Sulfur hexafluoride (psF. = 6.17 kg/m³) and nitrogen (pPN2 = 1.292 kg/m³) are fed into a mixing tank through pipe 1 and pipe 2, respectively. If the resulting gaseous mixture has a density of 2.105 kg/m³, what is the ratio of the volumetric flow rate between pipe 1 and pipe 2?

Sulfur hexafluoride (psF. = 6.17 kg/m³) and nitrogen (pPN2 = 1.292 kg/m³) are fed into a mixing tank through pipe 1 and pipe 2, respectively. If the resulting gaseous mixture has a density of 2.105 kg/m³, what is the ratio of the volumetric flow rate between pipe 1 and pipe 2?

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter14: Ocean Thermal Energy Conversion And Ocean Salinity Gradient Energy

Section: Chapter Questions

Problem 9P

See similar textbooks

Related questions

Q: The discharge of water in a 25 cm diameter pipe is 0.05 m3/s. What is the mean velocity?

Q: The 4-mm diameter cable BC is made of a steel with E = 200 GPa. Knowing that the maximum stress in t...

Q: A cylinder vessel filled with Wa and spilled half of its volume. Estimate the angular velocity in re...

Q: Two forces act on the hook. Determine the magnitude of the resultant (in newton) of the forces, give...

Q: 26 ksi An aluminum cube (E= 10 x 10 ksi, v D0.3) is aded as shown along each axis. (a) Show that for...

Q: J F K E G 30 2 m = 6 m

Q: Deflection at the overhanging end. 10 kN/ m 20 kN-m A EI 2EI 4 m 2 m

Q: Water flows into a large tank at a rate of 11 Ips (liters per second) as shown. The water leaves the...

A: Bernoulli theorem : Bernoulli's principle asserts that an increase in a fluid's speed occurs at the ...

Q: ILLUSTRATE AN ISOLATED SQUARE FOOTING SHOWING A PLAN(TOPVIEW) AND AN ELEVATION(FRONT VIEW) WITH ITS ...

A: Isolated square footing is generally used for shallow foundation for distributing superstructure loa...

Q: A 5-m simply supported beam is loaded over the whole span with uniform loads of WDL=18kN/m and WLL=1...

Q: PROBLEM NO. 1 DETERMINE THE VERTICAL DISPLACEMENT OF JOINT C OF THE TRUSS. EACH MEMBER HAS A CROSS-S...

Q: If an irrigation canal is forced to pass through a depression, what type of structure is needed?

A: There are mainly 2 types of structures Aqueduct: canal runs over the drainage . Super passage :

Q: Find the force in the member FG of the given pin jointed frame. 10 kN H 5 kN 2 m F K E G 30 2 m = 6 ...

A: Find the force in the member FG of the given pin jointed frame.

Q: 5. Determine ỹ, which locates the centroidal axis x' for the cross-sectional area of the T-beam, and...

Q: A cylindrical tank holding oxygen at 1,146 kPa pressure has an outside diameter of 430 mm and a wall...

Q: TP 2 Known Elevation is 402.78 4.30 2.01 4.72 +75· - 0s + - 0G + 00 2 Rod

Q: If €, and e, are the maximum and minimum strains, respectively in the neighbourhood of a point in a ...

A: Principal Strain: Maximum and minimum normal strain possible for a specific point on a structural el...

Q: Available chlorine in bleaching powder solution is 0.5mg/ml. To obtain a chlorine dose of 0.1 mg/1 i...

Q: Determine the effective area A, for each case shown in Figure P3.3-1.

Q: A square footing which carries an axial load of 13000 kg has its bottom resting on a ground water ta...

Q: 13. Determine the moment of inertia of the beam's cross-sectional area about the x-axis and the cent...

Q: Identify and enumerate the different safety standards in carpentry works and metal bench works.

A: 1. Always Wear the Safety Equipment It is one of the important factor to remember. During the usage ...

Q: Chlorine gas used for disinfection combines with water to form hypochlorous acid (HOCI). The HOCI io...

Q: 6. The shear-force diagram for a beam is shown in the figure. Assuming that no couples act as loads ...

Q: For all problems, draw the indicated influence lines. For #1, use both the "unit load method" and th...

Q: Fundamental Problem 4.41 Part A Determine the resultant force and specify where acts Determine the m...

A: First find the resultant loads under distributed loads. Then using the principle of moments the appl...

Q: VA = 0.6 m/s ав = ?

Q: Solve using elementary row operations and an augmented matrix. x– 2y - 3z = 0 x +4y + 4z = 10 3x + 7...

Q: °Prob. 2.9-4. Determine the allowable tensile load P for the prismatic bar shown in Fig. P2.9-4 if t...

Q: The square footing has a dimension of 2.61 m and has its bottom 1.48m below the ground surface. The ...

Q: A doubly reinforced beam, which have a base of 310 mm, and an effective depth of 410 mm, is reinforc...

A: Balanced steel Ratio PBalanced is corresponding to amount of steel at which concrete failure and ste...

Q: A steel beam is of cross section of right triangle of dimension 40 mm wide and 60 mm wide and 60 mm ...

Q: The pin support A and roller support B of the bridge truss are supported on concrete abutments. If t...

A: Determine the required minimum dimension of the square bearing plates at C and D

Q: How do you calculate float?

Q: A spring scale A and a lever scale B having equal lever arms are fastened to the roof of an elevator...

Q: (a) = z (1). H.W.1/Start from : To obtained : BOD (t) = Lo - z (t) = Lo(1 – e-kit). %3D

A: Introduction: BOD - Biochemical oxygen demand is defined as the amount of oxygen demand by the micr...

Q: The stratification of different layers of soils is shown in the figure below along with their coeffi...

Q: Classify the following truss as statically determinate (SD), statically indeterminate (SI), stable, ...

Q: The U-tube in the figure is given a uniform acceleration of 1.22 m/s to the right. What is the depth...

Q: A triangular lamina with base 3 m and height 3 m is immersed in water vertically with base parallel ...

A: Given:- The base of the triangular lamina = 3 m The height of the triangular lamina = 3 m The triang...

Q: The table below contains the conditions of a fluid (SG = 0.50) flowing in a pipe having constant dia...

A: Step 1: PA= 32.4 psi PB=29.7 psi ZA=56.8 ft ZB=68.2 ft

Q: What was the construction cost for the St. Lawrence Seaway when it was built? What is the relative s...

A: The St Lawrence Seaway is the system of locks, canals and channels linking the Great Lakes and the ...

Q: determine the Pabs exerted by H2O 31m high below a pool.

Q: The composite bar shown in the figure is firmly attached to unyielding supports. An Axial force P 52...

A: To compute the stress in the aluminum bar. Given, Axial force on the composite bar (P) = 52 kips I...

Q: The maximum safe compressive stress in a hardened steel punch is limited to 1 GPa and the punch is u...

A: Safe Compressive stress in punch = 1GPaThickness of the plate = 20 mmUltimate shearing stress = 400 ...

Q: In an ore-mixing operation, a bucket full of ore is suspended from a travelling crane which moves al...

Q: The channel shown in Figure below (all dimensions are in ft), Manning roughness n for side channels ...

A: The velocity of flow in any channel by Manning's equation is given by V=KnnR23S12 Where V=Mean velo...

Q: An inviscid fluid with the density of 800 kg/m³ flows up in a vertical pipe (gravity, g=10 m/s²). Wh...

Q: The motion of a particle is defined by the relation x = 6t 8 + 40 cos Tt, where x and t are expresse...

Q: A square footing which carries an axial load of 13000 kg has its bottom resting on a ground water ta...

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Sulfur hexafluoride (psF.
= 6.17 kg/m³) and nitrogen (PN2
= 1.292 kg/m³)
are fed into a mixing tank through pipe 1 and pipe 2, respectively. If the resulting
gaseous mixture has a density of 2.105 kg/m³, what is the ratio of the volumetric
flow rate between pipe 1 and pipe 2?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The raw water supply for a community contains 160 mg/L total particulate matter. It isto be treated by addition of 86 mg/L alum.Essentially all of the added alum precipitatesby this reaction:Al2(SO4)3 · 14H2O ⇒Al(OH)3(s) + 3SO2−4 + 6H+ + 8H2O. For a total flow of 5500 m3/day, compute the daily alum requirement. Answer in units of kg/day. Determine the concentration of solids in the water following alum addition (i.e., the sum of the solids initially present and those formed during treatment). Answer in units of mg/L.
A volumetric tank 1.20 m in diameter and 1.50 m high was filled with oil in 16 minutes and 32.4 seconds. What is the average discharge? a. 100.5 L/min b. 102.5 L/min c. 103.6 L/min d. 108.7 L/min
2.1 Air having a density of 1.01 kg/m3 and absolute viscosity of 1.79 x 10-4 poise (1.79 x 10-5 Pa-s) flows through a 30.48-cm diameter pipe at the rate of 1814.0 kg/hr. Determine the type of flow existing in the pipe. 2.2 A pipe hose should deliver at least 1 200 lpm. If the nozzle has a diameter of 30 mm, what is the velocity of the issuing jet?
The specifications of a certain residential deep well pump indicate that it delivers 745 gallons / hour. express this volumetric flow in ft3 / s
diameter = 60 cm height = 60 cm The open cylindrical tank is two-thirds full of water. Considering that the tank is to rotate about the axis at the center a. Determine its speed so no water is within 15 cm from the axis of rotation. Considering this speed, how much of the volume is spilled?
A Semi-solid waste storage has a volume of 1145 m3. The basin is initially 71% empty. The semi-solid density is 1521 kg/m3 is taken away from the storage tank at a rate of 5211.81 kg/day. How long will the basin take to be 91% emptied? Assume the storage is now initially full 23% and re-estimate the time to empty it
Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L to the permissible value of 2500 CFU/L. It is given that the velocity of flow through the pipe is 0.7 m/s and the rate constant is 0.25 per min.
Tank A initially holds 100 gallons of brine that contains 150 pounds af salt, and tank B holds 100 gallons of water. Two gallons of water enters tank A each minute, and the mixture , assumed uniform, flows from tank A into tank B at the same rate. If the resulting mixture , also kept uniform , runs out of B at the rate of 2 gallons per minute, how much salt is in the tank B at the end of 1 hour ?
There are four liquids that are to be poured in a single vessel that is located in an atmosphere with g = 3.72m/s2. The first liquid is seawater (SG=1.025), the second is kerosene (ρ=1.591 slugs/ft3), the third is castor oil (SG=0.959), and the last liquid is liquid butane (unit weight = 2235.72N/m3 @ g=3.72m/s2). (a)Determine the density of seawater, the specific gravity of kerosene, the unit weight of castor oil and the density of liquid butane expressing all your answers in SI Units. (b) Illustrate the order of the liquids from the top-to-bottom of the vessel?
Problem 2: Engineers sometimes use pipes as reactors in treatment plants. Suppose that the plant flow is 3.3ft3/s (about 2.1 million gallons per day, mgd) and a cylindrical pipe is to be used for disinfection.A. Draw a sketch of the system. Indicate the control volume by a dashed line. What kind of hydrodynamicmodel should you use for a pipe? What mixing conditions should you assume?B. Write the integrated mass balance equation for the pollutant in symbols at steady state. (“Integrated” meansthat your mass balance looks like: C = …) Define your symbols.C. For a pipe 3.5 feet in diameter and 50 feet long, what is the hydraulic residence time in minutes?D. For the pipe in Part C, what value of the first-order rate constant (in min–1) is needed to achieve a 99% removal of bacteria?
4. Tank A initially holds 100 gallons of brine that contains 100 pounds of salt, and tank B holds 10 gallons of water. Two gallons of water enter A each minute, and the mixture, assumed uniform, flow from A into tank B at the same rate. If the resultin mixture, also kept uniform, runs out of B at the rat of 2 gallons per minute, how much salt is in tank B a the end of one hour.
The pipe is 25mm with friction factor of 0.022. The second tank is vented. H1=1.4m H2=4.5m H3=1.0m X1=14.9m X2=2.7m Calculate the pressure(kPa) above the gasoline in the first tank that will result in a flowrate of 400 liters/min.