SOLVE USING SUPERPOSITION THEOREM ONLY WITH COMPLETE SOLUTION (AS IN COMPLETE SOLUTION WITH THE REDRAW CIRCUITS)

Q: What are the Principles of analog to digital conversion?

A: Given: Principles of analog to digital conversion.

Q: Find:Complex exponential Fourier series   x(t)=cos(3t)+sin(5t)

A:

Q: Armature resistance of a 230V shunt motor is 0.6 0 and no load current is 5A. When the rotor is…

A: Note  Back emf of DC shunt motor is directly proportional to product of Flux and speed Flux of DC…

Q: FOR THE CIRCUIT BELOW DETERMINE THE MESH CURRENT LI AND THE POWER DISSIPATED BY THE IN RESISTOR…

A: It is given that:

Q: V₂ A 8 V 5Vx VR=180 V and Vx=172 V, determine the power supplied by each ele

A:

Q: A three phase induction motor is wound for 4 poles and is supplied from 50Hz system. Calculate the…

A:

Q: 1. Three resistor of 10, 15 and "x" ohms, respectively are connected in parallel across a constant…

A:

Q: Contrast the intrinsic standoff ratio of a UJT and PUT

A:

Q: Question A capacitor that stores a charge of 0.5 coloumb at 10 Volt. The value of capacitance of…

A: Given- A capacitor- Charge Q=0.5 C, Voltage V=10 V, To Find- The value of the capacitance (C) of the…

Q: PROBLEM #1 WITH THE ASSISTANCE OF NODAL ANALYSIS, DETERMINE V₁-V₂ IN THE CIRCUIT BELOW. Vi 2A ↑ 352…

A:

Q: The measured drain currents from an enhancement mode nMOSFET were: 4 mA at VGS=5V, VDS=5 V 1 mA at…

A:

Q: The three-phase ratings of a three-winding transformer are: Primary Y-connected, 66 kV, 24 MVA…

A:

Q: 3. Evaluate the following. Express answers in polar form. a. b. (28 (65°) (45 (300) *jAPUA" 6+j8…

A:

Q: A rice mill will be served by two units of 50 KVA transformers, 7.620 KV/240V. The transformers will…

A: OPEN  DELTA CONNECTION:- Open delta connection is used to supply three phase load by using two…

Q: 5002 FIELD 11₂ 0,0352) ARMATURE 230V The armature current is Blank 1 A The armature voltage drop is…

A:

Q: Three resistors in parallel: RTotal 1 1 1 1 + + R₁ R2 R3 1) The circuit in figure (1) has, Vsupply…

A:

Q: 0.252 2v 0.12 0252 L 0.452 3v A.) Vab B) Rab 5v A 0.32 0.22 -Bv 2v Determine the following: 0.52 www…

A: Given:

Q: Find the cutoff frequency of the following filter: 19.9uF C1 HH V2 .8 R1 1.27mH 3L1

A: Circuit is given as:

Q: Question 1 Here again, is our diagram of the half-adder from the previous page. Copy this half-adder…

A: The given diagram is shown below,

Q: XRF requires a detector that can distinguish between multiple different wavelengths. True False

A: These analyses of rocks and minerals are carried out using methods like Mossbauer spectroscopy or…

Q: Exercise 2: Referring to Figure 4, find (a)the nodal voltages v1, v2 and v3 and (b) the current ix 3…

A: We need to find out the node voltage and current for given circuit , first we will find out the node…

Q: 1. Find the value of Vo using Thevenin's Theorem. 4 mA 1 ΚΩ 1 ΚΩ Σ 2 ΚΩ 2 ΚΩ +)12V Vo

A:

Q: For a linear system, we are given two input-output pairs as follows: ● for input x₁(t) = [[0,1](t),…

A: Given data: When input x1t=I[0,1]t, output y1t=1-tI[-1,1]t When input x2t=2I[0,2]t, output…

Q: A given signal x(t)=1 sin39t, find its power

A:

Q: 18. USING ONLY THE CD RULE FIND THE CURRENT THROUGH R2. I= 0.35 AMPS! 189 340 m R2 12 V +Tib V1 UB…

A:

Q: a) RTotal = b) |Total = ON EN R₁ Figure (2) 3) The circuit in Figure (2) has values of, V = 40 Volt,…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: 39. Calculate 1₂ and V₂ for the ideal transformer circuit of Fig. 13.61 if (a) V₁ = 4 /32 V and Z₁ =…

A: Given: k = 6:1 = 6 w.r.t. ideal Transformer Find: Calculate I2 & V2 For (a) I1= 244∠0∘mA &…

Q: Determine: a. Thevenin's equivalent resistance b. Thevenin's equivalent resistance c. The load…

A:

Q: Problem 1: Consider an LTI (linear, time-invariant) system whose mpulse response is given by h(t) =…

A:

Q: Identify the type of Transformer referred to K=0.7 a. Step down b. Voltage transformer c. Step up d.…

A: Given, k=0.7

Q: PROBLEM #4 DETERMINE NUMERICAL VALUES OF THE THREE MESH CURRENTS AS LABELED IN THE CIRCUIT.

A:

Q: Current flowing in a circuit is i = (18+ 10sinwt + 7sin2wt). A moving iron ammeter is connected in…

A:

Q: Q21. i) ii) Two watt-meter method is being used to measure power in a 3-phase 3-wire star-connected…

A:

Q: 4. Find the phasors corresponding to the following a. b. v(t) = 24 cos (4t i (t) = "-15") DUA 24 cos…

A: Phasor is vector representation of any sinusoidal signal both in terms of magnitude and phase.

Q: In a power system with negligible resistance, the fault current at a point is 8.00 pu. The series…

A: Given- Fault current If=8 pu, Short circuit current Is=5 pu, To Find- The value of the series…

Q: Consider the network above, with R=292, I₁ = 3A, V₂ = 50V, and V3 = 24V. There are two currents, x…

A:

Q: ya capacitor and inductor in a parallel configuration. Consider R, L, C arbitrary ositive constants.…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current…

A: Given data, RMS voltage V=20 V. Load resistance R=2.5 kΩ.

Q: b) a) X y y D.D. X S S

A:

Q: 2. After having been in position A for a long time, the switch in the circuit was moved to position…

A:

Q: Question 7   A 50 Hz sinusoidal signal is sampled at 1 kHz and analysed using a 128-point FFT.…

A: Given, Frequency of sinusoidal signal is  f = 50 Hz Sampling frequency (fs) = 1 kHz Radix value of…

Q: After a synchronous motor has reached the synchronizing speed, the best time to apply the field…

A: After a synchronous motor has reached the synchronizing speed, the best time to apply the field…

Q: Geoffrey is building an electronic circuit on a breadboard. He needs to supply his circuit with a…

A: Given: Need to supply 1500Ω resistance to the circuit. So Rreq=1500Ω Available value of the…

Q: Determine the voltage across 5 S2

A:

Q: The output y(t) of a system with input ä(t) is specified as follows: y(t) = * 6(7 −t − 1) a²³(r)dr…

A: Given data:

Q: Example 3 The input power to a device is 10,000 W at a voltage of 1000 v. The output power is 500w…

A:

Q: Q2. The generalized Fourier Transform of 1 is the impulse function (f). Use this conclusion to find…

A:

Q: 2. Find the equivalent capacitance. ÚA SITY TOF Q HE IBU To jefausto@mapi 18F N UNI 15 F DO NO DIS…

A:

Q: Q1. For signal v(t) = /2 sin(2π x 4t) + 4 cos(2π x 8t), determine (a) period, (b) Fourier Series…

A:

Q: Optical encoders (rotary) are used for measuring ? (Select all that apply) 1. Light intensity 2.…

A: Encoders: Encoders are sensors, widely used in the electronics devices. They provide feedback about…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.