow green black silverR7 = brown black black gold V1 (lower left) = 100VV2 (top center) = 150VV3 (lower right) = 200V
complete solution. Fix yourcalculator in four decimal places and show your final answers in FOUR DECIMAL places. 1. The resistance of the wire used for telephone is 35 Ω per kilometre when the weight of the wire is 5 kg per kilometre. If the specific resistance of the material is 1.95 x 10^-8 Ω-m, what is the cross sectional area of the wire? What will be the resistance of a loop to a subscriber 8 km from the exchange if wire of the same material but weighing 20 kg per kilometre is used?
q25/a Write the features of Air circuit breaker and mention its application.
In the figure, the ideal batteries have emfs ℰ1 = 25.0 V and ℰ2 = 0.500ℰ1, and the resistances are each 2.14 Ω. (a) What is the current in resistor 2? ______________A(b) What is the current in resistor 3? ______________A (please show the units when working through the problem so that I can follow it easier)
When electricity is transported from a power station to a city, the line voltage (relative to ground) is usually on the order of several hundred thousand volts. A power line cable has a radius of a = 2.0 cm, is made of aluminum with a resistivity of ρ = 2.7×10−8 Ω ⋅ m, and spans a distance of l = 100 km from a power station to a city. The city consumes 100 MW of power (so I2RL =100MW). (a) Find the resistance of the power cable between the station and the city(i.e.,between points A and B). (b) Suppose that the line voltage ∆VBC = 120 V. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B? (c) Suppose that the line voltage ∆VBC = 300 kV. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B?