The 104-lb force Pis applied to the 220-lb crate, which is stationary before the force is applied. Determine the magnitude and direction of the friction force Fexerted by the horizontal surface on the crate. The friction force is positive if to the right, negative if to the left. Assume 4, = 0.47, Hz = 0.38. Answer: F = Ib

The 104-lb force Pis applied to the 220-lb crate, which is stationary before the force is applied. Determine the magnitude and direction of the friction force Fexerted by the horizontal surface on the crate. The friction force is positive if to the right, negative if to the left. Assume 4, = 0.47, Hz = 0.38. Answer: F = Ib

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.49P

See similar textbooks

Similar questions

The 600-lb cable spool is placed on a frictionless spindle that has been driven into the ground. If the force required to start the spool rotating is F = 160 lb, determine the coefficient of friction between the ground and the spool. Neglect the diameter of the spindle compared to the diameter of the spool.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
Calculate the horizontal force P required to push the 85-lb lawn mower at constant speed. The center of gravity of the mower is at G, and the coefficients of rolling resistance are 0.12 for the front wheels and 0.18 for the rear wheels.
Determine the smallest horizontal force P that would push the homogeneous cylinder of weight W over the curb. Neglect friction.
How many turns of rope around the capstan are needed for the 40-lb force to resist the 8000-lb pull of a docked ship? The static coefficient of friction between the capstan and the rope is 0.25.
The 3600-lb car with rear Wheel drive is attempting to tow the 4500-lb crate. The center of gravity of the car is at G, and the coefficients of static friction are 0.6 at B and 0.2 at C. Determine if the crate will slide.
The normal pressure acting on the disk of the sander is given by p=(4/3)+(r2/6), where p is the pressure in pounds per square inch (psi) and r represents the radial distance in inches. Determine the torque C required to operate the sander at constant speed if the kinetic coefficient of friction for the surface being sanded is 0.86.
The leather rein used to fasten the horse to the hitching rail weighs 3.5 oz per foot. The coefficient of static friction between the rail and the rein is 0.6. If a 34-lb force acting on the bridle is sufficient to restrain the horse, determine the smallest safe length L for the free end of the rein.
Determine the largest angle for which the homogeneous block remains at rest.
The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed. Determine the force P and the roller reactions at A and B.
The two 200N blocks are pushed apart by the 15⁰ wedge of negligible weight. The angle of static friction is 12⁰ at all contacts surfaces. Determine the force P required to start the blocks moving.
If the coefficient of static friction at C is μs = 0.35, determine the largest force F that can be appliedto the 3-kg ring, without causing it to slip. Neglect the thickness of the ring.