Styrene is polymerized by free radical mechanism in solution. The initial monomer and initiator concentrations are 1 M and 0.001 M, respectively. At the polymerization temperature of 60ºC, the initiator efficiency is 0.30. The rate constants at the polymerization temperature are as follows: kd= 1.2 x 10-5 s-1 kp= 176 M-1s-1 kt= 7.2 107m-1s-1 Given this information, determine the following; a. Rate of initiation at 1 min and at 16.6 hrs b. Steady-state free radical concentration at 1 min c. Rate of polymerization at 1 min

Q: Gaseous fuel composed of 70% carbon, 25% hydrogen and 5% oxygen is burned with 20% excess air. Air i...

A:

Q: A gas is confined in a 0.5 m diameter cylin- der by a piston, on which rests a weight. The mass of t...

A:

Q: A standard signal range for electronic instrumentation is 4–20 mA. For purposes of monitoring instru...

A: It is to be mentioned whether instrument with range 0-20 mA can be used for monitoring or not.

Q: The reactor feed (not the fresh feed from the process) contains 3 moles of ethylene per mole of oxyg...

A: Given data: Single pass conversion of ethylene = 20 % Number of moles of ethylene per mole of oxygen...

Q: A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the stack gas shows 7.9% CO...

A: Orsat analysis of the stack gas: 7.9% CO2, 1.18% CO, 0.24% H2, 5.25% O2, 85.43% N2 Temperature of th...

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: Problem 1. A liquid has a constant-pressure specific heat (Cp) of 2.5 cal/(g⋅°C). Determine the spec...

A: The specific unit of the given liquids is to be determined in other units.

Q: A burner used Pittsburgh coal analyzing 14.1% ash, 2.1% N, 4.3% S. Excess air is supplied dry at 22⁰...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: A process is carried out in which a mixture containing 25.0 wt% methanol, 42.5% ethanol, and the bal...

A: The composition of feed stream is given as: Methanol = 25 wt % Ethanol = 42.5 wt % Water = 32.5 wt %...

Q: Ans 97.34 % vapour

A:

Q: What are the pros  and  cons  of solar energy?

A:

Q: Heat Transfer    Radiation: Under conditions a room’s temperature is maintained by a heating or cool...

A: Given data: Temperature of air inside a room = 20 0C Temperature of room (summer) = 27 0C Temperatur...

Q: 1. An Identity for the Gradient Operator Prove the following identity for the gradient of the scalar...

A:

Q: Carburetted water gas is produced in the same way as blue water gas except that it is done in the pr...

A:

Q: A mixture of 40 mol% isopropanol in water is distilled at 1 atm by batch distillation carried out in...

A:

Q: The van der Waals parameter b is a measure of the volume excluded due to the finite size of the mole...

A:

Q: The liquid-phase reaction                A+B ⎯⎯→ Cfollows an elementary rate law and is carried out ...

A:

Q: Write a balance chemical equation for the overall cell reaction represented as: a. Cd|Cd^2+||Sb^3+|S...

A: (a) The overall balanced equation for the chemical reaction taking place in the cell is to be mentio...

Q: Give one example of a combination reaction that is a redoxreaction and another that is not a redox r...

A: The example of combination reaction for both redox reaction and non-redox reaction is to be mentione...

Q: A furnace is fired with fuel oil containing 86% C, 1%N, and 0.1%S with a calorific value of46.4 MJ/k...

A:

Q: Question 1As part of the process of producing sugar crystals from sugar cane,raw sugar cane juice is...

A:

Q: 5. For your feasibility study your adviser assigned you to a power plant that makes use of coal as i...

A:

Q: Liza is a chemical engineer working for a wastewater treatment facility. One of thebyproducts of sew...

A:

Q: The water flowing with a flow rate of 60 kg / h in a heat exchanger enters the heat exchanger as sat...

A: The work provided to the heat pump is to be calculated.

Q: Under what conditions does a distillation column have to operate under vacuum?

A: It is to be mentioned the conditions where the distillation column requires a vacuum for the operati...

Q: A furnace is fired with fuel oil containing 86% C, 1%N, and 0.1%S with a calorific value of46.4 MJ/k...

A:

Q: The proximate analysis of a representative coal is 32% VCM, 53% FC, 10% ash, 1.2% N and 6.2% S. Its ...

A:

Q: ) Develop a 1-dimensional nonlinear state space model of the system and iden- tify the process state...

A:

Q: A 5.00-wt% aqueous sulfuric acid solution flows through a 45-m long pipe with a 6.0cm diameter at a ...

A:

Q: Motor benzole is a mixture of 3 lower aromatic hydrocarbons, benzene, toluene and xylene in proporti...

A:

Q: Professor Modyn owns a 30.0 ft tall cylindrical tank, which is closed at the top and bottom. The vap...

A: The absolute pressure of the tank at the bottom is to be determined.

Q: What are the three contributing factors to the vapor pressure drop across a tray?

A: The three factors which contributes to the vapor pressure drop across a tray are to be mentioned.

Q: What is a batch stripper?

A: The definition of the batch stripper is to be mentioned.

Q: نقطتان )2( * :Oligomer can be defined as a complex that contains a small number of repeating units a...

A: The correct option related to the oligomer's definition is to be chosen.

Q: 2. Pure ethane is burned completely in 20% excess air. Air is supplied at 25 deg C, 740 torrs, and i...

A:

Q: Prove that, in a triangular diagram where each vertex represents a pure component, the composition o...

A: It is to be proved that in a triangular diagram where each vertex represents a pure component, the c...

Q: Diffusion of a pollutant into a semi-infinite soil layer can be described by the following different...

A: Given that, Pollutant concentration at the soil surface = C0 It is required to calculate the depth b...

Q: 1. A sample of a mixture of acetylene and methane gas is burned in the presence of air, the flue gas...

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want rem...

Q: How much heat is needed to raise the temperature of 5 mol of O2 gas from 30 °C to 120 °C at a pressu...

A: Given data: Number of moles of O2 = 5 Initial temperature of oxygen = 30 0C or 303 K Final temperatu...

Q: For your feasibility study, your adviser assigned you to a power plant that makes use of coal as its...

A:

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: A process instrumentation diagram for a flash drum isshown in Fig. E9.2. Steam is condensed in a ste...

A:

Q: Maleic anhydride with 10% benzoic acid is a byproduct of the manufacture of phthalic anhydride. The ...

A: It is to be stated whether the problem is specified completely or not.

Q: 1.- During the recovery of phenolic compounds from nixtamalization wastewater (NWs) using an UF memb...

A: Given that, Ultrafiltration UF membrane is used for the recovery of phenolic compounds from nixtamal...

Q: Acrylic acid (CH₂=CHCOOH) is used to prepare poly-mers, adhesives, and paints. The first step to mak...

A: The amount of propylene that must be added to the mixture in pounds per hour is to be determined.

Q: Measurements indicate that 23.6% of the residents of a city with a population of 531,314 are college...

A:

Q: In absorption, the absorbent is stripped to an extent that depends on its K-value. In stripping, the...

A: The type of process which is taking place along with the reason in the given diagram is to be mentio...