subject: Circuits II A 50 -cycle current has a maximum value of 5.0 amps. What will be the instantaneous value of current, if the time is 0.0046 second after the wave passes through in a positive direction?

subject: Circuits II A 50 -cycle current has a maximum value of 5.0 amps. What will be the instantaneous value of current, if the time is 0.0046 second after the wave passes through in a positive direction?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter3: Static Electricity

Section: Chapter Questions

Problem 6RQ: Can one thundercloud contain both positive and negative charges?

See similar textbooks

Related questions

Q: Find the Fourier series of f(t) = t ^ 3 where t € [−4,4] and f(t+8)=f(t).

Q: 122 122 D2 MM 1252

Q: A load of 1250 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

Q: 5Ω ww 6Ω ww 20Ω 600 100 40 a 15 0 300 15Ω

Q: The total armature current carried by a 50-hp four-pole 230-volt motor is 180 amp. If the winding is...

Q: Given the points A(x=2, y=3, z=-1) and B(p = 4, 0 = -50°, z = 2), find a unit vector in cylindrical ...

A: Given points are,Ax=2, y=3, z=-1andBρ=4, ϕ=-50°, z=2

Q: A 300- kw alternator has an efficiency of 90 % at full load. Calculate the power losses? 267 kw 27 k...

Q: A 500-kw 600-volt 10-pole generator has an armature with 108 slots, 324 com mutator segments, and a ...

Q: X) Answer the following questions (answers to be typed, handwritten answer for this questio will not...

A: "since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: If A, B, and C are the inputs of the given circuit then determine the output waveform X. Circuit di...

A: In this question, A, B, and C are the inputs of the given circuit then determine the output wavefor...

Q: Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6| B = |0| and C =[10 5 1] ...

A: Given a system defined by x˙=Ax+Buy=Cx where, A=010001-6-11-6B=101C=1051

Q: When the load impedance is equal to the characteristic impedance of the transmission lines, then the...

Q: The following data were obtained from a short-circuit test performed upon a 50 kVA, 2300/115 V, 60 H...

Q: Consider two toroids of square cross section of air core,

Q: How long a wire is needed to coil a spring having a mean diameter of 1 inch if there are 8 active co...

A: Given, A spring has a mean diameter. d = 1 inch Total number of coils, n = 8

Q: A 46-mH inductive coil has a resistance of 10 ohms. How much current will it draw if connected acros...

A: Given a Inductive coil with resistance having, Inductance, L = 46 mH Resistance, R = 10 ohms Supply ...

Q: What will be truth table

A: There are two variables used in the given boolean function so we will have only 4 combinations of in...

Q: At T 400K, what the concentration of free electrons / holes in intrinsic silicon? 1.5x1010/cm3 5.16x...

Q: Power rating of a motor drawing a current of 40 A at 400 V is?

A: Given: A motor drawing a current, I = 40 A At voltage, V = 400 V

Q: 10. Determine V, and Ip for the networks of Fig. 2.160. 20 V Ip Si 12 V Ge Si GaAs 4.7 k2 2.2 k2 6 4...

Q: Q4 // Write the Boolean algebra laws for OR gates?

A: OR gate - A two input OR gate will give you a logic 1 output if EITHER or BOTH of its input are at l...

Q: (I) Circle the correct answer (8) 1. Sun light is converted to electricity in silicon when a photon ...

A: "Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: In an (n,k) block ECC, what do n and k represent?

A: Given : ECC blocks

Q: A-Using nodal analysis, find VO in the circuit in Fig 32 3 V 1Ω (+ I)

Q: Question#01: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 H...

Q: R(s) C(s) G1 G2 G3 HalG Figure 2 nswer:-

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

Q: (а) [(5 + /2X-1 + J4)-5/60'] 10 + j5 + 3/40 (b) + 10/30° + j5 -3 + j4

A: a z =5+j2-1+j4-5∠60° = -5 -j2+j20-8-5cos60°+j5sin60° = -13 +j18-2.5-j4.33z = 20...

Q: Q.6 Obtain CLTF. nery Magons gain furmunta.

Q: Q7. Explain what happen to a power supply if there is no smoothing capacitor connected across the ou...

A: If the capacitor are connected across the output then capacitor increase the DC voltage and there is...

Q: A coil has a resistance of 4 ohms and an inductance of 2H. It is connected to a 20V dc supply. Calcu...

A: In steady state inductor acts as short circuit i.e impedance of circuit is purely resistance of coi...

Q: 10. Summarize a definition of each of the following: a. Side lobes b. Grating lobes Apodization С.

A: a) side lobes In antenna engineering, side lobes or sidelobes are the lobes (local maxima) of the fa...

Q: 100 25V D2 本

Q: A rectangular surge of 500 kV 3µs travels along the terminated line by an inductance of 2mH. If the ...

A: Given Rectangular voltage magnitude vm=500 kvTime duration t=3 μsSurge impedance Z0=600 ΩInduct...

Q: Two resistors 5 kQ and 20 k2 are at 27°C. Calculate the thermal noise power for a 10 kHz bandwidth f...

A: R1 = 5k R2 = 20 k T =temperature= 27°C = (27 + 273) K = 300K B = Bandwidth= 10 kHz

Q: Determine V, and Ip given that the red LED needs 1.8V in order to function.

A: The voltage Vo and current through the diode can be calculated by considering the drop across the di...

Q: single phase fully controlled bridge is operated with a resistive load R = 10 Ω, the input voltage t...

A: In this question we have given single phase fully controlled bridge rectifier with R load....We have...

Q: 6.0 V 9.0 V 1.0 Ω 1.0 2 Batteries a b R

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A: Given a 3-phase induction motor is running at, Slip, s = 2 % = 0.02 Input power of rotor, Pin=1000 W...

Q: Question 5 An inductive coil has a resistance of 9.5 ohms. A battery of 115V is suddenly connected t...

A: Given a inductive coil has, Resistance, R=9.5 Ω Battery voltage, V=115 V Rise current, I = 10 A Curr...

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in...

A: Given a coil of wire having, Resistance, R = 50 ohm Time, t = 1 s Potential difference, V = 210 V La...

Q: Use nodal analysis to determine the node voltages in the circuit shown. 4 S 3i. 1s V2 1s V3 2 A 2S 4...

A: The solution is given below

Q: (a) #(t) = E- j*8(t – k) (b) z(t) = sin(at)e-lt|

A: For a periodic signal, time period is the interval of time after which signal repeats.

Q: current through the load resistor by simply Calculate the current through 62 load resistor using the...

Q: The no-load speed of a 240 V Dc shunt motor is 800 r/min and the armature current is 2A. Determine t...

A: Given,No load armature current=Iao=2ANo load back emf=Ebo=240-Iao×RaEbo=240-2×0.4=239.2Vand, ϕo∝ no ...

Q: Fill in the blanks Ge Si 1.2 kQ -1D Vo- What is the status of Ge Diode? ON or OFF Vo1= V ( Previous

Q: Explain the essential features of Indicating Instruments? Diagrams – draw neatly , scan and attach...

A: Measuring instrument- Define a measuring instrument as any device that can be used to determine the ...

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in...

A: Consider by the enthalpy of fusing the energy required to transform the solid water to water is 333....

Q: a) Depict the output signal of the circuit. b) Draw the output signal of the circuit if you insert a...

A: The given circuit is a bridge rectifier used to convert the alternating current into a direct curren...

Q: Use a 4-to-10 line decoder achieve the following functions, fi(a, b, c, d) %3 т, + mз + ms f-(a, b, ...

Concept explainers

Induced Voltage in a Coil

Q1. Which of the following law introduces the concept of EMF?

Question

subject: Circuits II
A 50 -cycle current has a maximum value of 5.0 amps. What will be the instantaneous value of current, if the time is 0.0046 second after the wave passes through in a positive direction?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 50-cycle voltage with maximum value of 24 V. (a) What will be the value of the instantaneous voltage at 0.00175 sec after the wave passesthrough in positive direction? (b) what will be the equation of the instantaneous current, if a non-inductive resistor of 9 ohms is connectedto the voltage source?
What peak-to-peak value of ac sine wave would do the same work as 50 Vdc? Oscilloscope can display which value? (peak or rms) May I ask if a follow-up question in Bartleby will be forwarded to the expert who previously answered the original question? Or will it be redirected to another expert? Thanks for clarifying.
For the waveform shown in figure1, determine (i) Peak value (ii) the peak-to-peak voltage (iii) the time period (iv) the frequency (v) The angular frequency.
A sinusoidal current wave has an instantaneous value of -20 A at t = 0 and is increasing negatively. If the peak value is 50 A, solve for the instantaneous value of the current when t = 3 milliseconds and at t = 40 milliseconds. At what time will the instantaneous value of the current be -30 A for the 4th time.
A voltage sine wave just passes thru the voltage axis at t = 0 at a value of – 30 volts and increasing negatively. It has a positive peak value of 100 volts and frequency of 1.273239545 Hz. a.At what time (milliseconds) will the wave crosses the t-axis for the 3rd time? b. At what time will the value of voltage be 35 volts for the second time? c. What is the value of the voltage at 287 milliseconds?
NEED ASAP. ANSWERS MUST BE IN 4 DECIMAL PLACES Power brightness of a 104) W, 110 V lamp is to be varied by controlling firing angle of SCR full-wave circuit; the rms value of ac voltage appearing across each scr being 110 V. Find the (a) rms voltage and (b) rms current in the lamp at firingangle of 60o .
A voltage sine wave has an effective emf of 12√2 volts and angular velocity equal to 50π rad/s. a. At what time(ms) will the instantaneous voltage be if v(t)= +10 volts after passing through the first positive peak voltage.b. At what time(ms) will the instantaneous voltage be if v(t)= erms/2 before reaching The first negative peak voltage.
Sketch the waveform for i of the network of the figure if tt= 2ts and the total reverse recoverytime is 9 ns.
Coulomb's Law and Electric Field Intensity 3.)
Please show the neat solution. Thank you. Draw a sinusoidal voltage waveform with peak value of 200 volts and has an instantaneous value of 100 volts at t= 1 milliseconds. The wave is increasing positively at t=0 with a magnitude of 0 volt. Calculate also the frequency and period of the said waveform.
|PLEASE ANSWER WITH SIMPLE COMPLETE SOLUTION FOR ME TO UNDERSTAND| A residential motor has a given voltage having an equation v=94sin3t. What is the frequency of the motor? How long does it take in milliseconds for the waveform to complete 1/8 Cycle if t=6.5 s? Also find the Magnitude of the current if the resistance is 216 Ω
The voltage in your home is 120 Vac effective (rms), what is the peak value? Voltage specified as 100 Vac is understood to be what value? rms, peak or peak-to-peak? Convert 280V peak-to-peak, to its rms value. Assume a sine wave. What peak-to-peak value of ac sine wave would do the same work as 50 Vdc? Oscilloscope can display which value? (peak or rms)